Waterco Electroheat plus Manual

Waterco Varmepumpe Electroheat plus

Læs gratis den danske manual til Waterco Electroheat plus (36 sider) i kategorien Varmepumpe. Denne vejledning er vurderet som hjælpsom af 32 personer og har en gennemsnitlig bedømmelse på 4.7 stjerner ud af 16.5 anmeldelser. Har du et spørgsmål om Waterco Electroheat plus, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/36
AUSTRALIA
NSW - Sydney (HEAD OFFICE)
Tel : +61 2 9898 8600
VIC/ TAS - Melbourne
Tel : +61 3 9764 1211
WA - Perth
Tel : +61 8 9273 1900
QLD - Brisbane
Tel : +61 7 3299 9900
SA/ NT - Adelaide
Tel : +61 8 8244 6000
CANADA / NORTH-EAST USA
Waterco Canada Inc
Boucherville, Quebec, Canada
Tel : +1 450 748 1421
USA
Waterco USA Inc
Augusta, USA
Tel : +1 706 793 7291
www.waterco.com.au
This web site address will enable you to select the appropriate country website.
NEW ZEALAND
Waterco (NZ) Limited
Auckland, New Zealand
Tel : +64 9 525 7570
EUROPE
Waterco (Europe) Limited
Sittingbourne, Kent. UK
Tel : +44(0) 1795 521 733
CHINA
Waterco (C) Limited
Guangzhou, China
Tel : +8620 3222 2180
MALAYSIA
Waterco (Far East) Sdn. Bhd.
Selangor, Malaysia
Tel : +60 3 6145 6000
(W99341) 10/2021
www.waterco.com.au
Waterco Limited ABN 62 002 070 733
WATERCO POOL HEAT PUMP
WATERCO THERMOPOMPE CHAUFFE-PISCINE
Installation and
Operation Manual
Manuel d’installation
et d’utilisation
This equipment must be installed and serviced by a qualied technician.
Improper installation can create electrical hazards which could result in property damage,
serious injury or death. Improper installation will void the warranty.
Cet équipement doit être installé st réparé par un technicien qualiié.
Une mauvaise installation peut entraîner des risques électriques qui pourraient provoquer
des dommages, des blessures graves ou la mort. Une installation inadéquate annulera la
garantie.
Notice to Installer / Avis à l’installateur
This manual contains important information about the installation, operation and safe
use of this product. Once the product has been installed this manual must be given to
the owner/operator of this equipment.
Ce manual contient des informations importantes sur l’installation, I’exploitation et
l’utilisation sécuritaire de ce produit. Une fois que le produit a été installé, ce manuel doit
être remis à l’acheteur et/ou utilisateur de cet équipement.
FLOW
WARNING
!
ECO-V
IMPORTANT SAFETY INSTRUCTIONS
When using this electrical equipment, basic safety precautions should always be
followed, including the following:
READ AND FOLLOW ALL INSTRUCTIONS
! WARNING: Disconnect all AC power during installation and servicing.
! WARNING: In order to avoid the possibility of hyperthermia (heat stress) occurring
it is recommended the average temperature of the spa - pool water does not exceed
40˚C.
! WARNING: The pool heat pump is not intended for use by persons (including
children) with reduced physical sensory or mental capabilities, or lack of experience
and knowledge, unless they have been provided supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be
supervised to ensure they do not play with the appliance.
• In certain situations unexpected start up may occur when the appliance is in
automatic mode.
• The installer should assess the risk associated with unexpected start-up of this
device which, in any circumstance should have no hazardous effect.
• The pool heat pump is not meant to provide safety protection for other devices.
• The pool heat pump should be deactivated if the pool or spa has been drained.
• Waterco pool heat pumps must be installed by a suitably qualified person in
accordance with current Regulatory Standards, the applicable Wiring Rules
(AS3000) and local statutory authority regulations.
• Parts containing live parts, except parts supplied with safety extra-low voltage not
exceeding 12V, must be inaccessible to a person in the spa – pool.
• Parts incorporating electrical components, except remote control devices, must be
located or fixed so that they cannot fall into the spa – pool.
• The appliance should be supplied through a residual current device (RCD) having
a rated residual operating current not exceeding 30mA.
• An Earth terminal is located inside the wiring enclosure. To reduce the risk of
electric shock, this terminal must be connected to the grounding means provided
in the electric supply service panel with a continuous copper wire as sized to
comply with current Standards and local statutory authorities in relation to the
circuit conductors supplying the equipment.
• A cable connector is provided on this unit to connect a suitably sized copper
conductor between this unit and any metal equipment, metal enclosures of electrical
equipment, metal water pipe, or conduit within 1.5m of the unit via equipotential
bonding.
SAVE THESE INSTRUCTIONS.
Pool Heat Pump I 02
Contents
Table of
IMPORTANT SAFETY INSTRUCTIONS ------------- 02
A NOTE TO YOU --------------------------------------- 03
INSTALLATION INSTRUCTIONS --------------------- 05
Location -------------------------------------------- 05
Installation Clearances --------------------------- 06
Water Piping --------------------------------------- 07
Water Flow Rate ---------------------------------- 07
Water By-pass Kit --------------------------------- 07
Plumbing Diagram -------------------------------- 08
Electrical ------------------------------------------- 09
Electrical Connection ---------------------------- 09
Breaker Size --------------------------------------- 09
Electrical Wire Size ------------------------------- 09
Bonding -------------------------------------------- 10
Bonding Diagram --------------------------------- 10
Remote Control Connections ------------------- 11
Usage Of Chemical Products -------------------- 12
OPERATION OF YOUR POOL HEAT PUMP --------- 13
CONTROLLER TYPES
Initial Heating -------------------------------------- 13
Adjustment Of The Bypass Valves ------------- 13
Pool Heat Pump Running Time ----------------- 14
Pool Solar Blanket -------------------------------- 14
Defrost Cycle -------------------------------------- 14
To Start The Pool Heat Pump ------------------- 15
To Stop The Pool Heat Pump ------------------- 15
To Check and Adjust Temperature
Settings -------------------------------------------- 16
Temperature Calibration ------------------------- 17
To Change Display From Farenheit To
Celcius ---------------------------------------------- 18
Defrost for Electroheat Ultra -------------------- 18
Protection Devices -------------------------------- 18
Codes ----------------------------------------------- 18
INVERTER POOL HEAT PUMP CONTROLLER ----- 19
Inverter Controller Operation ------------------------- 20
Timer Function ------------------------------------ 20
Function Descriptions ---------------------------- 21
Buzzer ---------------------------------------------- 21
Memory Function --------------------------------- 21
MAINTENANCE OF YOUR POOL HEAT PUMP ----- 22
Cabinet Cleaning --------------------------------------- 22
Cleaning Evaporator ----------------------------------- 22
Cleaning drainage holes ------------------------------- 22
Units Located In Coastal Locations ------------------ 22
Winterising Procedure --------------------------------- 23
GENERAL SAFETY INSTRUCTIONS -----------------24
TROUBLESHOOTING -----------------------------------25
Nothing Is Working and The
Electronic Control Does Not Operate ---------- 25
Nothing Is Working But The Electronic
Control Temperature Displays Digits
or a Code ------------------------------------------- 25
Fan Doesn’t Work (the fan blades
are not moving) -----------------------------------25
Fan Blades Turn, But Compressor Is Not
Functioning ---------------------------------------- 26
Compressor Starts and Stops ------------------- 26
There Is Water Around The Pool Heat
Pump ------------------------------------------------ 26
Pool Heat Pump Has Ice Formed On The
Evaporator Coil ------------------------------------ 27
Pool Heat Pump Is Functioning, But Does
Not Reach The Desired Temperature
Setting ---------------------------------------------- 27
Analysis Chart ------------------------------------- 28
Circuit Breaker Trips ------------------------------ 28
The Pool Heat Pump Is Noisy ------------------- 29
The Temperature Shown On Pool Heat
Pump Is Not The Same That Is
Shown By The Pool Thermometer -------------- 29
Service Analyser Codes
(Standard Models) -------------------------------- 30
WARRANTY --------------------------------------------- 35

Produkt Specifikationer

Mærke: Waterco
Kategori: Varmepumpe
Model: Electroheat plus

Har du brug for hjælp?

Hvis du har brug for hjælp til Waterco Electroheat plus stil et spørgsmål nedenfor, og andre brugere vil svare dig


Varmepumpe Waterco Manualer

Waterco

Waterco Electroheat ECO-V Manual

1 September 2024
Waterco

Waterco Hydrostar Plus Manual

1 September 2024
Waterco

Waterco Hydrostar MK4 Manual

1 September 2024
Waterco

Waterco Electroheat plus Manual

1 September 2024
Waterco

Waterco Electroheat MKV Manual

1 September 2024
Waterco

Waterco Hydrostar MK3 Manual

23 Maj 2024

Varmepumpe Manualer

Nyeste Varmepumpe Manualer

Tesy

Tesy EV 2x12 S 200 60 HP Manual

29 September 2025
Steinbach

Steinbach Waterpower 5000 Manual

29 September 2025
Tesy

Tesy V 15/9 S2 1000 95 EV 200 45 C Manual

28 September 2025
Hotpoint

Hotpoint 1H12HN2DAA Manual

11 September 2025
Mitsubishi

Mitsubishi RC-MCU-E Manual

11 September 2025
Hotpoint

Hotpoint 1H18HN2DAA Manual

11 September 2025
Electrolux

Electrolux TD6-20 Manual

9 September 2025
Electrolux

Electrolux TD6-7 Manual

9 September 2025
Electrolux

Electrolux TD6-11 Manual

9 September 2025
Wolf

Wolf CWL-T-300 Manual

8 September 2025