Sony SRS-XB100 Manual

Sony Højttaler SRS-XB100

Læs gratis den danske manual til Sony SRS-XB100 (3 sider) i kategorien Højttaler. Denne vejledning er vurderet som hjælpsom af 29 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 15 anmeldelser. Har du et spørgsmål om Sony SRS-XB100, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/3
5-047-815- (1)41
SRS-XB100 Model: YY7856E
©2023 Sony Corporation
Printed in China
https://www.sony.net/
Wireless Speaker
Reference Guide
Model: YY7856E
The term “product” in this document refers to the unit or its accessories.
Do not expose the unit to naked flame sources (for example, lighted
candles).
Do not install the product in a confined space, such as a bookcase or
built-in cabinet.
The nameplate and important information concerning safety are
attached in the following locations:
• the bottom of the unit
Do not expose the batteries (battery pack or batteries installed) to
excessive heat, such as sunshine, fire or the like, for a long time.
Do not subject the batteries to extreme low temperature conditions that
may result in overheating and thermal runaway.
Do not dismantle, open, or shred secondary batteries.
In the event of a secondary battery leaking, do not allow the liquid to
come in contact with the skin or eyes. If contact has been made, wash
the affected area with copious amounts of water and seek medical
advice.
Secondary batteries need to be charged before use. Always refer to
the manufacturer’s instructions or product manual for proper charging
instructions.
After extended periods of storage, it may be necessary to charge and
discharge the secondary batteries several times to obtain maximum
performance.
Dispose of properly.
This product has magnet(s) which may interfere with pacemakers,
programmable shunt valves for hydrocephalus treatment, or other
medical devices. Do not place this product close to persons who use
such medical devices. Consult your doctor before using this product if
you use any such medical device.
This unit has been tested and found to comply with the limits set out in
the EMC regulation using a connection cable shorter than 3 m.
Never insert the USB plug when the main unit or charging cable is wet.
If the USB plug is inserted while the main unit or charging cable is wet,
a short circuit may occur due to liquid (tap water, seawater, soft drink,
etc.) or foreign matter on the main unit or charging cable, and cause
abnormal heat generation or malfunction.
Licenses
• This product contains software that Sony uses under a licensing
agreement with the owner of its copyright. We are obligated to
announce the contents of the agreement to customers under
requirement by the owner of copyright for the software. Please
access the following URL and read the contents of the license.
https://rd1.sony.net/help/speaker/sl/23c/
• Use of the Made for Apple badge means that an accessory has
been designed to connect specifically to the Apple product(s)
identified in the badge, and has been certified by the developer
to meet Apple performance standards. Apple is not responsible
for the operation of this device or its compliance with safety and
regulatory standards.
Disclaimer regarding services offered by third parties
• Services offered by third parties may be changed, suspended,
or terminated without prior notice. Sony does not bear any
responsibility in these sorts of situations.
Notes on waterproof and dustproof
features
(Read before using the unit)
The supplied accessories are neither waterproof nor
dustproof.
Waterproof and dustproof performance of the unit
The unit, with the cap fastened securely, has a waterproof specification
of IPX7 as specified in “Degree of protection against water immersion”
of the IEC60529 “Ingress Protection Rating (IP Code)”, and a dustproof
specification of IP6X as specified in “Degrees of protection against solid
foreign objects”.
• The supplied accessories and the connectors of this unit (USB) are
neither water resistant nor dustproof. To reduce the risk of fires or
electric shocks, do not expose the unit to water or droplets while using
any connectors (USB).
Note that malfunctions as a result of water immersion or dust
intrusion caused by misuse by the customer are not covered by the
warranty.
To avoid the deterioration of waterproof and
dustproof performance
Carefully note the precautions below to ensure proper use of the unit.
• This unit does not have a design that is resistant to water pressure. Use
of the unit in a location where high water pressure is applied, such as
in the shower, may cause a malfunction.
• Do not pour high-temperature water or blow hot air from a hair dryer
or any other appliance on the unit directly. Also never use the unit in a
place subject to high temperatures, such as in a sauna or near a heat
source.
CAUTION : Handle the cap with care. The cap plays a very
important role in maintenance of the water resistant and dustproof
performance. When using the unit, make sure that the cap is closed
completely. When closing the cap, be careful not to allow foreign objects
inside. If the cap is not closed completely the water resistant and
dustproof performance may deteriorate and may cause a malfunction of
the unit as a result of water or dust particles entering the unit.
Cap
Passive radiator
How to care for the unit
You can use the unit more comfortably and for a longer period of time
by following the maintenance procedure below.
• If the surface of the unit gets dirty in the following cases, wash the unit
with fresh water (tap water, etc.) promptly to remove the dirt. Leaving
dirt on its surface may cause the surface to discolor or deteriorate, or
the unit to malfunction.
Ex.
– When salt, sand, etc. is stuck on the unit after using it on a beach,
pool side, etc.
– When the unit is stained with foreign substances (sunscreen, suntan
oil, etc.)
• The sound quality may change when water enters the speaker or
passive radiator section of the unit. It is not malfunction. Wipe off the
moisture on its surface, and put the unit on a dry soft cloth to drain the
collected water inside the unit. Then, dry the unit in an airy place until
no moisture remains.
Note
• If the surface of the unit gets dirty, do not use detergent, thinner,
benzine, alcohol, etc. to clean the unit because it will affect the water
repellent function of the unit.
• Especially in cold regions, be sure to wipe off the moisture after using
the unit. Leaving moisture on its surface may cause the unit to freeze
and malfunction.
Precautions
On placement
• To eliminate the risk of malfunctions, avoid the following locations
when placing or leaving this unit.
– A place subject to high temperatures, such as under direct sunlight or
lighting equipment, near a heat source, or in a sauna
– Inside a vehicle with the windows closed (especially in summertime)
– A place exposed to hot air, such as from a hair dryer
• Place this unit on a flat, level surface. When placed on a sloped surface,
the unit may fall over or fall off the surface due to its own vibration,
resulting in injuries, malfunctions, or performance degradation.
• Depending on the conditions where this unit is placed, it may fall over
or fall off the surface. Do not leave any valuables near the unit.
• This unit is not anti-magnetic. Keep objects susceptible to magnetism
(recorded tapes, watches, cash cards and credit cards with magnetic
coding, etc.) away from the unit. When you carry around the unit, keep
this in mind as well.
Other notes
• Do not use or leave the unit in an extremely cold or hot environment
(temperature outside the range of 5 °C – 35 °C). If the unit is used or left
in outside the above range, the unit may automatically stop to protect
internal circuitry.
• If you use this unit for a long time, the temperature of this unit may
rise, but it is not a malfunction.
• At high temperature, the charging may stop or the volume may reduce
to protect the battery.
• Even if you do not intend to use the unit for a long time, charge
the battery to its full capacity once every 6 months to maintain its
performance.
Trademarks
• Android is a trademark of Google LLC.
• The BLUETOOTH® word mark and logos are registered trademarks
owned by Bluetooth SIG, Inc. and any use of such marks by
Sony Group Corporation and its subsidiaries is under license.
• Apple, the Apple logo, iPhone, iPod and iPod touch are trademarks of
Apple Inc., registered in the U.S. and other countries.
• IOS is a trademark or registered trademark of Cisco in the U.S. and
other countries and is used under license.
• USB Type-C® and USB-C® are registered trademarks of
USB Implementers Forum.
All other trademarks and registered trademarks are trademarks or
registered trademarks of their respective holders. In this manual, ™ and
® marks are not specified.
Specifications
BLUETOOTH®
Frequency band 2.4 GHz band (2.400 0 GHz - 2.483 5 GHz)
General
Power DC 5 V 0.5 A (using a commercially-available USB AC
adaptor capable of feeding in 0.5 A (500 mA)) or, using
built-in lithium-ion battery
Lithium-ion battery life
Approx. 16 hours*1
– Volume level: 36
Approx. 5 hours*1
– Volume level: 50 (MAX.)
Time required for charging the built-in rechargeable battery
Approx. 4.5 hours*2 *3
Operating temperatures
5 °C – 35 °C
Battery charging temperatures
5 °C – 35 °C
Dimensions (including projecting parts and controls)
Approx. mm × 95 mm (dia × h)76
Mass (including battery)
Approx. g274
Included items Wireless Speaker (1)
USB Type-C® cable (USB-A to USB-C)*4 (1)
Strap (1) (attached to the unit)
Documents (1 set)
*1 The built-in battery life above is measured using our specified music
source. Actual performance time may vary from the listed time due
to the volume, songs played, surrounding temperature, and usage
conditions.
*2 Time required for the empty battery to be fully charged (100%) while
the unit is powered off.
*3 Provided that a USB AC adaptor capable of delivering an output
current of 0.5 A (500 mA) is used for battery charging connection.
*4
A charging cable exclusively designed for the unit. Do not use the
cable for any other purposes.
System requirements for charging battery using USB
Using a commercially-available USB AC adaptor capable of delivering an
output current of DC 5 V 0.5 A (500 mA).
Design and specifications are subject to change without notice.
https://rd1.sony.net/help/speaker/7856/h_zz/

Produkt Specifikationer

Mærke: Sony
Kategori: Højttaler
Model: SRS-XB100

Har du brug for hjælp?

Hvis du har brug for hjælp til Sony SRS-XB100 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Højttaler Sony Manualer

Sony

Sony BRAVIA Theatre Rear 8 Manual

8 Juli 2025
Sony

Sony SS-SFCR600 Manual

3 Juli 2025
Sony

Sony ULT FIELD 5 Manual

24 Juni 2025
Sony

Sony ULT FIELD 3 Manual

23 Juni 2025
Sony

Sony BRAVIA Theatre Quad Manual

20 Juni 2025
Sony

Sony BRAVIA Theatre Sub 7 Manual

16 Juni 2025
Sony

Sony BRAVIA Theatre Bar 6 Manual

15 Juni 2025
Sony

Sony ULT TOWER 9 Manual

13 Juni 2025
Sony

Sony SRS-NWT10M Manual

4 Juni 2025
Sony

Sony SRS-T100PC Manual

3 Juni 2025

Højttaler Manualer

Nyeste Højttaler Manualer

KEF

KEF Classic iQ60c Manual

2 August 2025
Lamax

Lamax PartyBoomBox700 Manual

2 August 2025
Lamax

Lamax PartyGo1 Manual

2 August 2025
The Box Pro

The Box Pro DSX 110 M Manual

1 August 2025
Muse

Muse M-968 BTY Manual

1 August 2025
Grundig

Grundig Portable 360 Manual

1 August 2025
Grundig

Grundig Band 360 Manual

1 August 2025
Grundig

Grundig GBT Connect 360 Manual

1 August 2025
Muse

Muse M-968 BTR Manual

31 Juli 2025
JLab

JLab Epic Party Manual

31 Juli 2025