Tripp Lite NGI-M05-C1 Manual

Tripp Lite bryter NGI-M05-C1

Læs gratis den danske manual til Tripp Lite NGI-M05-C1 (254 sider) i kategorien bryter. Denne vejledning er vurderet som hjælpsom af 5 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 3 anmeldelser. Har du et spørgsmål om Tripp Lite NGI-M05-C1, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/254

system, or transmitted in any form or by any means, whether electronic, mechanical,

photo copying, recording or otherwise, without the prior written permission of the

publisher.

FCC WARNING

This equipment has been tested and found to comply with the limits for a class

A device, pursuant to part 15 of FCC rules. These limits are designed to provide

reasonable protection against harmful interference in a commercial installation.

This equipment generates uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communication. Operation of this equipment in a residential area is likely to

cause harmful interference, in which case, the user will be required to correct the

interference at the user’s own expense.

This is a Class A product. In a domestic environment, this product may cause

radio interference in which case the user may be required to take adequate

measures.

HOT & COLD WARNING

The Switch surface will be getting very hot or cold depend on the operating

environment. Please take special care when touch to the working switch.

Take special care to read and understand all the content in the

warning boxes.

Do not work on the system or connect or disconnect cables during

periods of lightning activity.

Before working on equipment that is connected to power lines,

remove jewelry (including rings, necklaces and watches). Metal

objects will heat up when connected to power and ground and can

cause serious burns or weld the metal object to the terminals.

Do not stack the chassis on any other equipment. If the chassis falls,

it can cause severe bodily injury and equipment damage.

An exposed wire lead from a DC-input power source can conduct

harmful levels of electricity. Be sure that no exposed portion of the

DC-input power source wire extends from the terminal block plug.

Ethernet cables must be shielded when used in a central office

environment.

If a redundant power system (RPS) is not connected to the switch,

install an RPS connector cover on the back of the switch.

Warning

Produkt Specifikationer

Mærke:	Tripp Lite
Kategori:	bryter
Model:	NGI-M05-C1
Bredde:	31 mm
Dybde:	104.9 mm
Højde:	136.1 mm
Vægt:	530 g
Produktfarve:	Sort
Opbevaringstemperatur (T-T):	-40 - 85 °C
Relativ luftfugtighed ved drift (H-H):	5 - 95 %
Driftstemperatur (T-T):	-10 - 60 °C
Husmateriale:	Metal
Certificering:	FCC, CE, RoHS, REACH
LED-indikatorer:	Speed, Power
DC indgangsspænding:	24 - 57 V
Indgangsstrøm:	6 A
Strøm over Ethernet (PoE):	Ingen
Switch-type:	Administreret
Auto MDI/MDI-X:	Ja
Basis omskiftning RJ-45 Ethernet porte, antal:	5
Basis omskiftning RJ-45 Ethernet porttype:	Gigabit Ethernet (10/100/1000)
MAC adresselabel:	8000 entries
Switch kapacitet:	12 Gbit/sek.
Jumbo Frames support:	Ja
Jumbo rammer:	10000
Antal SFP modulslots:	1
Strømforsyning inkluderet:	Ja
MAC-adresse auto-indlæring understøttet:	Ja
Stabelbar:	Ja
DIN-skinne montering:	Ja
DHCP funktioner:	DHCP snooping