
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
Page 1 / 2
231123
T0290 / T0450
Turn off the power at fuse or circuit
box.
Installation Steps
1. Attach the mounting strap unit (A) to the outlet box by
using two mounting screws (B).
2. Unscrew the finial (I) , decorative cap (H), hex nut (E),
metal pad (F) and rubber pad (G) from the fixture. Then
remove glass assembly from the threaded pipe.
3. Pull out the source wires from the outlet box. Make wire
connections using wire connectors (C) as follows:
---Connect the hot wire (black insulation) from the
fixture to the black wire from the power source.
---Connect the neutral wire (white insulation) from
the fixture to the white wire from the power source.
---Attach the fixture ground wire (bare wire) to the
mounting strap unit (A) with the green ground screw,
then connect it to the house ground wire with the
wire connector (C).
Carefully put all of the wires back into the outlet box.
4. Attach the fixture to the mounting strap unit (A) by inserting
two fixture mounting screw heads into the hole
slots, then secure the bolt nuts (D). (See Fig.1)
Fig.1
Hole Slot
Socket
Bolt Nut
W
W
WARNING: Turn off the main power at circuit breaker before installing fixture.
AVERTISSEMENT: Coupez la source d’alimentation principale au panneau
central de disjoncteurs avant d’installer le luminaire.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Read
and save these instructions.
Hardware Package (included):
Bolt Nut (D)
Mounting Screw (B)
Mounting Strap Unit (A)
Wire Connector (C)
Hex Nut (E)
Hex Nut (E)
Metal Pad (F)
Metal Pad (F)
Rubber Pad (G)
Rubber Pad (G)
Fixture
Socket
Threaded Pipe
Glass Assembly
Max. 60W Type A Bulb
(not included)
Finial (I)
Decorative Cap (H)
Bolt Nut (D)
Outlet Box
House Ground Wire
Wire Connector (C)
Lock Nut
Mounting Strap Unit (A)
Green Ground Screw
Mounting Screw (B)
Fixture Wire
Fixture Mounting Screw
Fixture Ground Wire