READ AND SAVE THESE INSTRUCTIONS.
Read the instructions carefully before installing and/or using the hood.
Before connecting, make sure that the mains voltage corresponds to the voltage on the
rating plate inside the hood. (see fig. 7)
Once you remove the appliance from its packaging make sure it is intact. If the product
is damaged, do not use it and contact the Smeg assistance network.
It is recommended that a qualified technician performs installation and adjustment
operations .
The minimum distance between the cooker and the lower part of the hood must be
750mm for gas cookers and 650 mm for electric cookers.
Inspect and clean the filters thoroughly and in accordance with the intervals suggested
by the manufacturer.
UNPLUG OR DISCONNECT THE APPLIANCE FROM THE POWER SUPPLY
BEFORE SERVICING.
WARNING To Reduce Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any –
Solid-State Speed Control Device.
CAUTION For General Ventilating Use Only. Do Not Use For To Exhaust Hazardous –
Or Explosive Materials And Vapors.
Do not cook or fry in a way that could result in flames being sucked into the hood and
causing a fire.
The hood surface can be cleaned with a damp cloth and a non-bleach liquid detergent.
Make sure the room is properly ventilated when using the hood and other gas
appliances at the same time.
Comply with the regulations on air discharge when operating the hood.
The extracted air must not be routed into a duct used to discharge fumes of
Gas-operated appliances.
This appliance must not be used by children without an adult supervision or
by disabled people without assistance.
THE MANUFACTURER CANNOT BE HELD RESPONSIBLE IF THE ABOVE
INSTRUCTIONS ARE NOT FOLLOWED.
OPERATION
This appliance has been designed to work as a hood (evacuation of the air) or DUCTING
RECYCLING hood (recycling of the filtered air).
DUCTED MODE: In order to use the hood in the ducted mode, connect the motor intake,
by means of a suitable ducting hose not less than 120mm diameter, directly to the external
fumes outlet.
Note: Remove any carbon filters.
RECIRCULATION MODE: If it is not possible to discharge fumes outside, the hood can
be used to filter and recycle the air. This way, air and fumes are filtered by the anti-odour
carbon filters and recirculated through the aerating grids on the sides of chimney.
