Whale Aquasource WF1230 Manual

Whale Pomp Aquasource WF1230

Læs gratis den danske manual til Whale Aquasource WF1230 (4 sider) i kategorien Pomp. Denne vejledning er vurderet som hjælpsom af 31 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 16 anmeldelser. Har du et spørgsmål om Whale Aquasource WF1230, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Aquasource Clear Water Filter

12mm & 15mm

Ensure all relevant personnel read the points listed

below and that a copy is passed on to the end user.

Read the points listed below before installation and

use of equipment.

Aquasource Clear is a silverised carbon filter which

provides fresh clear drinking, helping remove bad

tastes and odours. It also boasts the following;

- Silverised carbon filter inhibits bacteria growth.

- Is suitable for caravans and boats (maximum

working pressure is 4 bar/ 60 PSI).

- No maintenance is required.

- Aquasource Clear filters have grooved 12mm

(WF1230) or grooved 15mm (WF1530),

inlet/outlet for use with various pipe

systems, see Plumbing Guide below.

- Supplied with mounting clips for wall mounting.

- Slim and compact for installing in confined

spaces.

- Simple installation.

Plumbing Guide

Please consider the environment when disposing of

the old filter and the packaging.

Do not allow the filter to stay in your system for more

than one year. The recommended usage for the

Aquasource Clear Filter is one season or 4500 litres,

whichever is shorter.

Pipe System Used Fittings required Model No.

12mm semi-rigid Connects directly using Whale Quick Connect 12mm fittings WF1230

15mm semi-rigid Connects directly using Whale Quick Connect 15mm fittings WF1530

3/8” (10mm) bore flexible hose Stainless stell hose clips WF1230

1/2” (13mm) bore flexible hose Stainless stell hose clips WF1530

To the Fitter

To the User

Application

Installation

Warnings

Flushing and Installation Procedure

The filter replacement must be carried out under

hygienic conditions.

As the flushing out process of a new filter can use

a lot of water, it is recommended that the filter is

flushed clean of any black loose particles

(shaking the filter from time to time to agitate the

contents within the filter), at a domestic fresh

water tap before installing. (Approximately 10

minutes under a flowing water tap, longer if

required, until the particles are all removed).

Once this has been achieved, fully drain down the

water system, and turn off the pump at the

isolation switch.

Disconnect the old filter from the system, either

by disconnecting the Quick Connect fittings, or

alternatively remove the jubilee clips if fitted.

Install the new Aquasource Clear water Filter,

making sure all the connection fittings are tightly

secured. N.B. Check the directional flow arrow

when installing.

Turn on the pump, and recharge the water

system.

Should the filter need replacing on site (using the

vehicle’s water source):

Install the new filter as described above.

N.B. Check the directional flow arrow when

installing.

Pass approximately 20 litres of water through the

filter.

Turn off the pump, and allow the system to settle.

Pass approximately a further 20 litres of water

through the filter. Further flushing may be

required until all the particles have been removed.

Select a location for the filter and cut the hose/

pipe to the appropriate size.

Take end caps off filter and push one end into

each connector taking care that the water will flow

in the direction of the arrow.

If you wish to fix the filter to the wall, use the

mounting clips and screws provided.

When the filter is installed allow water to run

through it for at least 30 seconds to flush out any

black loose particles until water runs clear.

Write the date of installation in the space provided

to enable you to remember when to change it.

Your filter is now ready for use.

Mounting Clips

(Supplied)

Hose Clip

Incorrect installation of

filter

Xü

Hose Clip

Correct installation

of filter

Reproduction in whole or in part without permission is prohibited. WHALE® and Watermaster® are registered trademarks of

Munster Simms Engineering Limited, Bangor, Northern Ireland trading as Whale. Whale’s policy is one of continuous

improvement and we reserve the right to change specifications without prior notice. Illustrations are for guidance purposes

only.

Please note that by contacting Whale Support you will be indicating your consent to receiving product updates, recall

information, help guides and appropriate marketing messages from us via post, email or telephone unless you indicated an

objection to receiving such messages.

Widest diameter

50mm

12mm (WF1230) or

15mm (WF1530)

Connection

Munster Simms Engineering Ltd.

2 Enterprise Road, Bangor, N. Ireland BT19 7TA Tel: +44 (0)28 9127 0531

Web: www.whalepumps.com Email: info@whalepumps.com Ref No. 181.11_v5_0516_sr_db

Produkt Specifikationer

Mærke:	Whale
Kategori:	Pomp
Model:	Aquasource WF1230

Har du brug for hjælp?

Hvis du har brug for hjælp til Whale Aquasource WF1230 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Pomp Whale Manualer

Whale Aquasource WF1530 Manual

1 August 2024

Whale Gulper 220 Manual

21 Juli 2024

Whale Aquasource WF1230 Manual

18 Juli 2024

Pomp Manualer

Nyeste Pomp Manualer

Little Giant OPWG-29 Manual

1 April 2025

Interphone Air Pump 3000 Manual

1 April 2025

Grundfos UPS 20-60 N 150 Manual

1 April 2025

Grundfos UPS 40-50 FN 250 Manual

1 April 2025

Grundfos MTA 120-280 Manual

1 April 2025

Grundfos DMX 860-5 Manual

1 April 2025

Grundfos UPM4 Manual

1 April 2025

Grundfos DMH 880-10 Manual

1 April 2025

Grundfos MTA 200-280 Manual

1 April 2025

Grundfos MTSE 40-66 Manual

1 April 2025