Whale Aquasource WF1530 Manual

Whale Pomp Aquasource WF1530

Læs gratis den danske manual til Whale Aquasource WF1530 (4 sider) i kategorien Pomp. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Whale Aquasource WF1530, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/4
Aquasource Clear Water Filter
12mm & 15mm
Ensure all relevant personnel read the points listed
below and that a copy is passed on to the end user.
Read the points listed below before installation and
use of equipment.
Aquasource Clear is a silverised carbon filter which
provides fresh clear drinking, helping remove bad
tastes and odours. It also boasts the following;
- Silverised carbon filter inhibits bacteria growth.
- Is suitable for caravans and boats (maximum
working pressure is 4 bar/ 60 PSI).
- No maintenance is required.
- Aquasource Clear filters have grooved 12mm
(WF1230) or grooved 15mm (WF1530),
inlet/outlet for use with various pipe
systems, see Plumbing Guide below.
- Supplied with mounting clips for wall mounting.
- Slim and compact for installing in confined
spaces.
- Simple installation.
1.
2.
3.
4.
5.
6.
Plumbing Guide
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
Please consider the environment when disposing of
the old filter and the packaging.
Do not allow the filter to stay in your system for more
than one year. The recommended usage for the
Aquasource Clear Filter is one season or 4500 litres,
whichever is shorter.
Pipe System Used Fittings required Model No.
12mm semi-rigid Connects directly using Whale Quick Connect 12mm fittings WF1230
15mm semi-rigid Connects directly using Whale Quick Connect 15mm fittings WF1530
3/8” (10mm) bore flexible hose Stainless stell hose clips WF1230
1/2” (13mm) bore flexible hose Stainless stell hose clips WF1530
To the Fitter
To the User
Application
Installation
Warnings
Flushing and Installation Procedure
The filter replacement must be carried out under
hygienic conditions.
As the flushing out process of a new filter can use
a lot of water, it is recommended that the filter is
flushed clean of any black loose particles
(shaking the filter from time to time to agitate the
contents within the filter), at a domestic fresh
water tap before installing. (Approximately 10
minutes under a flowing water tap, longer if
required, until the particles are all removed).
Once this has been achieved, fully drain down the
water system, and turn off the pump at the
isolation switch.
Disconnect the old filter from the system, either
by disconnecting the Quick Connect fittings, or
alternatively remove the jubilee clips if fitted.
Install the new Aquasource Clear water Filter,
making sure all the connection fittings are tightly
secured. N.B. Check the directional flow arrow
when installing.
Turn on the pump, and recharge the water
system.
Should the filter need replacing on site (using the
vehicle’s water source):
Install the new filter as described above.
N.B. Check the directional flow arrow when
installing.
Pass approximately 20 litres of water through the
filter.
Turn off the pump, and allow the system to settle.
Pass approximately a further 20 litres of water
through the filter. Further flushing may be
required until all the particles have been removed.
Select a location for the filter and cut the hose/
pipe to the appropriate size.
Take end caps off filter and push one end into
each connector taking care that the water will flow
in the direction of the arrow.
If you wish to fix the filter to the wall, use the
mounting clips and screws provided.
When the filter is installed allow water to run
through it for at least 30 seconds to flush out any
black loose particles until water runs clear.
Write the date of installation in the space provided
to enable you to remember when to change it.
Your filter is now ready for use.
Mounting Clips
(Supplied)
Hose Clip
Incorrect installation of
filter
Xü
Hose Clip
Correct installation
of filter
©Copyright Whale® 2016 - All rights reserved.
Reproduction in whole or in part without permission is prohibited. WHALE® and Watermaster® are registered trademarks of
Munster Simms Engineering Limited, Bangor, Northern Ireland trading as Whale. Whale’s policy is one of continuous
improvement and we reserve the right to change specifications without prior notice. Illustrations are for guidance purposes
only.
Please note that by contacting Whale Support you will be indicating your consent to receiving product updates, recall
information, help guides and appropriate marketing messages from us via post, email or telephone unless you indicated an
objection to receiving such messages.
Widest diameter
50mm
12mm (WF1230) or
15mm (WF1530)
Connection
Munster Simms Engineering Ltd.
2 Enterprise Road, Bangor, N. Ireland BT19 7TA Tel: +44 (0)28 9127 0531
Web: www.whalepumps.com Email: info@whalepumps.com Ref No. 181.11_v5_0516_sr_db

Produkt Specifikationer

Mærke: Whale
Kategori: Pomp
Model: Aquasource WF1530

Har du brug for hjælp?

Hvis du har brug for hjælp til Whale Aquasource WF1530 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Pomp Whale Manualer

Whale

Whale Aquasource WF1530 Manual

1 August 2024
Whale

Whale Gulper 220 Manual

21 Juli 2024
Whale

Whale Aquasource WF1230 Manual

18 Juli 2024

Pomp Manualer

Nyeste Pomp Manualer

Little Giant

Little Giant OPWG-29 Manual

1 April 2025
Interphone

Interphone Air Pump 3000 Manual

1 April 2025
Grundfos

Grundfos UPS 20-60 N 150 Manual

1 April 2025
Grundfos

Grundfos UPS 40-50 FN 250 Manual

1 April 2025
Grundfos

Grundfos MTA 120-280 Manual

1 April 2025
Grundfos

Grundfos DMX 860-5 Manual

1 April 2025
Grundfos

Grundfos UPM4 Manual

1 April 2025
Grundfos

Grundfos DMH 880-10 Manual

1 April 2025
Grundfos

Grundfos MTA 200-280 Manual

1 April 2025
Grundfos

Grundfos MTSE 40-66 Manual

1 April 2025