Canarm CEP110 Manual

Canarm Ikke kategoriseret CEP110

Læs gratis den danske manual til Canarm CEP110 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 3 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 2 anmeldelser. Har du et spørgsmål om Canarm CEP110, eller vil du spørge andre brugere om produktet?

Download PDF
Side 1/8
Page 1 of 6
M-CEP 11/24
CEP SERIES
ULTRA QUIET CEILING EXHAUST FAN
MODELS: CEP80, CEP110, CEP150
The purpose of this manual is to aid in the proper installation and operation of the CEP Series ceiling exhaust fans. These instructions
are intended to supplement good general practices and are not intended to overwrite local codes and ordinances.
IT IS THE RESPONSIBILITY OF THE PURCHASER TO ENSURE THAT THE INSTALLATION AND MAINTENANCE OF THIS
EQUIPMENT IS HANDLED BY QUALIFIED PERSONNEL.
Inspect all shipments carefully for damage. THE RECEIVER MUST NOTE ANY DAMAGE ON THE CARRIER’S BILL OF LADING AND
FILE A CLAIM IMMEDIATELY WITH THE FREIGHT COMPANY.
For quiet and efficient operation, long life, and attractive appearance - lower or remove grille and vacuum interior of unit with the dusting
brush attachment.
The motor is permanently lubricated and never needs oiling. If the motor bearings are making excessive or unusual noises, replace the
motor with the exact service motor. The impeller should also be replaced.
Use this unit only in the manner intended by the manufacturer. If you have 1.
questions, contact the manufacturer at the address or telephone number listed in
the warranty.
Before servicing or cleaning unit, switch power off at service panel and lock the 2.
service disconnecting means to prevent power from being switching on
accidentally. When the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the service panel.
Installation work and electrical wiring must be done by a qualified person(s) in 3.
accordance with all applicable codes and standards, including fire-rated
construction codes and standards.
Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to 4.
prevent backdrafting. Follow the heating equipment manufacturer’s guideline and safety standards such as those published by the
National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning Engineers
(ASHRAE), and the local code authorities.
When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities. 5.
Ducted fans must always be vented to the outdoors. 6.
Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault Circuit Interrupter) - protected branch circuit. 7.
This unit must be grounded. 8.
For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. 9.
This product is designed for installation in ceilings up to a 12/12 pitch (45 degree angle). Duct connector must point up. 10.
To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit. 11.
Please read specification label on product for further information and requirements. 12.
Do not use in a cooking area. 13.
WARNING: To Reduce The Risk Of Fire Or Electric Shock, Do Not Use This Fan With Any Solid-State Speed Control Device. 14.
The fan must not be installed in a ceiling thermally insulated to a value greater than R40. 15.
Please follow all applicable national, state/provincial and local codes. All of them will supersede this manual. 16.
Failure to follow the safety instructions in this manual may cause serious injury or death due to electrical shock or high 17.
speed rotating parts.
GENERAL SAFETY
CLEANING AND MAINTENANCE
Use an on/off switch to operate this fan. See Electrical Wiring Connection section for details.
OPERATION
OPERATION INSTRUCTIONS AND PARTS MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS
CEP SERIES
ULTRA QUIET CEILING
EXHAUST FAN
OPERATION INSTRUCTIONS AND PARTS MANUAL
PLEASE READ AND SAVE THESE INSTRUCTIONS
Page 2 of 6
M-CEP 11/24
CEP SERIES
ULTRA QUIET CEILING EXHAUST FAN
1. Do not use in a cooking area.
2. Two ways to connect ductwork to a factory-shipped unit.
PLAN THE INSTALLATION
1. Sliding hanger bars have been provided, which allow the housing to
be positioned accurately anywhere between the framing. The bars span
up to 24 inches and can be used on all types of framing: I-joist, standard
joist, and truss construction. Slide hanger bars onto housing and adjust
as needed to fit between framing.
2. Extend the hanger bars to the width of the framing. Position the
ventilator with the bottom edge of the hanger bar tabs flush with the
bottom edge of the framing, holding the ventilator in place. Secure
hanger bars to framing using one screw on each end of hanger bar.
Select a proper hole and secure the hanger bars together using one
screw.
3. Install round ductwork. Connect the round ductwork (not included) to
the damper/duct connector, and run the ductwork to a roof or wall cap
(not included). Using tape (not included), secure all the ductwork
connections so that they are air tight. The ducting from this fan to the
outside of building has a strong effect on the air flow, noise and energy
use of the fan. Use the shortest, straightest duct routing possible for
best performance, and avoid installing the fan with smaller ducts than
recommended. Insulation around the ducts can reduce energy loss and
inhibit mold growth. Fans installed with existing ducts may not achieve
their rated air flow.
ASSEMBLY INSTRUCTIONS
ROUND
DUCT*
WALL CAP*
(with built-in
damper)
* Purchase
separately
POWER
CABLE*
INSULATION*
(Place around and
over Fan Housing.)
Seal gaps
around
Housing.
ROUND
ELBOW(S) *
Seal duct
joints with
tape.
ROOF CAP*
(with built-in
damper)
Keep duct
runs short
FAN
HOUSING
Hanger Bar
screw

Produkt Specifikationer

Mærke: Canarm
Kategori: Ikke kategoriseret
Model: CEP110

Har du brug for hjælp?

Hvis du har brug for hjælp til Canarm CEP110 stil et spørgsmål nedenfor, og andre brugere vil svare dig


Ikke kategoriseret Canarm Manualer

Canarm

Canarm CBFI300 Manual

17 September 2025
Canarm

Canarm C50 Manual

17 September 2025
Canarm

Canarm CNPD100-3 Manual

17 September 2025
Canarm

Canarm CEP110 Manual

17 September 2025
Canarm

Canarm CP50 Manual

17 September 2025
Canarm

Canarm P14-4M Manual

16 September 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Vestil

Vestil E-MT-6 Manual

17 September 2025
Vestil

Vestil LAD-MM-8 Manual

17 September 2025
Vestil

Vestil FLOW-4-3 Manual

17 September 2025
Vestil

Vestil LAD-MM-4-G Manual

17 September 2025
Lakeside

Lakeside 6205 Manual

17 September 2025
Vestil

Vestil AS-383-4PK Manual

17 September 2025
Turbo Air

Turbo Air TBC-80SB-N Manual

17 September 2025
Vestil

Vestil PNU-3060 Manual

17 September 2025
Blodgett

Blodgett Invoq 61BG Manual

17 September 2025
Vestil

Vestil LAD-FM-84-PSO Manual

17 September 2025