2 Conveyor Bread and Bun Toasters Operator’s Manual
FEATURES
OPERATION
NOTICE: The crumb tray must be installed in the toaster during
operation. Failure to install the crumb tray will cause the
toaster to overheat.
Tips
Preheat
1. Plug the toaster into a grounded electrical outlet that matches the
rating on the name plate found on the back of the toaster.
NOTICE: Using a voltage other than the nameplate rated voltage
will cause damage to the unit. Incorrect voltage,
modification to the power cord or electrical components
can damage unit and will void the warranty.
2. Toasters with an adjustable heat shield: Adjust the heat shield so the
tallest bread product can pass below it. Excess space above the
product will create heat loss and may reduce performance.
3. Rotate the power knob to the full power position (I).
4. Set the conveyor speed control knob to 7.
5. Wait 5 minutes for the toaster to preheat.
Test
1. Adjust the settings for the product to be toasted. Test the settings by
placing a sample of the bread items to be toasted onto the feed
ramp.
2. Evaluate the results.
Toast
1. Adjust the conveyor speed as needed.
• Toast too light: Rotate the speed control knob to a lower number
to reduce the speed and darken the toast.
• Toast too dark: Rotate the speed control knob to a higher number
to increase the speed control and lighten the toast.
2. For best performance do not overload the toaster. Wait a few
seconds before loading a second row of bread into the toaster.
If Bread Becomes Stuck
1. Rotate the power knob to the OFF position (O) and unplug the
toaster.
2. Let the toaster cool completely.
3. Use a tong to remove the bread item. Take care to not bump the
glass heating elements above and below the conveyor.
CLEANING
NOTICE: Do not use abrasive materials, scratching cleansers or
scouring pad to clean the exterior of the equipment. These
can damage the finish.
NOTICE: Do not spray controls or outside of equipment with liquids
or cleaning agents.
Daily Cleaning
1. Rotate the power knob to the OFF position (O) and unplug the
toaster.
2. Let the toaster cool completely.
3. Slightly dampen a soft cloth with a warm water.
4. Use the dampened cloth to clean the exterior of the toaster, the air
intake under the toaster, the feed ramp, crumb tray and collection
tray.
5. Press and hold an abrasive pad or brush against the conveyor. Move
the pad or brush back and forth (left to right) across the conveyor to
remove food debris.
PREVENTATIVE MAINTENANCE
Contact an authorized service agent for a professional cleaning of the
components.
A Conveyor Speed Control Knob
B Power Knob
Full Power - maximum heat
Off
Standby - reduces electrical consumption by 75%.
C Heat Shield - Adjustable on the high-clearance toasters
D Feed Ramp
E Crumb Tray
F Collection Pan
G
Reset Button
G
A
B
D
E
F
C
Back View
CAUTION
Burn Hazard
Do not touch the equipment while it is heating or operating.
Hot surfaces can burn skin.
Bread Product Suggestions
Bagels, wheat or rye bread or
products with high moisture content.
Use a slower conveyor speed.
Buttered or coated, such as pastries Not recommended.
Frozen Must be thawed before toasting.
WARNING
Electrical Shock Hazard
Do not spray water or cleaning products. Liquid could contact
the electrical components and cause a short circuit or an
electrical shock.
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
