Traco Power TPC-REM240-24 Manual

Traco Power Ikke kategoriseret TPC-REM240-24

Læs gratis den danske manual til Traco Power TPC-REM240-24 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 46 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 23.5 anmeldelser. Har du et spørgsmål om Traco Power TPC-REM240-24, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

http://www.tracopower.com Rev:0.0

2013, JZ

INSTALLATION INSTRUCTIONS

TPC-REM Series Redundancy / Current Sharing Modules.

These modules allow a redundant and parallel operation of any two equal TPC power supplies. The modules

achieve equal current sharing for both power supplies in normal operation. In case one power supply fails there are

internal decoupling diodes to isolate it from the load in order to enable the remaining power supply providing its

energy.

Order Code

Nominal Input

Voltage *

Max. Input Current

Output Voltage Range

adjustable

Max. Output Current

TPC-REM240-24

TPC-REM240-48

24 VDC

48 VDC

2 x 5 A

2 x 2.5 A

24-28 VDC

48-55 VDC

5 A

* Voltage drop over input lines should be below 0.5 VDC

Block diagram

Operating temperature range:

Natural Air Convection Cooling

-25°C

–

+50°C max (measuring point: 3cm below the unit)

-13°F – +122°F max

Storage temperature range:

-25°C

–

+85°C ma

-13°F – +185°F max

Parallel Operation: 2 power supplies of TPC Series. Not suitable with other power supplies

Reverse voltage max. TPC-REM240-24: 35V, TPC-REM240-48: 63V

Electromagnetic compatibility:

In correspondence to connected units (no additional emission)

Connector 1

2x Input DC + DC-OK

5 screw terminals Similar to Phoeni

MKDS 1,5/5-5,08 type

Connector 2

1x Output DC + PE*

3 screw terminals Similar to Phoeni

MKDS 1,5/5-5,08 type

Wire size input / output

WG 20-14/0.5-2.5mm2

Signal connector / Wire size

2pin plug-in type, MOLEX KK-2 type, MOLEX 08-50-0032

AWG 30-22/0.05-0.3mm2

Casing material Plastic Makrolon 2405 (Beyer)

Chassis dimension 45mm x 90mm x 96.5mm [W x H x D]

IP Class IP20

Protection class

Class 3 (PE connection not required for safety, internal Y-capacitor connection to

+Vout for supplementary filtering purpose)

Mounting position Vertical

Mounting DIN-rail or wall mounting with adaptor (included)

http://www.tracopower.com Rev:0.0

2013, JZ

Safety Instructions:

 Before installation read these instructions carefully and

completely. This installation instruction cannot account for

every possible condition of installation, operation or

maintenance. Further information can be obtained from

your local distributor’s office or from the product datasheet,

which can be downloaded, from the Internet at

http://www.tracopower.com/products/tpc.pdf.

 The mains supply voltage connection, must be in

accordance to IEC 62103, EN 50178 and IEC 60364, VDE

100.

 Before any installation, maintenance or modification work

ensure that the main switch is switched off and prevented

from being switched on again. Non-observance, touching

of any live components or improper handling of TPC-

REM240 can result in death, severe personal injury or

substantial property damage. Proper and safe operation is

dependent on proper storage, handling, installation and

operation.

 Compliance with the relevant national regulations (in the

USA, Europe and other countries) must be ensured.

Before operation is started the following conditions must

be ensured:

 Connection to the TPC power supplies in compliance

with national regulations (VDE0100 and EN50178).

 By use of stranded wires, all strands must be fastened

in the terminal blocks.

 All input and output wires must be rated for the rated

current and must be connected with the correct polarity.

 Sufficient cooling must be ensured.

 Never work on TPC-REM240 if power is supplied! Risk

of electric arcs and electrical shock, which can cause

death, severe personal injury or substantial property

damage.

 Warning: Do not open the TPC-REM240 until at least 5

minutes after it has been disconnected from the power

supplies on all poles.

 Only trained personnel may open the TPC-REM240.

 Do not introduce any objects into the power supply.

 Keep away from fire and water

Installation Instructions:

 This TPC-REM240 is designed for professional indoor

systems. In operation the TPC-REM240 must not be

accessible. It may be installed and put into service by

qualified personnel only.

 The correct mounting position for optimal cooling

performance must be observed. Do not cover any

ventilation holes. Leave a free space of minimum 50mm

(2in.) above and below the power supply. Observe power

derating.

 Recycling: The unit contains elements that are suitable for

recycling, and components that need special disposal. You

are therefore requested to make sure that the power

supply will be environment friendly recycled at the end of

its service life.

Produkt Specifikationer

Mærke:	Traco Power
Kategori:	Ikke kategoriseret
Model:	TPC-REM240-24
Type:	DC/DC
Bredde:	45 mm
Dybde:	90 mm
Højde:	96.5 mm
Vægt:	190 g
Produktfarve:	Sort
Strøm:	120 W
Opbevaringstemperatur (T-T):	-50 - 125 °C
Relativ luftfugtighed ved drift (H-H):	0 - 95 %
Driftstemperatur (T-T):	-25 - 70 °C
Antal:	1
Materiale:	Copper, Silicone, Nickel, Plastic
Udgangsspænding:	24 V
Bæredygtighedscertifikater:	RoHS
DC indgangsspænding:	24-28 V
Overholdelse af bæredygtighed:	Ja
DIN-skinne montering:	Ja
Udgående strøm:	10000 mA