3
730427-100 Rev. B
1
2
4
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
!
NOTE:
Pictures may not exactly define contour of china and components.
INSTALLATION INSTRUCTIONS
Wall Hung Bathroom Sink
Introduction: Thank you for selecting our products...products which have been the benchmarks of fine quality for years. To help
insure that the installation process will proceed smoothly, please read these instructions carefully before you begin. Also, review
the recommended tools and materials list; carefully unpack and examine your new plumbing fixture.
Adjustable Wrench
Channel Lock Pliers
Regular Screwdriver
Recommended Tools & Materials
Phillips Screwdriver
Pipe Wrench
Putty Kinfe
Drill
Saber Saw
Basin Wrench
Plumbers' Putty or
Caulking
Tubing Cutter
Tape
Measure
Hacksaw
© American Standard Inc. 2003
Provide suitable reinforcement behind
finished wall for lavatory hanger mounting
screws. *Determine horizontal center line
location of support from the table listed in
Step 2. (Make sure support bottom
extends to lavatory back wall bottom.)
NOTE: If replacing an existing sink be
certain to shut off water supply before
removing old sink.
*NOTE: For installation of models using concealed or exposed arms, follow instruction
provided by arms manufacturer.
Level
Hanger
Location
C/L of 2X8
Support
Finished
Floor
*
Determine the
desired rim height
(for example 32")
then select from the
Table at right the
height of the hanger
mounting bolts
centerline
EXAMPLE:
For Lucerne:
32"-1"=31"
For Ledgewood:
32"+2-7/8"=34-7/8"
Drill pilot holes in positioning screw
slots of hanger. (Note: Some models
are supplied with anchor screws, or
steel hangers for lavatory installations.
Other models are not provided with
mounting hardware which can be
purchased at local hardware outlets.
Lavator-ies with bottom anchor screw
holes should be secured with anchor
screws in addition to hangers.
Part # Model
TABLE
Distance "A"
0124
0321
0355/0356
0372/0373
4300
4867/4869
5300
Comrade
Declyn
Lucerne
Penlyn
Ledgewood
Regalyn
Ledgemere
- 2-1/2" (64mm)
- 2-3/4" (70mm)
- 1" (25mm)
- 1/8" (3mm)
+ 2-7/8" (73mm)
+ 2-3/4" (70mm)
+ 2-1/2" (64mm)
HOLES FOR
ANCHOR
SCREWS
IN BACK
DRAPERY
RIM
HEIGHT
*
SUPPLIES AS
REQUIRED
WASTE
FINISHED FLOOR
HANGER
C/L OF HANGER
ANCHORING SLOTS
MOUNTING SCREW
HOLES (4)
POSITIONING
SCREW SLOTS (2)
A
Position hanger according to Step 2,
making sure its center is aligned with
the waste hole centerline. Mark the
hanger screw locations through its
mounting holes.
