AXESS AXDCT-2 Manual


Læs gratis den danske manual til AXESS AXDCT-2 (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 64 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 32.5 anmeldelser. Har du et spørgsmål om AXESS AXDCT-2, eller vil du spørge andre brugere om produktet?

Side 1/3
AXDCT-2
INSTALL ATION INSTRUCTI O N S
REV. 3/2/20
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com
The AXDCT-2 should be installed on a stereo’s speaker output wires or the
output wires on an factory amplier of up to 80 watts per channel. These
wires can be found behind the stereo in the dash, on the outside of an factory
amplifier, or on the input terminals on the factory speakers.
Wire Color & Function: The audio input wire colors are an EIA standard for car
stereo applications as follows:
Yellow - Battery +12v input †
Black - Ground input †
Blue - Remote +12v output †
These wires can be connected directly to the amplifier being installed.
Wires only required if a 12v amp turn-on is desired.
White - Left front (+) input
White/Black - Left front (-) input
Gray - Right front (+) input
Gray/Black - Right front (-) input
Black/White - Reference ground (-)
(Reference ground optional if noise is present)
Note: Be sure that all audio input connections are polarized or in phase with
each other. That is, the positive output wires from the audio source need to be
connected to the corresponding positive input wires of the AXDCT-2. The same
goes for the negative audio wires. Failure to do this will result in poor bass
response and low quality audio.


Produkt Specifikationer

Mærke: AXESS
Kategori: Ikke kategoriseret
Model: AXDCT-2

Har du brug for hjælp?

Hvis du har brug for hjælp til AXESS AXDCT-2 stil et spørgsmål nedenfor, og andre brugere vil svare dig