American Dryer GX1-M Manual

American Dryer Håndstoffer GX1-M

Læs gratis den danske manual til American Dryer GX1-M (2 sider) i kategorien Håndstoffer. Denne vejledning er vurderet som hjælpsom af 18 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 9.5 anmeldelser. Har du et spørgsmål om American Dryer GX1-M, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

1 7/8

DISCONNECT POWER BEFORE INSTALLING

DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES

WARNING:

INSTALLATION INSTRUCTIONS

1. Remove cover by removing (2) tamper proof-screws using security wrench

supplied. Pull cover directly toward you. IMPORTANT: Save security wrench.

2. Dryers should be placed at least 2 feet (61cm) apart and at least 12” (30cm) from

washbasin. Do not install dryer over washbasin. Automatic dryers should be at least

18” (46cm) above any projection which may interfere with the operation of the auto-

matic sensor.

Hold the backplate to the wall at the suggested mounting height. Measure from bot-

tom edge of to the backplate floor (Ref. Dimension “A”, Fig. 1):

CHILDREN

MEN WOMEN (depends on age) DISABLED

44” (112cm) 42” (107cm) 32 to 42” (81-107cm) 36” (91cm)

3. Mark the locations of the four mounting holes and the conduit entrance location on the

wall. (The conduit entrance is the proper hole diameter for 1/2 inch (13mm) conduit.)

4. Fasten the backplate to the wall where previously marked.

RECOMMENDATION:

Wood wall – No. 14 (M6) wood screws, 2 3/4” (70mm) long

Cement or brick – 1/4” (M6) stud expansion bolts, 3” (76mm) long

Hollow wall – 1/4” (M6) toggle bolts, length depends on wall thickness

5. Run service wire to the dryer location and connect to lead wires.

IMPORTANT: All units must be supplied with 3 wire service. Use No. 12 or 14 wire

as required by local electrical code. The ground wire must be connected to the dryer

ground screw. Unit must be installed by a qualified licensed electrician.

CONNECT TO A DEDICATED CIRCUIT NOT TO ExCEED 20 AMPS.

Dryers located in shower rooms or other wet locations should be equipped with

ground fault interrupter(s).

6. Carefully replace the cover using (2) tamper-proof screws supplied. Apply a bead of

caulk around edges of cover to wall.

GLOBAL DRYER

MFD by AMERICAN DRYER, INC.

33067 INDUSTRIAL ROAD, LIVONIA, MI 48150, U.S.A.

Telephone (734) 421-2400 • Fax (734) 421-5580

www.americandryer.com • Email: sales@americandryer.com

Revised November 2011

GLOBAL DRYER LIMITED WARRANTY

All parts of the models are warranted to the original consumer purchaser Gx-M/C

to be free from defects in material and workmanship for a period of five (5) years or

three (3) years for models from the date of purchase from manufacturer. Sensor Gx

warranty three (3) years in the U.S.A. All models outside of the U.S.A., one (1) year

including sensor. We will replace FREE OF CHARGE, during the warranty period, any

warranted part which proves defective in material and/or workmanship under normal

installation, use, and service, excluding normal wear. Replacement parts can be

obtained by returning the part, TRANSPORTATION CHARGES PREPAID. You must

notify factory prior to returning part or dryer. Any damage to this dryer as a result of

misuse, abuse, neglect, accident, improper installation, unauthorized repairs, or any

other use violative of instructions furnished by us, WILL VOID THIS WARRANTY.

THIS LIMITED WARRANTY IS THE SOLE WARRANTY ON OUR PRODUCTS, AND

WE DISCLAIM AND EXCLUDE ANY AND ALL OTHER WARRANTIES, EXPRESS

OR IMPLIED, INCLUDING ANY IMPLIED WARRANTIES OF MERCHANTABILITY

OR FITNESS FOR A PARTICULAR PURPOSE. OUR LIABILITY SHALL NOT EXCEED

IN ANY EVENT THE REPLACEMENT OR SALE PRICE OF THE ALLEGEDLY

NONCONFORMING PRODUCT AND SHALL EXCLUDE LABOR CHARGES. TO

THE EXTENT PERMITTED BY LAW WE SHALL NOT BE LIABLE FOR ANY LOSS,

COST, EXPENSE, OR INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY

KIND, WHETHER BASED UPON WARRANTY (EXPRESS OR IMPLIED), CONTRACT,

NEGLIGENCE OR STRICT LIABILITY AND ARISING IN ANY WAY IN CONNECTION

WITH THE DESIGN, MANUFACTURE, SALE, USE OR REPAIR OF THE PRODUCT.

O ’ M wner s anual GX Series Hand Dryers

F Ior nstallatIon or ervIce s

assIstance lease all P c

(734) 421-2400 or

Email: sales@americandryer.com

ImPortant: Have odel erial o eady M & S N . r

m #______ s #______odel erIal

F d Migure 1 - ryer ouNtiNg

(48mm)

(208mm)

6 3/16

7/8 (22mm) DIA. IN-WALL

& SURFACE CONDUIT

ENTRANCES

MOUNTING HOLES FOR

1/4” (M6) DIA. SCREWS

(227MM)

8 15/16

7/16

(11mm)

“A”

8 7/16

(214mm)

FLOOR

7/16

(11mm)

SERVICE AND MAINTENANCE OF YOUR DRYER

GENERAL OPERATION

This dryer is activated by an infrared sensor. The dryer operates as long as hands are below

nozzle. There is a maximum 60 second running time with a safety over-ride feature, if hands

are not removed. Each component used in your dryer has been designed to provide years of

trouble-free service. However, if trouble should develop, it can normally be located by visual

examination. Removal or replacement of most parts, is simple and can be done without

special tools.

IF THE DRYER WON’T TURN ON:

Check electrical service, circuit breaker. Make sure proper voltage is being supplied to the

dryer. Check for loose or disconnected terminal to sensor. INCREASE sensitivity (

FIgure 3)

by using a flat-blade screwdriver and CAREFULLY turning the adjustment pot located on the

sensor CLOCKWISE 1/3 Turn MAx. If necessary, replace sensor.

IF DRYER WILL NOT SHUT OFF:

Make certain black foam is attached to lens and lens is clean. If damaged, replace.

DECREASE sensitivity (FIgure 3) by CAREFULLY turning the adjustment pot located on

the sensor. Use a small flat-blade screwdriver. 1/3 Turn MAx. COUNTER-CLOCKWISE. If

necessary, replace sensor.

IF COLD AIR IS COMING FROM THE NOZZLE:

Turn off breaker for 30 seconds to reset thermostat. If required. remove the cover and vent,

check the heating element. If the element is broken or burned out, replace it.

IF NO AIR IS COMING FROM THE NOZZLE AND HEATING ELEMENT GLOWS:

Remove the cover and check to see that the fan revolves freely. Check and replace motor,

if required.

FOR ANY OTHER PROBLEM, CONTACT FACTORY FOR ASSISTANCE.

CLEANING - DO NOT spray cleaning solvents thru dryer vents. DO NOT use abrasive,

chlorinated, or highly alkaline cleaners. DO NOT use oil based cleaners.

SEMI-ANNUALLY remove the cover and clean all lint and dust from the mechanism, inside

of cover, and plastic window.

Clean cover with a mild soap or detergent and warm water, using a soft cloth or sponge.

PARTS LIST FOR YOUR DRYER (Figure 2)

ITEM PART NO. DESCRIPTION

1 GX202 COVER, WHITE ABS

(MUST SPECIFY DRYER MODEL #)

2 GX202-M COVER, WHITE STEEL

(MUST SPECIFY DRYER MODEL#)

3 GX202-BG COVER, BLACK GRAPHITE STEEL

(SPECIFY DRYER MODEL#)

4 GX202-C COVER, CHROME PLATED STEEL

(SPECIFY DRYER MODEL #)

5 GX212 VENT ASS’Y W/ LENS AND FOAM GASKET

6 GX216 MOTOR, 110-120V INCLUDES BLOWER WHEEL (GX1)

7 GX217 MOTOR, 208-240V INCLUDES BLOWER WHEEL (GX3)

8 GX218 HEATING ELEMENT 110-120V (GX1)

9 GX220 HEATING ELEMENT 208-240V (GX3)

10 GX228 BLOWER WHEEL

11 GX239 SENSOR COMPLETE, 110-240 VOLT

12 GB232 TAMPER-PROOF SCREWS & SECURITY WRENCH

F S aigure 3 eNSitivity djuStMeNt

F vigure 2 - Exploded iew

DISCONNECT POWER BEFORE INSTALLING

DESUNA LA ELECTRICIDAD ANTES DE HACER REPARACIONES

WARNING:

Produkt Specifikationer

Mærke:	American Dryer
Kategori:	Håndstoffer
Model:	GX1-M

Har du brug for hjælp?

Hvis du har brug for hjælp til American Dryer GX1-M stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Håndstoffer American Dryer Manualer

American Dryer Advantage AD90-BG Manual

17 August 2024

American Dryer Advantage AD90 Manual

16 August 2024

American Dryer ExtremeAir EXT7-M Manual

12 August 2024

American Dryer ExtremeAir EXT7-SS Manual

9 August 2024

American Dryer ExtremeAir GXT9-SS Manual

9 August 2024

American Dryer GX1-M Manual

8 August 2024

American Dryer Advantage AD90-M Manual

8 August 2024

American Dryer ExtremeAir GXT9 Manual

7 August 2024

American Dryer ExtremeAir EXT7 Manual

6 August 2024

American Dryer ExtremeAir GXT9-M Manual

6 August 2024

Håndstoffer Manualer

Nyeste Håndstoffer Manualer

Biodrier Biobot Manual

13 September 2024

Honeywell HPD-100B Manual

27 August 2024

Bobrick AirCraft B-750 Manual

23 August 2024

Bobrick QuietDry B-7120 Manual

23 August 2024

Bobrick QuietDry B-770 Manual

23 August 2024

Bobrick QuietDry B-7128 Manual

23 August 2024

Bobrick QuietDry B-778 Manual

23 August 2024

Bobrick CompacDryer B-710 Manual

23 August 2024

Noirot 2510 Automatic Manual

18 August 2024

Noirot 2511 Automatic Manual

18 August 2024