AXESS AXLOC-150A Manual


Læs gratis den danske manual til AXESS AXLOC-150A (3 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 39 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 20 anmeldelser. Har du et spørgsmål om AXESS AXLOC-150A, eller vil du spørge andre brugere om produktet?

Side 1/3
AXLOC-150A
INSTALL ATIO N I NSTRUCTI O NS
REV. 12/18/19© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com
Wire Color & Function: The audio and power input wire colors are an EIA standard for
car stereo applications as follows.
Note: Be sure that all audio input connections are polarized or in phase with each other.
That is, the positive output wires from the audio source need to be connected to the
corresponding positive input wires of the AXLOC-150A. The same goes for the negative
audio wires. Failure to do this will result in poor bass response and low quality audio.
Adjusting the AXLOC-150A for maximum performance:
After completing all of the necessary connections, turn the AXLOC-150A adjustment pots all of the
way down by rotating them completely counter-clockwise. Now, turn the stereo system on and
adjust the main volume control on the stereo to approximately 3/4 maximum volume. Select
one of the adjustment pots on the AXLOC-150A and turn it slowly clockwise until you notice audio
distortion and then stop. Turn the remaining pot to the same position as the previously adjusted
pot. The audio set-up of the AXLOC-150A is now complete and ready to be enjoyed.
INPUT HARNESS
White = LEFT Front (+) Input
White/Black = LEFT Front (-) Input
Black = Reference Ground (-)
(Reference ground optional if noise is present)
Gray = RIGHT Front (+) Input
Gray/Black = RIGHT Front (-) Input


Produkt Specifikationer

Mærke: AXESS
Kategori: Ikke kategoriseret
Model: AXLOC-150A

Har du brug for hjælp?

Hvis du har brug for hjælp til AXESS AXLOC-150A stil et spørgsmål nedenfor, og andre brugere vil svare dig