Tangent Spectrum X5 Manual

Tangent Højttalere Spectrum X5

Læs gratis den danske manual til Tangent Spectrum X5 (8 sider) i kategorien Højttalere. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Tangent Spectrum X5, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Spectrum X5 Instruction manual

Instruction manual

Thank you for purchasing Tangent loudspeakers. You have just purchased one of the

best domestic hi loudspeakers available and we hope you will enjoy the music they

reproduce for many years to come. The following notes are designed to assist you in

obtaining a greater degree of musical satisfaction from your Tangent loudspeakers.

Before connecting your loudspeakers, we suggest that you read this leaets carefully.

Amplier capacity - power handling

Your Tangent loudspeaker system will operate satisfactorily with any good amplier

designed for use with an 4-8 Ohm impedance load. Although Tangent loudspeakers are

designed to handle high power loadings, you must remember that any loudspeaker that

is abused with excessive use of volume, tone controls and graphic equalisers is likely to

cause damage to the drive-units. Be careful especially with small ampliers constantly

driven on high power levels as these may be liable to go into „clipping mode“ and

distort the signal causing possible damage. If you hear a distorted signal through the

loudspeakers you must reduce the power level.

Connecting to your amplier

Some of the Tangent loudspeakers are supplied with cables, however we strongly

recommend the use of high quality speaker cables, colour coded or grooved cables are

recommended to assist checking polarity, your local dealer should be able to advise

you on this point. Always switch OFF your amplier before making any connections or

adjustments to the system. Wire the right-hand channel cable so that the positive (RED)

terminal of your loudspeaker is connected to the positive (RED) on your amplier, and

the negative (BLACK) terminal of your loudspeaker is connected to the negative (BLACK)

terminal on your amplier. Repeat the instructions for the left-hand channel. Do NOT

connect more than one loudspeaker to one terminal on your amplier.

Phasing

Providing that you have followed the connecting instruction correctly the loudspeakers

should be in phase and provide solid stereo images. If however, you have any doubt as

to the phasing of the loudspeakers, try reversing the connections (RED & BLACK) to ONE

of the loudspeakers, and play a recording which has plenty of deep bass operating both

loudspeakers simultaneously with the stereo amplier switched to „mono“. The correct

polarity is indicated by rm full bass, when incorrect, the bass will be noticeably much

weaker.

Loudspeaker positioning

Ideally the Tangent loudspeakers should be positioned at least 50 cm from a rear wall, 1

meter from a side wall and at least 2 metres apart. The space between the two loud-

speakers and the distance form the listeners are important. If loudspeakers are placed

too close together or too far apart, stereo images will not be fully developed. In average

living rooms, speaker spacing between 2 and 4 metres will usually produce satisfactory

results. The listeners distance from the loudspeakers should be at least equal to and

preferably greater than the distance between the loudspeakers. Tests should be made

with both speech and music before deciding upon nal locations.

Service

No routine attention is required to the working parts of the loudspeakers and being very

reliable Tangent loudspeakers rarely require service. Any service problems should in the

rst instance be referred to your dealer.

Produkt Specifikationer

Mærke:	Tangent
Kategori:	Højttalere
Model:	Spectrum X5
Bredde:	166 mm
Dybde:	205 mm
Højde:	340 mm
Vægt:	4000 g
Produktfarve:	Sort
Udgangseffekt (RMS):	100 W
Equalizer:	Ingen
Anbefalet brug:	Universel
Frekvensområde:	50 - 20000 Hz
Impedens:	6 ohm (Ω)
Forbindelsesteknologi:	Ledningsført
Højttaler, type:	2-vejs
Lyd-output kanaler:	2.0 kanaler
Højttaler, placering:	Bordplade/bogreol
Antal drivere:	2
Diskanthøjttaler:	Ja
Sensitivitet:	88 dB
Diskant diameter:	25 mm
Bashøjttaler:	Ja
Woofer diameter:	130 mm
Basrefleks:	Ja
Egnet til udendørs brug:	Ingen