Winegard AP8700 Manual

Winegard TV signal booster AP8700

Læs gratis den danske manual til Winegard AP8700 (2 sider) i kategorien TV signal booster. Denne vejledning er vurderet som hjælpsom af 13 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 7 anmeldelser. Har du et spørgsmål om Winegard AP8700, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

Fig. 2

Fig. 1

Fig. 3

SINGLE INPUT MODELS

Chromstar® 2000

Antenna Preampliers

INSTRUCTIONS

Models AP-2870 & AP-2880 Dual Input, 82 Channel

Models AP-8275, AP-8700 & AP-8780, AP-8800, & HDP-269 82 Channel

Models AP-4700 & AP-4800 UHF Only

Models AP-3700 & AP-3800 VHF Only

WARNING: TO PREVENT FIRE OR SHOCK HAZARD,

DO NOT EXPOSE POWER SUPPLY SECTION OF THIS

APPLIANCE TO RAIN OR MOISTURE.

NOTE

If FM interference is a problem in your area, it is recom-

mended that you temporarily hook up the preamplier near

the TV for ease of tuning the variable FM trap.

NOTE

The further the preamplier from the antenna(s), the lower

the input signal.

STEP 2. Slide weather boots over the antenna downlead(s) and

attach connectors. See Figure 2.

STEP 3. Attach the antenna downlead(s) to antenna(s) and other

end(s) to preamplier, leaving a sufcient slack in the cable(s)

to form a drain loop. See Figure 3.

STEP 4. Slide the weather boots over the cable connector(s)

and boot collar(s) on the preamplier and antenna(s).

STEP 5. The 75 ohm coaxial downlead may be secured to the

mast with weatherproof tape or cable ties.

STEP 6. Attach “F” connector on downlead cable from preamp

to Power Injector jack marked “ANT”. See gure 4.

STEP 7. Attach “F” connector on cable from DTV, Digital

Converter box, Distribution Amplier, or splitter system to jack

on Power Injecter marked TV. See gure 4.

STEP 8. Connect one “F” connector on supplied black RG-6

cable to jack on Power Injecter marked “PWR IN”. Connect

the other “F” connector on supplied RG-6 cable to jack on

supplied AC Adapter (Wall Transformer). See Figure 4.

STEP 9. Mount power injector to wall using supplied screws.

Plug in AC Adapter (Wall Transformer) into household wall

outlet.

PREAMPLIFIER INSTALLATION

STEP 1. Mount the preamplier on the mast within easy reach.

See Figure 1.

MADE IN U.S.A.

WINEGARD®

SUPPORT

PLATE

HEX NUT

MAST

U-BOLT

300 OHM DOWNLEAD

HOUSING

PREAMPLIFIER

MAST

CLAMP

TO POWER

SUPPLY

75 OHM COAXIAL

DOWNLEAD

DRAIN LOOP

ANT.

INPUT

75 OHM COAXIAL

DOWNLEAD

TO POWER

SUPPLY

MAST

CLAMP

PREAMPLIFIER

UHF

INPUT

DRAIN LOOP

VHF

INPUT

CONNECTORS

WEATHER

BOOTS

DUAL INPUT MODELS

Fig. 4

AC ADAPTOR

(SUPPLIED)

6’ STANDARD

COAX CABLE

(SUPPLIED)

COAX CABLE TO

DIGITAL TV, DIGITAL

CONVERTER BOX,

DISTRIBUTION AMP,

OR SPLITTER (SYSTEM)

LED

POWER IN

ANT.

DOWNLEAD COAX CABLE FROM

PREAMP OR AMPLIFIED ANTENNA

POWER

INJECTOR

Printed in U.S.A. • Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601-2000 • © Winegard Company, 2006 2451964 Rev. 1/12/09

CONSUMER 90 DAY WARRANTY

The Winegard Company warrants this Winegard product against any defects in materials or workmanship within 90 (ninety) days from date of

purchase. No warranty claim will be honored unless at the time the claim is made, you present proof of purchase to an authorized Winegard dealer

(if unknown, please contact Winegard Company, 3000 Kirkwood Street, Burlington, IA 52601-2000, telephone 800-288-8094).

Winegard Company (at its option) will either repair or replace the defective product at no charge to you. This warranty covers parts, but does not

cover any costs incurred in removal, shipping or reinstallation of the product. The warranty does not extend to products which have been subjected

to misuse, improper installation, or to damage caused by wind, lightning, ice or other occurrences over which the manufacturer has no control.

The 90 Day Warranty is provided on the condition that the equipment is properly delivered with all handling and freight charges prepaid to your

Winegard dealer for return to our factory for repair or replacement. Winegard dealers will arrange for the replacement or repair and return to you

without charge the product which failed due to defective material or workmanship.

WINEGARD COMPANY WILL NOT ASSUME ANY LIABILITIES FOR ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE BY ANY

OTHER PERSON.

ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR

PURPOSE AND MERCHANTABILITY ARE LIMITED TO THE 90-DAY PERIOD OF THIS WARRANTY.

The foregoing shall be the sole and exclusive remedy of any person, whether in contract, tort or otherwise, and Winegard shall not be liable for

incidental or consequential damage or commerical loss, or from any other loss or damage except as set forth above.

Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of limitation of incidental or consequential damages,

so the above limitations or exclusions may not apply to you.

This warranty gives you specic legal rights and you may also have other rights which vary from state to state. Rev. 2/08

FM TRAP OPERATION (Not applicable to Models AP-4700, AP-4800, or HDP-269)

The preamplier features two FM traps, one xed and the other variable. The preamplier is shipped with the xed FM in the “FIXED

TRAP IN” position and the variable FM trap tuned out of the FM band (about 108 MHz). See Figure 5.

If FM reception is desired, move the FM trap switch to the “FIXED TRAP OUT” position.

FM interference is indicated by “herringbone” patterns appearing on any VHF channel (2 through 13). If this interference is present,

verify the FM trap is in the “FIXED TRAP IN” position. If interference is still present, turn the “VARIABLE FM TRAP” screw very slowly

while observing the TV channel with the greatest interference until the picture clears. See Figure 5.

The variable FM trap can also be used with the xed FM trap in the “FIXED TRAP OUT” position. This allows you to receive FM and

tune out a specic FM station that is causing interference. This is performed the same as the proceeding paragraph except the FM trap

is in the out position.

SPECIFICATION : 14 Volts Nominal at 130 Milliamps Max.

NOTE: This power supply is equipped with a Polyswitch. If there is a short between the preamp and the power supply, it will

shut the power supply off until the short is removed.

APPLY LABEL

NOTE: A label is supplied so you can enter the

installation date and record the frequency the vari-

able trap is tuned to. Once tuning is complete, apply

the label to the bottom of the preamplier to seal

openings. See gure 5. For models without traps,

apply the label to the bottom of the preamplier to

seal openings.

TIPS:

If splitting the signal to multiple TVs or combining with another signal source, it is strongly recommended that the power injector be

installed between the preamplifer and the splitter/combiner input. In this case, the cable connection from the “TV” jack of the power

injector goes to the splitter input or valid combiner input. Use splitters rated from 54-806 MHz or wider bandwidth (commonly 5-1000

MHz) for over-the-air television signal distribution.

Additional distribution/inline ampliers must be installed FOLLOWING the TV output of the power injector, NOT on the downlead cable

line connecting to the ANTENNA port. Check TV picture quality, if the power injector LED is glowing when powered, and antenna

alignment prior to adding additional line ampliers.

To maximize the operating life of the amplier, install the power injector close to the TV receiver (if only one will be used with the

antenna) or the rst signal splitter. A maximum preamp-to-power injector length of 150 feet RG-6 or 150 feet RG-59 is acceptable.

APPLY LABEL AFTER TUNING

FIG. 5

DUAL

INPUT

UHF

ANT.

VHF

ANT.

FIXED TRAP OUT

VARIABLE

FM TRAP

FIXED TRAP IN

POWER

SUPPLY

WINEGARD COMPANY

BURLINGTON, IOWA

Produkt Specifikationer

Mærke:	Winegard
Kategori:	TV signal booster
Model:	AP8700
Produktfarve:	Sort
Frekvensområde:	88 - 108 MHz
Indgangsspænding:	120 V
Forstærkning:	19 dB
Støjtal:	2.8 dB