2
USER MANUAL
912400575012UM
WWW.VARI-LITE.COM
PREFACE
1. ABOUT THIS MANUAL
The document provides installation and operation instructions for the following product(s):
• VL800 EVENTWASH
Read all instructions before installing or using this product. Retain this manual for future reference.
2. INCLUDED ITEMS
Each VL800 EVENTWASH luminaire includes the following items:
• VL800 EVENTWASH
• Quick Start Guide
3. SAFETY NOTICES
• Unpack and check carefully for shipping damage before using the fi xture.
• Installation and operation only to be performed by trained personnel.
• Use safety tether for mounting.
• Install only in locations with adequate ventilation. There must be at least 50cm (20 in) clearance between
the fi xture and adjacent surfaces.
• To prevent overheating, ensure sure that air can fl ow freely from ventilation .
• Prior to operation, ensure that the voltage and frequency of the power supply match the power require-
ments of the unit.
• To minimize the risk of electric shock, ground the yellow/green conductor.
• Do not operate outside the ambient temperature range of 0-40°C.
• Do not connect the device to any dimmer pack.
• Upon fi rst run, there may be smoke or smells. These will disappear after a few minutes of operation.
• Do not place fl ammable materials near the fi xture.
• Inspect power cables and replace any damaged cables before each use.
• During operation, surface temperature of the fi xture can reach up to 65°C. DO NOT touch the housing of
the fi xture.
• When not in use, turn fi xture o to avoid shortening lifespan.
• Do not operate in dirty or dusty environment. Clean fi xture regularly.
• Do not allow children to operate the fi xture.
• Do not touch cables while the fi xture is operation as there might be a hazard of electric shock.
• Avoid power wires together around other cables.
• In the event of serious operating problem, stop using the unit immediately.
• Never turn on and o the unit time after time.
• Regularly Inspect housing, lenses, ultraviolet fi lter, and cables. These items must be replaced if they are
visibly damaged.
• Do not open the fi xture as there are no user serviceable parts inside. Never attempt to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the
nearest Authorized Service Center.
• Disconnect the mains power if the fi xture is not used for a long time.
• Do use original packing materials once transport it again.
• To prevent or reduce the risk of electrical shock or fi re, do not expose the unit to rain or moisture.
• Do not look directly at LED light beam.
