
INSTRUCTIONS
SL-539
Read instrucons carefully & save for future reference.
SOLAR PANEL ASSEMBLY
3. Fill the reservoir with water, ensuring the
pump will remain completely submerged during
operaon.
7. Your new fountain is ready to use.
6. Connect the pump and LED light cables to the
solar panel (charger sold separately).
SL0454 INSTRUCTIONS (PAGE 1 / 4) SL0454 INSTRUCTIONS (PAGE 2 / 4)
PUMP
Continual ON
until all battery power is used
LIGHT
CHARGER
(sold separately)
4-Hour Timer
(on for 4 hours only)
Daily 4-Hour Timer
(on for 4 hours, off for 20 hours,
repeates daily at the same time)
Battery Low
(battery pack needs
to be charged)
Power
on/off
Timer
modes
2. Extend the pump and LED light cables through
the access panel in the back of the fountain, cables
are ready for connecon to the solar panel.
SL-539
1. From the access panel in the back of the
fountain, locate the built-in hose and light cable.
Aach the pump to the hose and place inside the
fountain.
4. Connect the bracket, tube, and spike and aach
the solar panel to the bracket as shown.
SL-539
FOUNTAIN ASSEMBLY
Select a level locaon to place the fountain.
Assemble components on a smooth, clean surface
to avoid scratching or damaging the nish.
ACCESS PANEL
HOSE
PUMP
BRACKET
TUBE
BRACKET
SPIKE
SOLAR PANEL
ACCESS PANEL
HOSE
PUMP
11/201911/2019
PARTS
(1) Water Fountain
(1) Pump with 5m Cable (inside solar panel box)
(1) LED Light with 5m Cable (inside the fountain)
(1) Solar Panel, Bracket, Tube, Spike
Ensure all parts are accounted for before disposing of packaging.
INCORRECT
5. Insert the spike into the ground. Posion the solar
panel to face south (in the northern hemisphere)
to make the most of daylight hours. It is important
to angle the solar panel towards the sun when the
sun is at its highest point. Ensure trees, shrubs, or
buildings do not shade the solar panel.
Over me, the nish may gradually mellow in color;
this is part of the natural aging process.