Tor Rey DT-2 Manual


Læs gratis den danske manual til Tor Rey DT-2 (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 33 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 17 anmeldelser. Har du et spørgsmål om Tor Rey DT-2, eller vil du spørge andre brugere om produktet?

Side 1/1
INSTRUCTIONS
NOTES:
The printer is pre-programmed at Torrey to communicate with your scale.
You will need to purchase a RS-232 9 pin serial cable. It must be a straight thru, male on one end, female
on the other end. DO NOT purchase a null modem cable. It will not work.
The yellow button on top of printer is for programming/diagnostics only. Do not press it.
Do not run the software while the printer is connected to a computer. This may erase or alter the
programming.
When you turn on the printer, after a few seconds the led (light) on top should turn yellow/orange.
work but you might need to follow the procedure below).
To print a label, put weight on the platter, enter a price, then press M+. A label should print and you will
see something like TOT 1. This means total of items you weighed. Press C once to weigh another product
or press C twice to clear total.
If the led (light) turns red or the labels are not dispensing correctly, follow the procedure below:
1). Turn off printer
2). Hold in button on top of printer and turn on.
3). Hold in button until led (light) flashes yellow. Release button.
4). After a few seconds the printer will dispense several labels. It should be calibrated now.
5). Turn off and back on. Led (light) should turn yellow/orange.
6). Print a label.


Produkt Specifikationer

Mærke: Tor Rey
Kategori: Ikke kategoriseret
Model: DT-2

Har du brug for hjælp?

Hvis du har brug for hjælp til Tor Rey DT-2 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Tor Rey Manualer

Tor Rey

Tor Rey DT-2 Manual

23 August 2024

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer