AXDI-GMLN10
I N S TA L L AT I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION REV. 10/30/23 INSTAXDI-GMLN10
Product Info
ATTENTION: With the key out of the ignition,
disconnect the negative battery terminal
before installing this product. Ensure that all
installation connections, especially the air
bag indicator lights, are plugged in before
reconnecting the battery or cycling the ignition
to test this product.
NOTE: Refer also to the instructions included
with the aftermarket radio.
OPTIONAL ACCESSORIES (sold separately)
Extension Harness: AXEXH-GM10
TABLE OF CONTENTS
Connections: LD-LCLAN-10 Harness 2 ......................
Installation 3 .............................................................
Programming 3 .........................................................
APPLICATIONS
INTERFACE COMPONENTS
• AXDI-GMLN10 interface • AXDI-GMLN10 harness
(1) (2) With RPO code I0B • With RPO code I0A
The , if applicable, are in the in the following locations: : Malibu IOA/IOB codes Service Parts Identification labels Rear Compartment Floor
Glovebox: Note: RPO (QR codes) “B Pillar” VIN Canyon/Colorado/Cruze/Equinox/Silverado/Sierra are in the driver door jam or on the label.
GM Data Interface 2016-2020
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink
• Tape • Wire cutter • Zip-ties
CHEVROLET
Colorado 2017-2019(1) ........................
Cruze 2016-2019(2) ..............................
Cruze Hatchback 2016-2019(2) ........
Equinox 2018(1) ...................................
Malibu 2016-2019(2) ............................
Silverado 2016-2018(1) .......................
Silverado LD 2019(1) ...........................
Trax 2017-2020(2) ...............................
GMC
Acadia 2017-2019(1) ....................
Canyon 2017-2019(1) ...........................
Sierra 2016-2018(1) ..............................
Sierra Limited 2019(1) .........................
Visit for more detailed AxxessInterfaces.com
information about the product and up-to-date
vehicle specific applications.
INTERFACE FEATURES
• Used in non-amplified models, or when bypassing a factory amp
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
•
Provides illumination, parking brake, reverse, and speed sense
outputs
• Used in models without OnStar
• Retains all warning chimes
• High level speaker input
• Retains balance and fade
• Retains factory backup camera
• USB Micro-B updatable
