Soundskins SSK-WJLTRUNK Manual


Læs gratis den danske manual til Soundskins SSK-WJLTRUNK (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 30 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 15.5 anmeldelser. Har du et spørgsmål om Soundskins SSK-WJLTRUNK, eller vil du spørge andre brugere om produktet?

Side 1/3
Jeep JL Trunk Kit Instructions
1. Start by unclipping the side panels on your wheel wells.
Begin from the top of the side panels. If you have a factory
subwoofer, remove the torque bolt at the front to unplug the
subwoofer.
Then, remove the main floor piece by sliding it back and up,
and remove the side carpet pieces by removing the 6 clips
that cover the tops of the torque bolts.
2. Next, unclip the flap/panel that sits on the back of the
backseat. It will be tight, so use a clip removal tool or the
back side of a hammer to wedge the clips out. Once this
panel is off, it will reveal the 3 bolts holding down the
backseats of the Jeep.
3. To remove the backseats, you will need an 18mm socket to
remove the bolts. Take out the 2 bolts in the back and the
bolts in front of the backseats. When all bolts are out, remove
the smaller seat first, then the larger seat. Be sure you also
remove the seatbelt bolts. Then, remove the carpet under
the backseat area.
R
Scan this code to watch the
full instructional video!
• Socket tool set & extension
• Panel/trim tool
• Roller
• Clip removal tool
• Screw driver
• Microber cloth
• Acetone or cleaning solution
• Shop vacuum
• Razor blade
Tools needed for installation:


Produkt Specifikationer

Mærke: Soundskins
Kategori: Ikke kategoriseret
Model: SSK-WJLTRUNK

Har du brug for hjælp?

Hvis du har brug for hjælp til Soundskins SSK-WJLTRUNK stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Soundskins Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer