APC Back-UPS BX650LI Manual

APC UPS Back-UPS BX650LI

Læs gratis den danske manual til APC Back-UPS BX650LI (1 sider) i kategorien UPS. Denne vejledning er vurderet som hjælpsom af 36 personer og har en gennemsnitlig bedømmelse på 4.5 stjerner ud af 18.5 anmeldelser. Har du et spørgsmål om APC Back-UPS BX650LI, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

0 /201EN 990-9648A-002 5 7

by Schneider Electric Industries S A S or their affiliated companies All . . . . other

trademarks are property of their respective owners .

Back-UPS BX650LI

User Guide

™

ON/OFF button

LED status indicator

Battery connector

AC power inlet

EBattery and surge protected outlets

Fuse

Features

IEC jumper cable for

PC connection

1Safety and General Information

Inspect the package contents upon receipt. Notify the

carrier and dealer if there is any damage.

Read the following reminders before stalling the UPS. in

• This UPS is inten ded for indo or use only.

• Con nect the UPS power cable directly to a wall outlet. Do not use surge protecto rs or

extension cords.

• When grounding can not be verified, disconnect the equipment from the AC power outlet

before installing or connecting to other equipment. Reconnect the power cord after all

connections are made.

• Servicing of batteries should be performed by Schneider Electric IT (SEIT) Customer

Sup port only.

• When replacing battery the UPS must be OFF, and its AC inlet unplugged.

• Do no t dispose of batteries in a fire. The batteries may explode.

• Do no t open or mutilate batteries. They contain an electrolyte that is toxic and harmful

to the skin and eyes.

• To avoid harmful injury due to energ y hazard, remove wrist watches and jewelry such

as rings when replacing the batteries. Use tools with insulated han dles.

• Replace batteries with the same number an d type of batteries as originally installed in

the equipment.

2Place and Power On

Replace PC's input cord with a jumper cable and use PC's input cord to connect

the UPS.

Con nect the battery by pulling the battery handle up,

and then pushing it into the unit.

Press the ON/OFF button to tu rn on the unit.

The green “Power On” indictor co nfirms th at the Back-UPS is on and read y to

pro vid e protection.

The Back-UP S should charger for at least 6 hours to ensure sufficient runtime.

The unit is being charged whenever it is connected to AC power, whether the

unit is turned ON or OFF.

Place the Back-UPS to avoid:

‧Direct sunlight

‧Excessive heat

‧Excessive moisture

For safety operation, please place the unit on the floor.

Specifications

Input Voltage / Frequency 230 VAC / 5 6 Hz0 Hz or 0

Brownout Transfer /

Over-voltage Transfer

1 0 VAC, typical / 7

280 VAC, typical

Output UPS Capacity (total) 650 VA / 325 W

Voltage On Battery 230 Vac rms

Frequency - On Battery 50 Hz / 60 Hz Hz±1

Transfer me 6ms typicalTi 

Protection AC Input Fuse

Battery Type (maintenance-free) 12V, 7 AH

Typical Recharge Time Hours 4-6

Physical Net Weight . kg 4 2

Dimensions (H x W x D) cm x 1 . cm x cm 14.2 0 1 30

Average Life years. Environmental factors impact battery

life. Elevated temperatures, high humidity, 

poor quality mains power, and frequent,

short duration discharges will shorten

battery life.

The battery typically lasts for three to five

The battery in the Back-UPS BX 650LI

Series is not user-replaceable. Contact

SEIT Technical Support for a list of

authorized service centers near you.

APC by Schneider Electric IT Customer

Support Worldwide

For country specific customer support, go to the APC by Schn idere Electric Web site w , w w. .apc com.

Troubleshooting and Service

1 act Schneider Electric stomer Support through the APC by. If the problem persists, cont IT (SEIT) Cu

Schneider Electric Web site, www.apc.com. .

a. Note the model number and serial number . and the date of purchase The model and serial numbers

are located on the rear panel of the unit and are available through the LCD display on select models.

b. Call SEIT Customer Support and a technician will attempt to solve the problem over the phone. If it

is not possible, the technician will issue a Returned Material Authorization Number (RMA#).

c. If the unit is under warranty, the repairs are free. 

d. Service procedures and returns may vary . internationally Refer to the APC by Schneider Electric

Web site for country specific instructions.

2 phone If this is not successful and the unit is still under. Prepare to troubleshoot the problem over the . ,

, warranty the SEIT Technical Support Representative will provide all necessary information to return the

unit for replacement .

5LED Condition

On Off On-line - The Back-UPS is supplying AC power to

the connected equipment

Constant Tone On Line Overload - The power being used by the

connected equipment has exceeded the capacity of the

unit. Disconnect some equipment.

Constant beeping Over-temperature Warning - The unit is

overheating and will shut down if the temperature is

not lowered. Disconnect some of the connected

equipment.

(Off during 4 beeps)

4 beeps repeated

every 30 seconds

On-Battery - The Back-UPS is supplying battery

power.

Flashing Rapid Beeping

(every 1/2 second)

Low Battery Warning - The Back-UPS has 2

minutes of runtime remaining.

Constant tone Bad Battery Detected - The battery needs to be

charged, or is at end of life. (See Battery

Replacement.)

Off Short eep very b e

4 seconds Low Battery Shutdown - During On Battery

operation the battery power was almost completely

exhausted, and the Back-UPS is waiting for AC power

to return to normal.

Constant Tone On Battery Overload - The connected equipment

requires more wer thanpo provided by the Back-UPS 

battery. Unplug devices one at a time to remove

overload. If the problem is not corrected, contact SEIT

Technical Support

Constant Tone Charger Fault - Back-UPS has an internal problem,

and is no longer powering the load. Contact SEIT

Technical Support

Audible Alarm

Long beep every

4 seconds UPS has ov erheated and has shut down.

Unp lug connected devices one at a time or

wait for a few hours for system to co ol down.

Over-temperature Protected - The Back-

Status Indicators

Warranty

The standard warranty is two (2) years from the date of purchase. SEIT standard procedure is to replace the

original unit with a factory reconditioned unit. Customers who must have the original unit back due to the 

assignment of asset tags and set depreciation schedules must declare such a need at first contact with an SEIT

Technical Support representative. SEIT will ship the replacement unit once the defective unit has been

received by the repair department, or cross-ship upon the receipt of a valid credit card number. The customer

pays for shipping the unit to SEIT. SEIT ays groundp freight transportation costs to placement unit ship the re

to the customer.

No-load Shutdown

If the UPS is operating on battery power and detects that the connected equipment is using less than

15W of energ y for more than 15 minutes, it will shut do wn to conserve en ergy. When th e UPS is

reconnected to AC power, th e UPS will automatically switch on .

Operational Features

Automatic Voltage Regulation bo osts/trims th e AC voltage when it drop s/exceeds safe levels.

This allows the equipmen t plu gged in to th e unit to operate durin g low/h igh voltage co nditions,

conserving the battery power in the event of a power cut.

The Back-UP S will switch to battery power if the input voltag e level becomes too low/high for the

Automatic Voltage Regulation to comp ensate, or if the AC po wer is distorted.

Automatic Voltage Regulation (AVR)

Fuse Replacement

A spare fuse is provided in every Back-UP S unit.

Once the input current exceed s 5A, the installed

fuse in ev ery unit will burn to safeguard connected

equipment fro m excessive input currents. Replace

it using the sp are fuse, or with a fuse that has

similar input current rating.

Produkt Specifikationer

Mærke:	APC
Kategori:	UPS
Model:	Back-UPS BX650LI

Har du brug for hjælp?

Hvis du har brug for hjælp til APC Back-UPS BX650LI stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

UPS APC Manualer

APC RBC150 Manual

2 April 2025

APC RBC151 Manual

2 April 2025

APC Symmetra LX 4kVA Manual

30 Marts 2025

29 Marts 2025

29 Marts 2025

29 Marts 2025

29 Marts 2025

30 Januar 2025

30 Januar 2025

APC BE650G2-IT Manual

14 Januar 2025

UPS Manualer

Nyeste UPS Manualer

Teltonika BAT120 Manual

30 Januar 2025

LevelOne UPS-2101 Manual

9 Januar 2025

Conceptronic ZEUS52E6K Manual

31 December 2025

Conceptronic ZEUS51E6K Manual

31 December 2025

CyberPower Smart App Sinewave PR2000RT2U Manual

30 December 2025

Tripp Lite ECO750UPS Manual

30 December 2025

Phoenix Contact QUINT-UPS/ 24DC/ 24DC/10 Manual

28 December 2024

Phoenix Contact QUINT-UPS/ 24DC/ 24DC/20 Manual

28 December 2024

Phoenix Contact QUINT-UPS/ 24DC/ 24DC/ 5 Manual

28 December 2024

Conceptronic ZEUS52EA3K Manual

14 December 2024