APC Back-UPS BX650LI-MS Manual

APC Uafbrydelig strømforsyning (UPS) Back-UPS BX650LI-MS

Læs gratis den danske manual til APC Back-UPS BX650LI-MS (1 sider) i kategorien Uafbrydelig strømforsyning (UPS). Denne vejledning er vurderet som hjælpsom af 4 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 2.5 anmeldelser. Har du et spørgsmål om APC Back-UPS BX650LI-MS, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/1
/201EN 990-5607 12 4
Back-UPS BX650LI-MS
User Guide
™
Replace PC's input cord with a jumper cable and use PC's input cord to connect the
UPS.
© 4201 APC by Schneider Electric. APC, the APC logo and Back UPS are owned -
by Schneider Electric Industries S A S . . . or their affiliated companies All . other
trademarks are property of their respective owners .
A
AC power inlet
D
Battery connector
C
LED status indicator
B
Battery and surge protected outlets
E
1
Safety and General Information
Inspect the package contents upon receipt. Notify the
carrier and dealer if there is any damage.
Read the following reminders before installing the UPS.
• This UPS is intended for indoor use only.
• Connect the UPS power cable directly to a wall outlet. Do not use surge protectors or
extension cords.
• When grounding cannot be verified, disconnect the equipment from the AC power outlet
before installing or connecting to other equipment. Reconnect the power cord after all
connections are made.
• Servicing of batteries should be performed by Schneider Electric IT (SEIT) Customer
Support only.
• When replacing battery the UPS must be OFF, and its AC inlet unplugged.
• Do not dispose of batteries in a fire. The batteries may explode.
• Do not open or mutilate batteries. They contain an electrolyte that is toxic and harmful
to the skin and eyes.
• To avoid harmful injury due to energy hazard, remove wrist watches and jewelry such
as rings when replacing the batteries. Use tools with insulated handles.
• Replace batteries with the same number and type of batteries as originally installed in
the equipment.
Features
3
2
Place and Power On
2
1
3
4
Connect the battery by pulling the battery handle up,
and then pushing it into the unit.
Press the ON/OFF button to turn on the unit.
The green “Power On” indictor confirms that the Back-UPS is on and ready to
provide protection.
The Back-UPS should charger for at least 6 hours to ensure sufficient runtime.
The unit is being charged whenever it is connected to AC power, whether the
unit is turned ON or OFF.
Place the Back-UPS to avoid:
‧Direct sunlight
‧Excessive heat
‧Excessive moisture
For safety operation, please place the unit on the floor.
APC by Schneider Electric IT Customer
Support Worldwide
For country specific customer support, go to the APC by Schn idere Electric Web site w apc , w w. .com.
4
Specifications
Input
Voltage / Frequency 230 VAC / 5 6 Hz0 Hz or 0
Brownout Transfer /
Over-voltage Transfer
1 0 VAC, typical / 7
280 VAC, typical
Output UPS Capacity (total) 650 VA / 325 W
Voltage On Battery 230 Vac rms
Frequency - On Battery 50 Hz / 60 Hz Hz±1
Transfer Time 6ms typical
Protection
AC Input Fuse
Battery
Type (maintenance-free) 12V, 7 AH lead acid
Typical Recharge Time Hours 4-6
Physical
Net Weight . kg 4 4
Dimensions (H x W x D) cm x 1 . cm x cm 14.2 0 1 30
Average Life
years. Environmental factors impact battery
life. Elevated temperatures, high humidity,
poor quality mains power, and frequent,
short duration discharges will shorten
battery life.
The battery typically lasts for three to five
The battery in the Back-UPS BX 650LI
Series is not user-replaceable. Contact
SEIT Technical Support for a list of
authorized service centers near you.
5
LED
Condition
On
Off On-line - The Back-UPS is supplying AC power to
the connected equipment
Constant Tone On Line Overload - The power being used by the
connected equipment has exceeded the capacity of the
unit. Disconnect some equipment.
Constant beeping Over-temperature Warning - The unit is
overheating and will shut down if the temperature is
not lowered. Disconnect some of the connected
equipment.
On
(Off during 4 beeps)
4 beeps repeated
every 30 seconds
On-Battery - The Back-UPS is supplying battery
power.
Flashing
Rapid Beeping
(every 1/2 second)
Low Battery Warning - The Back-UPS has 2
minutes of runtime remaining.
Constant tone
Bad Battery Detected - The battery needs to be
charged, or is at end of life. (See Battery
Replacement.)
Off
Short beep every
4 seconds
Low Battery Shutdown - During On Battery
operation the battery power was almost completely
exhausted, and the Back-UPS is waiting for AC power
to return to normal.
Constant Tone On Battery Overload - The connected equipment
requires more power than provided by the Back-UPS
battery. Unplug devices one at a time to remove
overload. If the problem is not corrected, contact SEIT
Technical Support
Constant Tone Charger Fault - Back-UPS has an internal problem,
and is no longer powering the load. Contact SEIT
Technical Support
Audible Alarm
Long beep every
4 seconds
UPS has overheated and has shut down.
Unplug connected devices one at a time or
wait for a few hours for system to cool down.
Over-temperature Protected - The Back-
Status Indicators
Warranty
Register your product on-line. http://warranty.apc.com
The standard warranty is two (2) years from the date of purchase. SEIT standard procedure is to replace the
original unit with a factory reconditioned unit. Customers who must have the original unit back due to the
assignment of asset tags and set depreciation schedules must declare such a need at first contact with an SEIT
Technical Support representative. SEIT will ship the replacement unit once the defective unit has been
received by the repair department, or cross-ship upon the receipt of a valid credit card number. The customer
pays for shipping the unit to SEIT. SEIT pays ground freight transportation costs to ship the replacement unit
to the customer.
Troubleshooting and Service
1 act Schneider Electric stomer Support through the APC by. If the problem persists, cont IT (SEIT) Cu
Schneider Electric Web site, www.apc.com.
.
a. Note the model number and serial number . and the date of purchase The model and serial numbers
are located on the rear panel of the unit and are available through the LCD display on select models.
b. Call SEIT Customer Support and a technician will attempt to solve the problem over the phone. If it
is not possible, the technician will issue a Returned Material Authorization Number (RMA#).
c. If the unit is under warranty, the repairs are free.
d. Service procedures and returns may vary . internationally Refer to the APC by Schneider Electric
Web site for country specific instructions.
2 phone If this is not successful and the unit is still under. Prepare to troubleshoot the problem over the . ,
, warranty the SEIT Technical Support Representative will provide all necessary information to return the
unit for replacement .
No-load Shutdown
If the UPS is operating on battery power and detects that the connected equipment is using less than
15W of energy for more than 15 minutes, it will shut down to conserve energy. When the UPS is
reconnected to AC power, the UPS will automatically switch on.
Operational Features
6
Automatic Voltage Regulation boosts/trims the AC voltage when it drops/exceeds safe levels.
This allows the equipment plugged into the unit to operate during low/high voltage conditions,
conserving the battery power in the event of a power cut.
The Back-UPS will switch to battery power if the input voltage level becomes too low/high for the
Automatic Voltage Regulation to compensate, or if the AC power is distorted.
Automatic Voltage Regulation (AVR)
NEMA jumper cable for
PC connection
Fuse Replacement
A spare fuse is provided in every Back-UPS unit. Once
the input current exceeds 5A, the installed fuse in
every unit will burn to safeguard connected equipment
from excessive input currents. Replace it using the
spare fuse, or with a fuse that has similar input current
rating.
Fuse
F

Produkt Specifikationer

Mærke: APC
Kategori: Uafbrydelig strømforsyning (UPS)
Model: Back-UPS BX650LI-MS

Har du brug for hjælp?

Hvis du har brug for hjælp til APC Back-UPS BX650LI-MS stil et spørgsmål nedenfor, og andre brugere vil svare dig


Uafbrydelig strømforsyning (UPS) APC Manualer

APC

APC Back-UPS 600 Manual

8 Juli 2025
APC

APC Back-UPS BX650LI-MS Manual

7 Juli 2025
APC

APC RBC44J Manual

7 Juli 2025
APC

APC Easy UPS 3S Manual

4 Juli 2025
APC

APC Back-UPS Pro BN1350M2 Manual

10 April 2025
APC

APC RBC172 Manual

28 Marts 2025
APC

APC Back-UPS XS 1500 Manual

28 Marts 2025
APC

APC Smart-UPS SCL500RMI1UNC Manual

28 Marts 2025
APC

APC Back-UPS Pro BR1000G Manual

27 Marts 2025
APC

APC Isolation Transformer Manual

22 Januar 2025

Uafbrydelig strømforsyning (UPS) Manualer

Nyeste Uafbrydelig strømforsyning (UPS) Manualer

Hikvision

Hikvision DS-UPS3000 Manual

7 Juli 2025
GYS

GYS Power Pack 14.22 Manual

6 Juli 2025
Vertiv

Vertiv Liebert PSI5-1100MT120 Manual

6 Juli 2025
PowerWalker

PowerWalker VI 2000 RLP Manual

6 Juli 2025
Vertiv

Vertiv Liebert PSI5-750MT120 Manual

6 Juli 2025
PowerWalker

PowerWalker VI 1000 RLP Manual

5 Juli 2025
PowerWalker

PowerWalker VFI 3000 RMG PF1 Manual

5 Juli 2025
PowerWalker

PowerWalker VI 500 R1U Manual

5 Juli 2025
PowerWalker

PowerWalker VI 600 SCL Manual

5 Juli 2025
Qoltec

Qoltec 53042 Manual

5 Juli 2025