Zagg Rugged Book Go Manual

Zagg Ikke kategoriseret Rugged Book Go

Læs gratis den danske manual til Zagg Rugged Book Go (26 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 68 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 34.5 anmeldelser. Har du et spørgsmål om Zagg Rugged Book Go, eller vil du spørge andre brugere om produktet?

Side 1/26
Keyboard Instructions
rugged book go
*WARRANTY REGISTRATION
Your ZAGG Rugged Book Go comes with a one-year manufacturer’s warranty. In order to activate
the warranty, you must register your Rugged Book Go as well as keep your purchase receipt. If you
purchased your ZAGG Rugged Book Go from ZAGG.com, ZAGG has already registered it and has a
copy of your proof of purchase.
NEED MORE HELP? PLEASE SEE OUR FAQ SECTION AT: www.ZAGG.com/faq
See the important Health and Safety information on page 7 before using this product.
INSERTING/REMOVING YOUR DEVICE
DETACHING THE CASE FROM THE KEYBOARD
1. Hold your device in landscape mode with the volume control
buttons facing up. Insert the top half of your device at an angle
into the top of the case and apply light pressure to snap it snuggly
into place.
2. At the top of the keyboard, there is a hinged magnetic bar with
two long teeth at either end. At the bottom of the case, you’ll see
two long slots that will fit the teeth on the magnetic hinge bar.
Line the slots up with the teeth and lower the case face down onto
the keyboard. You will feel the powerful magnetic bar engage and
attach the keyboard and case.
3. You can now open the case and adjust the kickstand on the back
to support your tablet at an ideal viewing angle.
4. To easily remove your device from the case, first detach the case
from the keyboard. (See directions below.) Then hold the top of
the case with one hand and press against the back of the case with
the other. Then grasp the exposed side of your device and lift/pull
it away from the cover.
Hold one of the top corners of the keyboard in one hand, hold the
corresponding top corner of the case with the other hand, and pull the
case back away from the keyboard. This will disengage the magnets
holding the keyboard and case together.
POWERING ON AND OFF
1. To turn your Rugged Book Go on, press the Power button
located at the top right corner of the keyboard. A green LED will
light briefly.
2. To turn your Rugged Book Go o, press and hold the Power button
for three seconds. A red LED will flash indicating it has turned o.


Produkt Specifikationer

Mærke: Zagg
Kategori: Ikke kategoriseret
Model: Rugged Book Go

Har du brug for hjælp?

Hvis du har brug for hjælp til Zagg Rugged Book Go stil et spørgsmål nedenfor, og andre brugere vil svare dig