Bauknecht GSF Excellence Manual

Bauknecht Opvaskemaskine GSF Excellence

Læs gratis den danske manual til Bauknecht GSF Excellence (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 66 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 33.5 anmeldelser. Har du et spørgsmål om Bauknecht GSF Excellence, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

GB -1-

Chart

PROGRAM SELECTION

BUTTON

Push “Programs” button

(repeatedly) until the indicator

of the required program lights

up (see “Table of programs”

below).

START/RESUME BUTTON

Push this button to start the selected program: the

indicator lights up and goes off at the end of the

program.

When the door is opened during a washing cycle,

the cycle is temporarily paused: the Start indicator

blinks. To resume the cycle close the door and

push Start button again.

(see at right for options description)

CANCEL/OFF BUTTON

Push this button to switch off the control panel.

If pressed when a program is running it cancels the

program ongoing draining water for 1 minute (0:01

is shown into the display).

If pressed when the dishwasher is switched off, it

drains any possible liquids from dishwasher

(1minute process).

1) Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without additional

options) and may vary depending on conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the

appliance’s automatic calibration system.

2) Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the

EN/Standard loading comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on the NF EN 13697 standard of November 2001.

Table of programs

Deter-

gent

Consumption

PPrograms Available

options Loading instructions Litres kWh Minutes 1)

1Sensor 40-70°C

Delay

Multizone

Antibacterial

rinse

Normally or heavily soiled crockery,

including pots and pans. None soaking

or hand pretreatment is needed. In

addition hygiene of the complete

loading is ensured with this program.

X 7-14 0.99-1.80 70-185

2Pre-Wash cold Delay

Multizone Crockery to be washed later. — 4.0 0.03 14

3Glasses 40°C Delay

Multizone Light soiling, for example glasses and

cups. X 10.0 0.85 100

4Quickwash 45°C Delay

Multizone Lightly soiled crockery, with no dried-

on food. X 11.0 0.80 30

5Bio Normal 2) 50°C

Delay

Multizone

Antibacterial

rinse

Normally soiled crockery. X 12.0 1.05 150

6Daily 60°C

Delay

Multizone

Antibacterial

rinse

Normally to heavily soiled crockery. X 13.0 1.25 120

5019 496 01635GSF EXCELLENCE

BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ

THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!

Options and display description

SALT INDICATOR

When lit (at the end of the cycle),

the salt reservoir needs to be

refilled.

MULTIZONE

Allows you to choose the washing

zones. Press this button (repeatedly)

to select the wash zones:

both racks

only lower rack

only upper rack

- indicator lits TABLET SETTING

This setting allows to

optimize the cycle

performances according

the type of detergent

used. Push the Tablet

button for 3 seconds (until

the indicator lights up) if

you are using the

combined detergents in

tablet (rinse aid, salt and

detergent in 1 dose). If you

are using powder

detergent or liquid

detergent, the Tablet

indicator on the control

panel has to be off.

DELAYED START

BUTTON

Push the button

(repeatedly) to delay the

start of the program.

Adjustable from 1 to 24

hours. With each press of

the button, the delayed

start indicator increases

by one hour and after 24

restarts from 0. Then

press the START button.

The dishwasher will start

after the set time.

RINSE AID INDICATOR

When lit (at the end of the cycle),

the rinse aid dispenser needs to

be refilled.

WASH TIME DISPLAY

Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected it indicates

the time remaining until program start (h.00) - below 1h (0:mim).

If “Fx Ey” messages appears on the display, see page 6 - chapter “What to do if...”.

ANTIBACTERIAL RINSE 3)

This function activates an

antibacterial rinse at the end of the

wash cycle, guaranteeing a further

reduction of bacteria. Press the

button to activate or deactivate the

function. This function can be used

with the programs indicated in the

table of programs. The dishwasher

door must be kept shut for the entire

duration of the program in order to

guarantee reduction of bacteria. If

the door is opened the indicator lamp

starts flashing.

THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING

ANY BUTTON EXCEPT CANCEL/OFF BUTTON.

FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES

AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.

Quick reference guide

Produkt Specifikationer

Mærke:	Bauknecht
Kategori:	Opvaskemaskine
Model:	GSF Excellence

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSF Excellence stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Bauknecht Manualer

Bauknecht BKO IBM Manual

31 Oktober 2025

Bauknecht BKR UAS Manual

31 Oktober 2025

Bauknecht BKO PBM Manual

29 Oktober 2025

Bauknecht B8I HT58 TS Manual

30 September 2025

Bauknecht BKSV1 FAM Manual

16 September 2025

Bauknecht BKO FBM Manual

25 August 2025

Bauknecht B0B D651A X Manual

25 August 2025

Bauknecht OBFC Ecosilent 8650 Manual

24 August 2025

Bauknecht OBIC Ecosilent 8650 Manual

16 August 2025

Bauknecht B7F HS51 X Manual

3 August 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Big Chill BC24DWCBBMB Manual

31 Oktober 2025

Big Chill BC24DWRCAR Manual

31 Oktober 2025

Big Chill BC24DWCCRPB Manual

31 Oktober 2025

Artusi ADW5001 Manual

31 Oktober 2025

Big Chill BC24DWCSNCW Manual

31 Oktober 2025

Elektra Bregenz MGIV 56580 XL Manual

31 Oktober 2025

Siemens SR93EX25MG Manual

31 Oktober 2025

Tornado TDV-FN128COX Manual

31 Oktober 2025

Elektra Bregenz GI 57180 X Manual

31 Oktober 2025

Elektra Bregenz GI 85544 X Manual

31 Oktober 2025