Little Giant 508058 Manual

Little Giant Pumpe 508058

Læs gratis den danske manual til Little Giant 508058 (8 sider) i kategorien Pumpe. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om Little Giant 508058, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
G SAFETY GUIDELINES
READ ALL INSTRUCTIONS AND SAFETY GUIDELINES
THOROUGHLY. FAILURE TO FOLLOW THE GUIDELINES AND
THE INSTRUCTIONS COULD RESULT IN SERIOUS BODILY
INJURY AND/OR PROPERTY DAMAGE.
1. CAUTION: To reduce the risk of electrical shock, pull plug
before servicing this pump.
2. Check local electrical and building codes before installation.
The installation must be in accordance with their regulations.
3. During normal operation the sump pump is immersed in
water. Also, during rain storms, water may be present in the
surrounding area of the pump. Caution must be used to pre-
vent bodily injury when working near the pump:
a. Electrical power should be disconnected prior to touching,
servicing or repairing the pump.
b. To minimize possible fatal electrical shock hazard, extreme
care should be used when changing fuses. Do not stand in
water while changing fuses or insert your finger into the fuse
socket.
4. Do not run the pump in a dry sump. If the pump is run in a
dry sump, the surface temperature of the pump will rise to a
high level. This high level could cause skin burns if the pump
is touched and will cause serious damage to your pump.
5. Do not oil the motor. The pump housing is sealed. A high
grade dielectric oil devoid of water has been put into the motor
housing at the factory. Use of other oil could cause serious
electric shock and/or permanent damage to the pump.
6. This pump’s motor housing is filled with a dielectric lubricant
at the factory for optimum motor heat transfer and lifetime
lubrication of the bearings. Use of any other lubricant could
cause damage and void the warranty. This lubricant is non-
toxic; however, if it escapes the motor housing, it should be
removed from the surface quickly by placing newspapers or
other absorbent material on the water surface to soak it up, so
aquatic life is undisturbed.
7. In any installation where property damage and/or personal
injury might result from an inoperative or leaking pump due to
power outages, discharge line blockage, or any other reason,
a backup system(s) and/or alarm should be used.
RISK OF ELECTRIC SHOCK—This pump is supplied with a
grounding conductor and grounding-type attachment plug. To
reduce the risk of electric shock, be certain that it is connected
only to a properly grounded, grounding-type receptacle. As a
safety measure, each electrical outlet should be checked with an
Underwriters Laboratory Listed circuit analyzer. This will indicate
if the power, neutral and ground wires are properly connected. If
they are not, call a qualified licensed electrician.
ELECTRICAL CONNECTIONS (FIGURE 1)
Your sump pump is supplied with a 3-prong electrical plug. The
third prong is to ground the pump to prevent possible electric
shock hazard. Do not remove the third prong from the plug. A
separate branch electrical circuit is recommended. Do not use an
extension cord.
Figure 1.
INSTALLATION (FIG. 2)
1. Clean any debris from sump pit and set pump in center of pit.
A solid bottom will prevent clogging of the pump from sand
and dirt.
2. Connect discharge piping and run it to the nearest sewer or
surface outlet. Use pipe joint compound at all connections.
Sump pumps can be piped to discharge into the house drain-
age system, to a dry well, splash block or to a storm drain,
depending on local plumbing codes. The discharge pipe
should be as short as possible and contain as few elbows as
possible. The discharge pipe should be the same diameter
as the discharge size to reduce pipe friction losses. Smaller
pipe will restrict capacity and reduce pump performance. The
sump pump comes with 1½” female pipe thread discharge,
and 1-1/4” FNPT reducing bushing.
3. Always install a union in the discharge line, just above the
sump pit to allow for easy removal of the pump for cleaning or
repair.
1
Little Giant
P. O. Box 12010
Oklahoma City, OK 73157-2010
405.947.2511 • Fax: 405.947.8720
www.LittleGiantPump.com
CustomerService-WTS@fele.com
8-CIM, 8-CBM
6-CIA, 8-CIA, 8-CBA

Produkt Specifikationer

Mærke: Little Giant
Kategori: Pumpe
Model: 508058

Har du brug for hjælp?

Hvis du har brug for hjælp til Little Giant 508058 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Pumpe Little Giant Manualer

Little Giant

Little Giant 508058 Manual

19 December 2025
Little Giant

Little Giant 513273 Manual

15 December 2025
Little Giant

Little Giant WGFP-100 Manual

15 December 2025
Little Giant

Little Giant WRSC-6 Manual

9 December 2025
Little Giant

Little Giant 2-MD-HC Manual

9 December 2025
Little Giant

Little Giant WF5 Manual

22 August 2025
Little Giant

Little Giant TP 553674 Manual

6 Juli 2025
Little Giant

Little Giant 5MSP-WG Manual

6 Juli 2025

Pumpe Manualer

Nyeste Pumpe Manualer

Liberty Pumps

Liberty Pumps 237 Manual

19 December 2025
ProFlo

ProFlo PF92305 Manual

15 December 2025
ProFlo

ProFlo PF92370 Manual

15 December 2025
Liberty Pumps

Liberty Pumps CSP-457 Manual

11 December 2025
ProFlo

ProFlo PF93511 Manual

11 December 2025
ProFlo

ProFlo PF92342 Manual

11 December 2025
Liberty Pumps

Liberty Pumps LE41A Manual

11 December 2025
Liberty Pumps

Liberty Pumps LSGX202M Manual

10 December 2025
Liberty Pumps

Liberty Pumps P382XPRG102 Manual

9 December 2025
Vevor

Vevor 2KQ-3G Manual

2 December 2025