Visit us at www.stauer.com
to learn more about the fantastic
benefits of owning a Stauer Watch!
F - Chronograph Seconds Hand
H - Chronograph Minute Dial
1. Pull the crown (part B) out to position “2”
and rotate it to the desired time.
2. Once the correct time is set, push the
crown back into “0” (zero) position. e
Seconds Dial (part G) will start to run.
1. Pull the crown (part B) out to position
“1” and rotate it clockwise (away from you) to
the desired date (part E).
2. Once the correct date is set, push the crown
back into “0” (zero) position.
NOTE: e date should not be adjusted be-
tween the hours of 9pm and 1am.
is chronograph is able to measure and
display time in 1 second increments up to a
maximum of 59 minutes (part H) and
1. To start the Chronograph feature, press
the Start/Stop Button (part A). To measure
split times press the Split/Reset Button (part
2. Press the Split/Reset Button (part D) to
reset the chronograph, and the Chronograph
Minute Dial (part H) and the Chronograph
Second Hand (part G) will all return to the
3. For split time, press the Split/Reset But-
ton (part D) again after stopping the chro-
nograph to restart the chronograph function.
en press the Start/Stop Button (part A) to
stop, and the Split/Reset Button (part D) to
When resetting the chronograph, only return
the crown (part B) to the normal “0” (zero)
position when the second hand (part G) is in
the 12 o’clock position. e second hand stops
when the crown is pushed in to the “0” (zero)
position and that position is then recognized as
- Stainless steel case back
- Stainless steel bracelet
- 24-hour military time, minute &
- Water resistant to 3 ATM
Chronograph Reset (includes after
1. Pull the crown (part B) out to position “2”.
2. Press the Start/Stop Button (part A) to set
the Chronograph Second Hand (part F) to the
zero position. e chronograph hand can be
advanced rapidly by continuously pressing the
Start/Stop Button (part A).
3. Once the Chronograph Second Hand (part
F) has been set to the zero position, push the
crown (part B) back into “0” (zero) position.
