BaByliss Hydro-Fusion Anti-Frizz 2973U Manual

BaByliss Krøllejern Hydro-Fusion Anti-Frizz 2973U

Læs gratis den danske manual til BaByliss Hydro-Fusion Anti-Frizz 2973U (8 sider) i kategorien Krøllejern. Denne vejledning er vurderet som hjælpsom af 17 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 9 anmeldelser. Har du et spørgsmål om BaByliss Hydro-Fusion Anti-Frizz 2973U, eller vil du spørge andre brugere om produktet?

Side 1/8
HYDRO-FUSION AIR STYLER
2973U
SAFETY CAUTIONS
Read these safety precautions carefully before using the
unit! This appliance should only be used as described
within this instruction booklet. Please retain for future
reference.
WARNING! BURN HAZARD : THIS APPLIANCE GETS
HOT!
ALWAYS keep out of reach of children (during and after
use and whilst cooling).
Always take extra care if used on children or near
children.
Do not use on very young children.
IMPORTANT SAFETY
UK Only: This appliance must not be used in
the bathroom.
Outside the UK: If using the appliance in a bathroom,
unplug after use as the proximity of water can be
dangerous even if the appliance is switched off. For
additional protection the installation of a residual current
device (RCD) with a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit
supplying the bathroom. Ask your installer for advice.
WARNING! Do not use this appliance near bathtubs,
showers, basins or other vessels containing water.
Do not immerse the appliance into water or other liquids.
Always inspect the appliance before use for noticeable
signs of damage. Do not use if damaged, or if the
appliance has been dropped. In the event of damage,
discontinue use immediately. Contact the Conair
Customer Care Line (refer to ‘UK After Sales Service
section for further information).
Do not use the appliance if the lead is damaged. In the
event of damage, discontinue use immediately. If the lead
is damaged it must be replaced by the manufacturer.
Return the appliance to the Customer Care Centre (refer
to UK After Sales Servicesection for further information).
No repair must be attempted by the consumer.
Do not leave the appliance unattended when switched
on or plugged in.
This appliance is equipped with a safety thermostat. In
the event of overheating the appliance will either stop
automatically or run hot and cold intermittently. Should
this happen, switch the appliance to the ‘0 position,
unplug and allow to cool for 10 minutes. Before use,
ensure the rear lter is clear of hair and other debris. Plug
in and switch on. If the appliance continues to overheat
discontinue use immediately, switch off and unplug, and
contact the Conair Customer Care Line (refer to ‘UK


Produkt Specifikationer

Mærke: BaByliss
Kategori: Krøllejern
Model: Hydro-Fusion Anti-Frizz 2973U

Har du brug for hjælp?

Hvis du har brug for hjælp til BaByliss Hydro-Fusion Anti-Frizz 2973U stil et spørgsmål nedenfor, og andre brugere vil svare dig