
• Read the instructions carefully before installing and/or using the
• The manufacturer declines all responsibility for any faults, damage or res
caused by the failure to observe the above the instructions provided in
• The hood is designed for extracting cooking fumes and vapours, and is
intended for domestic use only.
• Installation and adjustments should be carried out by qualied personnel.
• Check the integrity of the hood once it has been removed from the
packaging. If the product is damaged, do not use it. Contact the Apell
• Before connecting the appliance, make sure that the mains voltage is the
same as the voltage indicated on the technical data label inside the
• For Class I appliances, make sure that the domestic power supply is
• The minimum distance between the hob and the lower surface of the
hood must be at least 650 for electric hob and 750 mm for gas hob. mm
• The air that is extracted must not be conveyed into a duct that is used for
extracting fumes from appliances powered by gas or other fuels.
• Connect the air outlet from the hood to ue ducts having an adequate
internal diameter, not less than 120 mm.
• Ensure that there is adequate ventilation in the room when using the
cooker hood and gas appliances at the same time.
• If the power cable is damaged, it should be replaced by the manufacturer,
the manufacturer’s technical assistance service, or a similarly qualified
person in order to avoid possible hazards.
• Comply with local authority regulations regarding the technical and safety
measures to adopt for discharging the fumes.
• Warning: failure to install the screws or xing devices in accordance with
these instructions may result in an electrical hazard