Soundskins SSK-GLDTR Manual


Læs gratis den danske manual til Soundskins SSK-GLDTR (5 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 26 personer og har en gennemsnitlig bedømmelse på 3.8 stjerner ud af 13.5 anmeldelser. Har du et spørgsmål om Soundskins SSK-GLDTR, eller vil du spørge andre brugere om produktet?

Side 1/5
Jeep JK/JL/Gladiator Kit Instructions
3a. Next, you need to prop the window up out of the way.
For JLs and Gladiators, turn the accessory on, pop open the
two circular rubber service caps on the door panel, and row
the window around 3/4 of the way down until the bolts are
centered in the cap holes. Then, pull the clips connected to
the glass up. This will allow you to remove the glass and
slide it all the way up to install the kit. Prop the window up
with a rubber wedge covered by a microfiber cloth or place
a screwdriver in the hole underneath the window to prop the
glass up.
1. Start by locating the fastening hardware on the door
panel, take the appropriate screw driver and remove. Once
all the screws are removed you can take off the door panel
gently, watching that you don’t break any of the clips or
mounting hardware.
2. Pull the panel away slowly and unplug any electrical
connections. Under the panel, you will find plastic insert
over the metal door.
R
• Drill with socket set and extension
• Panel/trim tool
• Roller
• Razor blade
• Screw driver
• Rubber wedge
• Microber cloth
• Acetone or cleaning solution
• Shop vacuum
Tools needed for installation:
4. Note that the plastic inserts do not need to be completely
removed to install the door pieces, you can simply hold it off
to the side or have a friend help as you install the material.
Now you are ready to prep the metal surface with a microfiber
cloth and Acetone (use a breathing mask). Wipe away any
moisture, oil, debris, etc. Then let air dry. The point is to get
the surface clean to ensure material glue contact.
3b. To prop the windows up for JKs, remove the 10mm bolts
around the plastic insert and disconnect the wire harnesses.
Peel the panel back and pull the toward you. Then find the
alginment pin located between the insert and door connected
to the bottom of the glass and disconnect it from the glass.
This will allow you to slide the glass up. Prop the window up
with a rubber wedge covered by a microfiber cloth.
5. Locate the piece of the kit with the label on the back that
coincides with the door you’re working on. Make sure it lines
up and is correct before pulling the white cover paper off,
then pull off the white paper and start placing the material at
the top and work your way down. Use a roller to apply the
material completely. Use a razor blade point or needle to
release any air bubbles. Repeat these steps for all door
panels, then reverse the process to replace your doors.
6. Next, you will need to disconnect your car batteries before
removing the seats. You will need to disconnect the negative
battery terminal. If your JL has an extra battery, be sure to
disconnect that as well by disconnecting the secondary
ground cable from the 13mm lug.
You can double check that your batteries are correctly
disconnected by going back inside your car and turning on
your dome light. If it does not turn on, you have completed
this step correctly.


Produkt Specifikationer

Mærke: Soundskins
Kategori: Ikke kategoriseret
Model: SSK-GLDTR

Har du brug for hjælp?

Hvis du har brug for hjælp til Soundskins SSK-GLDTR stil et spørgsmål nedenfor, og andre brugere vil svare dig