Antennas Direct ClearStream Manual


Læs gratis den danske manual til Antennas Direct ClearStream (2 sider) i kategorien TV antenne. Denne vejledning er vurderet som hjælpsom af 51 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 26 anmeldelser. Har du et spørgsmål om Antennas Direct ClearStream, eller vil du spørge andre brugere om produktet?

Side 1/2
1) Reflector with
Collapsible Dipole
and Loop Element Base
2) Loop Element
3) 3 ½” Bolt
4) Weather Boot (optional)
Required, not included: Coaxial Cable, Medium-sized Cross Point Screwdriver.
3
4
Thread coaxial cable A with the connected weather boot through
the VHF IN hole in the Loop Element base (1) and connect cable
to the VHF IN connector on back of the Loop Element (2).
Once connected, slide the weather boot over the connection.
Secure the Reflector with Collapsible Dipole, Loop Element
Base (1), and Loop Element (2) as shown using the 3 bolt.½
Position the Loop Element Base at the center of the Reflector
Assembly bar until holes are alligned.
1
2
3
Thread coaxial cable through the TO TV hole
in the Loop Element Base (1) and connect the
cable to the TO TV connector on the back of
the Loop Element (2).
A
©Antennas Direct 2012 06/12 C2-V
Connect opposite end of coaxial cable to your TV or receiver.
Locate your TV Station transmission towers by going to
antennapoint.com and search on your address or zip code.
Point antenna in the direction of the transmission towers
closest to you and check reception by scanning for channels.
If reception is not as desired, move antenna and rescan.
Please call our Helpline for additional information.


Produkt Specifikationer

Mærke: Antennas Direct
Kategori: TV antenne
Model: ClearStream

Har du brug for hjælp?

Hvis du har brug for hjælp til Antennas Direct ClearStream stil et spørgsmål nedenfor, og andre brugere vil svare dig




TV antenne Antennas Direct Manualer

TV antenne Manualer

Nyeste TV antenne Manualer