Smeg SHW910X1 Manual

Smeg Emhætte SHW910X1

Læs gratis den danske manual til Smeg SHW910X1 (16 sider) i kategorien Emhætte. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 5 anmeldelser. Har du et spørgsmål om Smeg SHW910X1, eller vil du spørge andre brugere om produktet?

Side 1/16
Instructions Manual
SHW610X1 - SHW910X1
RECOMMENDATIONS
AND SUGGESTIONS
The Instructions for Use apply to
several versions of this appliance.
Accordingly, you may nd descrip-
tions of individual features that do
not apply to your specic appliance.
The manufacturer will not be held
liable for any damages resulting from
incorrect or improper installation.
The minimum safety distance be-
tween the cooker top and the extrac-
tor hood is 650 mm (some models
can be installed at a lower height,
please refer to the paragraphs on
working dimensions and installation).
Check that the mains voltage cor-
responds to that indicated on the
rating plate xed to the inside of
the hood.
For Class I appliances, check that
the domestic power supply guaran-
tees adequate earthing. Connect the
extractor to the exhaust ue through
a pipe of minimum diameter 120
mm. The route of the ue must be
as short as possible.
Do not connect the extractor hood to
exhaust ducts carrying combustion
fumes (boilers, replaces, etc.).
If the extractor is used in conjunc-
tion with non-electrical appliances
(e.g. gas burning appliances), a
sufcient degree of aeration must
be guaranteed in the room in
order to prevent the backow of
exhaust gas. The kitchen must
have an opening communicating
directly with the open air in order
to guarantee the entry of clean air.
When the cooker hood is used in
conjunction with appliances supplied
with energy other than electric, the
negative pressure in the room must
not exceed 0,04 mbar to prevent
fumes being drawn back into the
room by the cooker hood.
In the event of damage to the power
cable, it must be replaced by the
manufacturer or by the technical
service department, in order to
prevent any risks.
If the instructions for installation for
the gas hob specify a greater dis-
tance specied above, this has to
be taken into account. Regulations
concerning the discharge of air have
to be fullled.
Use only screws and small parts
in support of the hood.
Warning: Failure to install the
screws or xing device in accord-
ance with these instructions may
result in electrical hazards.
Connect the hood to the mains
through a two-pole switch having
a contact gap of at least 3 mm.
USE
The extractor hood has been de-
signed exclusively for domestic use
to eliminate kitchen smells.
Never use the hood for purposes
other than for which it has been
designed.
Never leave high nakedames un-
der the hood when it is in operation.
Adjust the ame intensity to direct
it onto the bottom of the pan only,
making sure that it does not engulf
the sides.
Deep fat fryers must be continuously
monitored during use: overheated
oil can burst into ames.
Do not ambè under the range
hood; risk of re.
EN


Produkt Specifikationer

Mærke: Smeg
Kategori: Emhætte
Model: SHW910X1

Har du brug for hjælp?

Hvis du har brug for hjælp til Smeg SHW910X1 stil et spørgsmål nedenfor, og andre brugere vil svare dig