Stauer 38664 Manual

Stauer Ur 38664

Læs nedenfor 📖 manual på dansk for Stauer 38664 (1 sider) i kategorien Ur. Denne guide var nyttig for 3 personer og blev bedømt med 5.0 stjerner i gennemsnit af 2 brugere

Side 1/1
WATCH DISPLAY
TIMESETTING
Stauer Solar Chronograph
INSTRUCTION MANUAL
Visit us at www.stauer.com
to learn more about the fantastic
benefits of owning a Stauer Watch!
www.stauer.com
0
1
2
12
1545
30
60
816
24
1020
30
A - Start/Stop Button
B - Crown
C - 24-Hour Dial
D - Split/Reset Button
E - Date Window
F - Second Hand
G - Chronograph Seconds Dial
H - Chronograph Minute Dial
TO SET THE TIME
1. Pull the crown (part B) out to position “2”
and rotate it to the desired time.
2. Once the correct time is set, push
the crown back into “0” (zero) position.
e Second Hand (part F) will start
to run.
TO SET THE DATE
1. Pull the crown (part B) out to position “1”
and rotate it clockwise (away from you) to the
desired date (part E).
2. Once the correct date is set, push the crown
back into “0” (zero) position.
NOTE: e date should not be adjusted
between the hours of 9pm and 1am.
TO SET THE CHRONOGRAPH
is chronograph is able to measure and
display time in 1 second increments up to
a maximum of 59 minutes (part H) and
59 seconds (part G).
1. To start the Chronograph feature, press
the Start/Stop Button (part A). To measure
split times press the Split/Reset Button (part
D) to stop counting.
2. Press the Split/Reset Button (part D) to
reset the chronograph, and the Second Hand
(part F), the Chronograph Minute Dial (part
H) and the Chronograph Second Dial (part
G) will all return to the zero position.
3. For split time, press the Split/Reset
Button (part D) again after stopping the
chronograph to restart the chronograph
function. en press the Start/Stop Button
(part A) to stop, and the Split/Reset Button
(part D) to reset.
FEATURES
- Precision movement
- Stainless steel case back
- Stainless steel bracelet
- 24-hour military time, minute &
second subdials
- Date window
- Water resistant to 3 ATM
USING THE CHRONOGRAPH
B.
A.
C.
E.
D.
CHARGING
F.
CHRONOGRAPH RESET
Chronograph Reset (includes after
replacing the battery)
1. Pull the crown (part B) out to position “2”
when the second hand (part F) is at the 12
o’clock position.
2. Press the Start/Stop Button (part A) to set
the Chronograph Second Hand (part G) to
the zero position. e chronograph hand can
be advanced rapidly by continuously pressing
the Start/Stop Button (part A).
3. Once the Chronograph Second Hand (part
G) has been set to the zero position, push the
crown (part B) back into “0” (zero) position.
IMPORTANT - Before using the stopwatch,
make sure the crown is set at the “0” position
and that the stopwatch hands are reset to the
“0” position. If the stopwatch hands do not
return to the “0” position, follow the steps
above to reset the chronograph.
Charge the watch by exposing it to a light
source. DO NOT place it too close to a hot
light source or leave it exposed to the sun for a
long time, as this can raise the watch tempera-
ture and damage the product.
e Chronograph Second Hand can be used
to check the power reserve amount.
1. Make sure the Chronograph Second Hand
is reset at the zero position. Press the reset but-
ton for 2 seconds. is will set the hand at the
30 second position and will move to inidicate
the power reserve amount for 3 seconds.
Low Charge 35 seconds Less an 30 days
Half Charge 40 seconds 30 - 90 days
High Charge 45 second 90+ days
NOTE - When the energy is reduced to a low
level, the second hand moves at 2-second inter-
vals instead of 1-second intervals. Charge the
watch as soon as possible by exposing to light.
NOTE - Battery replacement is not necessary
for this watch. NEVER replace with a silver
oxiede battery as it may explode.
G.
H.


Produkt Specifikationer

Mærke: Stauer
Kategori: Ur
Model: 38664

Har du brug for hjælp?

Hvis du har brug for hjælp til Stauer 38664 stil et spørgsmål nedenfor, og andre brugere vil svare dig