XYZprinting RF10BXEU08A Manual

XYZprinting Ikke kategoriseret RF10BXEU08A

Læs gratis den danske manual til XYZprinting RF10BXEU08A (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om XYZprinting RF10BXEU08A, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

Filament Replacement Instructions

Take out the stopper by

rotating anti-clockwise.

Remove the stopper Lift the cartridge Change the lament

and chip

Close the cartridge

Screw in the stopper

tightly

Take out the accessories

from the lament cartridge

and replace them with new

accessories.

A. Filament parameter chip

B. Filament

C. Desiccant pouch

Press the joint of the casing

of the lament cartridge

gently and open it.

Put a new filament parameter

chip in place. Make sure it is

placed in the correct direction.

Reassemble the cartridge

and pull the lament to

make sure it is discharged

smoothly.

Replace the stopper and

screw it up clockwise.

Turn the cartridge over

and make sure the

stopper has been

tightened to its position.

Put a new desiccant pouch

in place.

Direct the lament through

the guide hole to put out

the lament easily.

1-1

1-2

2-1 3-1 4-1

4-2

5-1

5-2

3-3

2-2

345

Note

1. Do not use the filament cartridge in an environment with heavy dust or high humidity.

2. Unsealed filament kit must be used as soon as possible to ensure good printing quality.

3. If product is defective out of the box, please contact customer service and return the filament and parameter

chip with the original packing for exchange.

3-2

Produkt Specifikationer

Mærke:	XYZprinting
Kategori:	Ikke kategoriseret
Model:	RF10BXEU08A
Vægt:	600 g
Antal pr. pakke:	1 stk
Pakkevægt:	1000 g
Udskrivning af farver:	Orange
Pakketype:	Kasse
Diameter:	1.75 mm
Harmoniseret systemkode (HS):	84779080
Kapabilitet:	da Vinci
Mærke kompatibilitet:	XYZprinting
Printemateriale:	ABS
Glasovergang temperatur (min.):	70 °C
Glasovergang temperatur (maks.):	90 °C
Dysse temperatur:	210 °C