Yepp Mini Manual

Yepp Cykelsæde Mini

Læs gratis den danske manual til Yepp Mini (4 sider) i kategorien Cykelsæde. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om Yepp Mini, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

Installation instructions for the Yepp® Mini

The Yepp Mini is suitable for carrying children up to a maximum weight of 15 kg (about 3 years old)

and meets European standard EN 14344. Do not use the seat if your child can’t sit upright, at least

for the time of the journey.

The Yepp Mini with its stem adapter is suitable for common bicycles with 26 or 28 inch wheels and

a round steel stem with diameter of 21 - 28 mm.

Installation:

Assemble the seat (pic.1). Tighten both hexagon screws firmly tight (torque 4Nm).

Attach the handlebar stem fitting to the handlebar (pic.3). Tighten both Hexagon screws

firmly tight (torque 8Nm).

If you have a Ahead type handlebar system, you can use our special Ahead adapter (art.

020402).

The Yepp Mini is attached in two stages. Press the red button on the bottom and pull

simultaneously the grey handle to the rear (pic.4a). Position the seat over the lip on the

clamp. Release the slide and push the seat straight down until it clicks into place (pic.4b).

This means that the seat is secured automatically. Check this by pulling the seat upwards. If

it’s secured properly, you will not be able to pull it out.

For additional safety, always lock the seat (pic.4a). Make a note of the key number so you

can get a replacement if the original key is lost.

To remove the seat, perform the above actions in reverse order (pic.8a+b).

Place your child in the seat and position the footrests to the correct height (pic.6). Connect

the straps once the footrests are in the correct position.

Close the 5-point harness and adjust it to the correct length (pic.7). To open the buckle:

press both halves of the clip in and push both sides at the same time.

Instructions for use:

Make a test ride, without your child, to see of everything is mounted correctly and the seat

does not affect the cycling and everything is still functioning.

Always close the straps. Make sure your child is not able to remove its feet, but be sure the

child is not hurt if they are too tight.

Cleaning of the Yepp Mini is simple: clean with lukewarm soapy water. Never use aggressive

cleaning agents.

If you have any doubts regarding the assembly of this seat on your bicycle, we recommend

you obtain further information from your bicycle dealer.

Warnings and Safety advices:

WARNING! Never modify the seat yourself.

Always remove the seat when putting the cycle on a cycle carrier on a car.

WARNING! Do not use the seat if any part of it is faulty. Any broken part must be

replaced immediately. Consult your dealer.

WARNING! Never leave your child unattended in the seat.

WARNING! Note that cycling with a child in a child seat can affect the way the cycle

behaves, especially when going round corners and when riding off. Use the Yepp Mini only on

bicycles that are suitable for carrying the extra load. Check the manual of the bicycle or ask

the bicycle manufacturer for advice.

WARNING! Never carry bags or other luggage in the seat. If you will carry additional loads,

they should be placed at the opposite site of the bicycle, for instance when you use a front

seat you should place the luggage on the rear luggage carrier.

Check after assembling if all fasteners are tightened properly and everything functions correct.

Make sure that the Yepp Mini is locked at all times by turning the anti-theft lock in the in

"lock" position with the adjunct key (pic.7b). This is safe and prevents possible theft of your

Produkt Specifikationer

Mærke:	Yepp
Kategori:	Cykelsæde
Model:	Mini
Vandfast:	Ja
Maksimal bruger vægt:	15 kg
Fodskammel:	Ja
Justerbar fodstøtte:	Ja
Sikkerhedssele:	Ja
Monteringsstil:	Bagbeslag