Tripp Lite OmniSmart OMNISMART700TSU Manual

Tripp Lite UPS OmniSmart OMNISMART700TSU

Læs gratis den danske manual til Tripp Lite OmniSmart OMNISMART700TSU (36 sider) i kategorien UPS. Denne vejledning er vurderet som hjælpsom af 27 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 14 anmeldelser. Har du et spørgsmål om Tripp Lite OmniSmart OMNISMART700TSU, eller vil du spørge andre brugere om produktet?

Side 1/36
UPS Systems
Models:
OMNIVS800LCD, OMNIVS1000LCD, OMNIVS1200LCD,
OMNISMART700TSU, OMNIVS1500LCD
(Series Numbers: AG-02F0, AG-02F1, AG-02F2, AG-02F3, AG-87D5)
Owner’s Manual
1111 W. 35th Street, Chicago, IL 60609 USA • www.tripplite.com/support
Copyright © 2019 Tripp Lite. All rights reserved.
Español 13 • Français 25
PROTECT YOUR INVESTMENT!
Register your product for quicker service and ultimate peace of mind.
You could also win an ISOBAR6ULTRA surge protector—a $100 value!
www.tripplite.com/warranty
18-10-316-9338D9.indb 1 12/27/2018 1:30:21 PM
2
SAVE THESE INSTRUCTIONS
This manual contains instructions and warnings that should be followed during the
installation, operation, maintenance and storage of the UPS and batteries. Failure
to heed these warnings may affect the warranty.
UPS Location Warnings
Install your UPS indoors, away from excess moisture or heat, conductive contaminants, dust
or direct sunlight.
For best performance, keep the indoor temperature between 32º F and 104º F
(0º C and 40º C).
Leave adequate space around all sides of the UPS for proper ventilation.
Only set the UPS upright on a sturdy flat surface. Do not block fans or ventilation holes, as
this will seriously inhibit the unit's internal cooling and cause product damage not covered
under warranty.
UPS Connection Warnings
Connect your UPS directly to a properly-grounded AC power outlet. Do not plug the UPS into
itself; this will damage the UPS.
Do not modify the UPS plug, and do not use an adapter that would eliminate the UPS
ground connection.
Do not use extension cords to connect the UPS to an AC outlet.
If the UPS receives power from a motor-powered AC generator, the generator must provide
clean, filtered, computer-grade output.
The mains socket outlet that supplies the UPS should be easily accessible and located near
the UPS.
Equipment Connection Warnings
Install in accordance with National Electrical Code standards ANSI/NFPA
70 and Canadian Electrical Code, Part I, C22.1.
Short-circuit backup protection and overcurrent protection is provided by
the building installation.
To reduce the risk of fire, connect only to a circuit provided branch circuit
overcurrent protection in accordance with the National Electrical Code,
ANSI/NFPA 70 and the Canadian Electrical Code, Part I, C22.1. The plug on
the power supply cord is intended to serve as the disconnect device. Be
sure that the socket-outlet is installed near the equipment and is made
easily accessible.
Important Safety Instructions
18-10-316-9338D9.indb 2 12/27/2018 1:30:21 PM


Produkt Specifikationer

Mærke: Tripp Lite
Kategori: UPS
Model: OmniSmart OMNISMART700TSU

Har du brug for hjælp?

Hvis du har brug for hjælp til Tripp Lite OmniSmart OMNISMART700TSU stil et spørgsmål nedenfor, og andre brugere vil svare dig