Speco Technologies O4VT1MN Manual


Læs gratis den danske manual til Speco Technologies O4VT1MN (46 sider) i kategorien Overvågningskamera. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Speco Technologies O4VT1MN, eller vil du spørge andre brugere om produktet?

Side 1/46
User Manual
4MP IP Camera
O4VD1 /O4VT1N/ O4VT1NG/ O4VT1MN / O4VB1N / O4VB1NG/O4VB1MN/ MN
O4VD1N/ O4VD1NG
Please read this manual carefully before operang the unit keep it for further reference and
Important Safeguards and Warnings
1. Electrical safety
All installaon and operaon here should conform to local electrical safety codes.
Use a cered/listed 12VDC Class2 power supply only.
Please note: Do not connect two power supplying sources to the device at the same me; it may result in device damage! The
product must be grounded to reduce the risk of electric shock.
Improper handling and/or installaon could run the risk of re or electrical shock.
2. Environment
Do not expose the heavy stress, violent vibraon long-term exposure water humidity during transportaon, unit to or to and
storage, and/or installaon.
Do not install near sources heat. of
Only install the product environments inside the specicaon operang temperature humidity range. in and
Do not install the camera near power lines, radar equipment other electromagnec radiation. or
Do not block any venlaon enings any. op if
Use all the weatherproong hardware requirement minimize weather intrusion.to
3. Operaon and Daily Maintenance
Please shut down the device and then unplug the power cable before you begin any maintenance work.
Do not touch the CMOS sensor opc component. You can use a blower to clean the dust on the lens surface.
Always use the dry so cloth to clean the device. If there is too much dust, use a cloth dampened with a small quanty of neutral
detergent. Finally use the dry cloth to clean the device.
Please use a professional optical cleaning method to clean the enclosure. Improper enclosure cleaning (such as using cloth) may
result in poor IR functionality and/or IR reecon.
The grounding holes of the product are recommended to be grounded to further enhance the reliability of the camera.
Dome cover is an opcal device, please do not touch or wipe cover surface directly during installaon and use, please refer to the
following methods if dirt is found.
Stained with dirt:
Use oil-free so brush or hair dryer to remove it gently.
Stained with grease or ngerprint.
Use oil-free coon cloth or paper soaked with alcohol or detergent to wipe from the lens center outward. Change the cloth and
wipe several mes if it is not clean enough.


Produkt Specifikationer

Mærke: Speco Technologies
Kategori: Overvågningskamera
Model: O4VT1MN

Har du brug for hjælp?

Hvis du har brug for hjælp til Speco Technologies O4VT1MN stil et spørgsmål nedenfor, og andre brugere vil svare dig