Bauknecht GSIP 6517/1 SW Manual

Bauknecht Opvaskemaskine GSIP 6517/1 SW

Læs gratis den danske manual til Bauknecht GSIP 6517/1 SW (8 sider) i kategorien Opvaskemaskine. Denne vejledning er vurderet som hjælpsom af 45 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 23 anmeldelser. Har du et spørgsmål om Bauknecht GSIP 6517/1 SW, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

5019 496 01066

GB GSIP 6517

Before using the dishwasher, read the

installation and maintenance instructions carefully!

1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to

different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness

and power supply voltage.

2) Energy label programme in compliance with EN 50242. - Information for Test Laboratories: for more detailed information on

the EN comparison test and other tests, contact the following address: “nk_customer@whirlpool.com”.

3) The antibacterial action has been shown in collaboration with the Pasteur Institute, Lille (France), in conformity with.

Standard NF EN 13697 - November 2001.

1. OVERVIEW

Programme selector

START button

The indicator lights up during operation, ﬂashes when a fault

occurs, and goes off at the end of the programme.

START button RESET function:

Press this button for at least 2 seconds; the selected programme and

options are cancelled. Main failure displays (repeated flashing of the

START indicator lamp) can be cancelled by RESETTING. Detailed

instructions are given in chapter 5 “What to do, in case of...”.

Fault indication and wash time display

In normal operation it indicates the remaining time (h:mm),

whereas with “Delayed start” selected it indicates the time

remaining until programme start (hh).

If “F..” appears on the display, see chapter 5 “What to do, in case of...”.

“Delayed start” button

Press the button (repeatedly) to delay the start of the programme.

Adjustable from 1 to 24 hours. With each press of the button, the

delayed start indicator increases by one hour and after 24 restarts

from 00. Then press the START button. The dishwasher will start

after the set time.

Half Load/Multizone button

The half load cycle can be used for the upper or lower rack. Select the

required programme then press the “Half load” button. The light

comes on and goes off at the end of the programme.

This function can be used with the programmes indicated in table 1.1.

Antibacterial rinse 3)

This function activates an antibacterial rinse at the end of the wash

cycle, guaranteeing a further reduction of bacteria. Press the button to

activate or deactivate the function. This function can be used with those

programmes marked with the relative symbol in table 1.1.

The dishwasher door must be kept shut for the entire duration of

the programme in order to guarantee reduction of bacteria. If the

door is opened the indicator lamp starts flashing.

On / Off button

Table 1.1.

Table of programmes Detergent

dispenser Consumption 1)

PProgrammes Available

options Loading instructions large small Litres kWh Minutes

1Pre-rinse cold — Crockery to be washed later. — — 4.0 0.03 14 ± 1)

2Rapid 40°C —Lightly soiled crockery, without dry

residuals. X — 10.0 0.65 30 ± 1)

3Bio 2) 50°C Normally soiled crockery. Energy-saving

programme. X X 12.0 1.05 165 ± 1)

4Daily 60°C Normally to heavily soiled crockery. X X 13.0 1.25 120 ± 1)

5Intensive 70°C Recommended programme for heavily

soiled crockery, especially suitable for

pans and saucepans. X X 14.0 1.55 155 ± 1)

2. QUICK REFERENCE GUIDE

Detailed instructions are given on the following pages; also see section “5. What to do, in case of...”

1. Switch on the

appliance Press the ON/OFF button.

2. Select a programme Press the button “Select programme” or the programme selector to display the

selected programme. If required, select possible options.

3. Select the type of

detergent The detergent selection procedure varies depending on the dishwasher model.

Chapter “1. Overview” provides instructions for selecting detergent type.

4. Fill in the detergent 4a. Powder/gel/tabs

Fill the detergent dispenser compartments in

accordance with the wash programme selected.

Large compartment A for every wash cycle, additional

small compartment B for programmes with pre-wash

(see table 1.1.).

4b. Combined action detergents (2 in 1/3 in 1/... etc.)

Place the detergent in compartment A or in the cutlery

basket, as per the manufacturer's recommendations.

5. Check the rinse aid

level

6. Check the salt level Depending on the model:

7. Load the racks

Make sure that the spray arms can turn freely and are not impeded by crockery

or cutlery in the racks.

Detailed instructions on loading the racks are given in chapter “3. How to use

the appliance”, under “How to load the racks”.

8. Open the water tap

and close the door

9. Start the appliance Press the START button.

Wash cycle

If the appliance is switched off during a

wash cycle, when switched on again it will

resume the cycle from where it was

interrupted. Care must be taken when

opening the door, as steam will escape!

10.End of programme The START indicator lamp switches off at the end of the programme.

11.Switch off the

appliance Press the OFF button. All the indicator lamps switch off.

12.Turn oﬀ the water

tap, unload the racks

Unload the appliance, starting from the lower rack in order to avoid any

residual drips of water falling onto crockery below.

Visual indicator in dispenser C

dark ➯sufficient rinse aid present,

clear ➯add rinse aid (approx. 100 ml).

The indicator lamp on the control panel lights up when rinse aid

needs to be added. Not all models are equipped with such an

indicator.

window in salt reservoir cap on bottom of appliance inside

orange ➯when sufficient salt is present,

clear ➯when salt needs to be added.

The indicator lamp on the control panel lights up when salt needs

to be added. Even once salt has been added, the indicator lamp

only switches off after several wash cycles!

Changing the programme

in progress:

- Keep the START button pressed

for about 2 seconds until the

START indicator goes off.

- (Water drains for up to 60

seconds).

- Select the programme again.

- Press the Start button.

Produkt Specifikationer

Mærke:	Bauknecht
Kategori:	Opvaskemaskine
Model:	GSIP 6517/1 SW

Har du brug for hjælp?

Hvis du har brug for hjælp til Bauknecht GSIP 6517/1 SW stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Opvaskemaskine Bauknecht Manualer

Bauknecht BK6IC11BS7LSA0CH Manual

15 Juli 2025

Bauknecht BK8IA15AM3TUSC0CH Manual

15 Juli 2025

Bauknecht BK4PC11BS7A0 Manual

29 Juni 2025

Bauknecht BK41C11BS7LA0 Manual

29 Juni 2025

Bauknecht OBFC Ecosilent 9760 Manual

28 Juni 2025

Bauknecht OBIC Ecosilent 9760 Manual

28 Juni 2025

Bauknecht B8KI HP42 LCA Manual

27 Juni 2025

Bauknecht BK6IB10BS7LAO Manual

27 Juni 2025

Bauknecht BK6UB10BS7A0X Manual

26 Februar 2025

Bauknecht BK6IB10BS7LA0 Manual

26 Februar 2025

Opvaskemaskine Manualer

Nyeste Opvaskemaskine Manualer

Frigidaire FDSH4502BF Manual

29 Juli 2025

Siemens iQ300 SN43HS11TE Manual

28 Juli 2025

Blaupunkt 5VS401AU Manual

28 Juli 2025

Whirlpool WDT751SAPZ Manual

28 Juli 2025

GE GDF540HSFSS Manual

28 Juli 2025

Neff S255HTX00E Manual

28 Juli 2025

Neff S287HDX01A Manual

28 Juli 2025

Blaupunkt 5VF421AU Manual

28 Juli 2025

GE PDT760SSFSS Profile Manual

28 Juli 2025

GE GDWF460VSS Manual

28 Juli 2025