Trust 200DSM Manual

Trust Røgalarm 200DSM

Læs gratis den danske manual til Trust 200DSM (3 sider) i kategorien Røgalarm. Denne vejledning er vurderet som hjælpsom af 58 personer og har en gennemsnitlig bedømmelse på 3.6 stjerner ud af 29.5 anmeldelser. Har du et spørgsmål om Trust 200DSM, eller vil du spørge andre brugere om produktet?

Side 1/3
TRUST WIRELESS SMOKE DETECTOR 200DSM
1
1 Introduction
This manual is intended for users of the Trust Wireless Smoke Detector 200DSM. The
Wireless Smoke Detector 200DSM can be used with Trust alarm systems from the
200 series.
This wireless smoke detector is active 24 hours a day. As soon as any smoke or fire is
detected, an alarm signal will be transmitted to your alarm centre. This centre will
immediately sound an alarm via the 24 hour zone, even if the alarm centre is switched
off.
The wireless smoke detector is sold with a 9V alkaline battery.
2 Safety
2.1 General
1. Do not use this device in damp environments such as bathrooms, swimming
pools, etc.
2. Do not try to repair this device yourself.
3. Under the following circumstances disconnect the batteries and have the
device repaired by qualified personnel:
a) Fluid has entered the device;
b) The device has been dropped and/or the housing is damaged.
2.2 Batteries
1. The alkaline battery of the smoke alarm is not rechargeable. Do not try to
recharge these batteries. This may result in an explosion.
2. Do not throw the batteries in an open fire. The batteries may explode.
3. Never drill a hole in the batteries.
4. Keep the batteries out of the reach of small children.
5. When the batteries are empty, ask your local authority where you can dispose
of them.
TRUST WIRELESS SMOKE DETECTOR 200DSM
2
UK
3 Function description
For a summary of the various functions of the wireless smoke detector, see figure 1
and the table below:
Function Description
ALED Blinks every 10 seconds in the ‘stand-by mode,
and stays on continuously when an alarm signal
is being given.
BDetection room When smoke enters this room via the grating,
this will be detected by the internal optic sensors
and an alarm signal will be transmitted.
When the room is smoke-free, the smoke
detector will automatically be reset to the ‘stand-
by’ mode.
4 Installation
For installation of the wireless smoke detector, follow the steps below:
1. Remove the back plate (A) of the smoke detector by loosening it counter-
clockwise. See figure 2.
2. Connect the enclosed 9V alkaline battery to the battery connection (B).
3. Select a suitable location for the installation.
Note: The best location for the smoke detector is in the middle of the
ceiling, or at least 60 cm away from the wall on the ceiling. When
installing in a staircase, the best location is above the top step of
the stairs.
4. Press the test button (C) to test the communication between the smoke
detector and your alarm centre. The alarm will emit 6 beeps to confirm receipt.
5. Attach the back plate (A) at the location selected to the ceiling with the
enclosed screws and plugs.
6. Reattach the smoke detector to the back plate by turning it clockwise until
tight.
4.1 Important information for installation:
1. Installing the smoke detector in the kitchen is not recommended. Fumes from
cooking may cause false alarms.
2. Do not place the smoke detector in the vicinity of fans, air conditioners, etc.
These may affect the sensitivity of the sensor.
3. Do not place the smoke detector between supporting beams and above ceiling
tiles. These may affect the sensitivity of the sensor.


Produkt Specifikationer

Mærke: Trust
Kategori: Røgalarm
Model: 200DSM
Produktfarve: Hvid
Batterispænding: 9 V
Strømkilde: Batteri
Detektor type: Luftprøve detektor

Har du brug for hjælp?

Hvis du har brug for hjælp til Trust 200DSM stil et spørgsmål nedenfor, og andre brugere vil svare dig




Røgalarm Trust Manualer

Trust

Trust 200DSM Manual

17 December 2023

Røgalarm Manualer

Nyeste Røgalarm Manualer