BlendMount HT-1096 Manual


Læs gratis den danske manual til BlendMount HT-1096 (2 sider) i kategorien Detektor. Denne vejledning er vurderet som hjælpsom af 9 personer og har en gennemsnitlig bedømmelse på 5.0 stjerner ud af 5 anmeldelser. Har du et spørgsmål om BlendMount HT-1096, eller vil du spørge andre brugere om produktet?

Side 1/2
Guidelines on Using a Voltmeter to
Locate Power and Ground
1. First set your voltmeter to the continuity
setting (should beep when you touch the red
and black probes together, telling you they are
shorted).
2. Find a ground on the car somewhere, like a
bolt under the dash, or a metal cross member.
3.
Put the black probe on that ground, and
touch the back
of
each exposed wire connector
in the mirror harness with the red probe.
4. For each wire that beeps, that means that
wire is grounded. Tum the ignition to the on
position, then back to off, and make sure it
beeps regardless
of
the ignition position.
5.
Put the voltmeter into voe mode, to
measure DC volts, turn the ignition to the on
position.
6.
Put the black probe on the ground wire
found
in
#4.
7. Touch each
of
the wires
in
that ha mess with
the red probe, and note which one(s) gives you
+12-14 volts, turn the ignition off to verify that
the volt readings go down to zero or close to
zero.
Clear the "clutter" from
your dash by wiring your
radar detector straight into
your fuse box.
Innovative Design
And
Precision Manufacturing
For
more
information
please
vi
sit
WWW
.
MIRRORTAP
.
COM
©2014 J28 Design Inc.
01
/14
7
28028
16213
4
HardTap Power Cord
Radar Detector Hardwire Kit
With In-line Fuse
RJ11
CONNECTOR X 8' OVERALL LENGTH
WITH 2 AMP FUSE


Produkt Specifikationer

Mærke: BlendMount
Kategori: Detektor
Model: HT-1096

Har du brug for hjælp?

Hvis du har brug for hjælp til BlendMount HT-1096 stil et spørgsmål nedenfor, og andre brugere vil svare dig