Chamberlain 041-0185-000 Manual


Læs nedenfor 📖 manual på dansk for Chamberlain 041-0185-000 (6 sider) i kategorien Ikke kategoriseret. Denne guide var nyttig for 34 personer og blev bedømt med 4.5 stjerner i gennemsnit af 2 brugere

Side 1/6
Logic Board and End Panel Replacement
Repair Parts 041-0184-000 and 041-0185-000
Installation
NOTE: The images throughout this manual are for reference only and
your product may look different.
1. Unplug garage door opener and unplug battery (if necessary)
2. Remove the plastic door and place in a safe spot (A)
3. Remove the 4 screws (pointy screws), place sheet metal end panel
cover in a safe spot (B)
4. Remove the 5 screws (non-pointy screws)
5. Partially remove end panel (C)
6. Disconnect logic board wire connectors
7. Completely remove end panel
8. Unscrew logic board fasteners
9. Remove logic board from end panel
10. Screw in new logic board to end panel
11. Reconnect logic board wire connectors
12. Screw end panel back into garage door opener using the non-pointy
screws
13. Screw end panel cover back into garage door opener using the pointy
screws
To prevent possible SERIOUS INJURY or DEATH:
Disconnect ALL electric and battery power BEFORE performing
ANY service or maintenance.
To prevent damage to the receiver/logic board, DO NOT touch printed
circuit board of replacement receiver/logic board during installation.
ALWAYS wear protective gloves and eye protection when changing
the battery or working around the battery compartment.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov.
Logic Board
End Panel Receiver
Logic Board
End Panel Cover
Control Panel Door
PART
NUM
BER:
SERIAL NUMBER
DAT
E:
SS
IC: 2666 A -
FCC
ID:
100W Max
26
W
Max
C
ONT
A
INS
:
FC
C ID: C
O
FWMNBM11
IC:
102
3
9A-W
M
NB
M1
1
®
BC
D
RED
WHITE
WHITE
GREY
Wire
Channel
Antenna
wires
Logic Board
End Panel
Wire
Harnesses
Receiver
Logic
Board
Antenna wires
routing
To insert or
remove the
wires from the
terminal, push
in the tab with a
screwdriver tip.
A
LiftMaster Brand Garage Door Opener
14. Locate the label in the box with the same brand as your current(D)
product. Place this label on your end panel and with a permanent
marker, update the label with the information from the product on
your old end panel. Discard the old end panel
15. Attach plastic door back in place
16. Plug garage door opener and battery (if necessary)


Produkt Specifikationer

Mærke: Chamberlain
Kategori: Ikke kategoriseret
Model: 041-0185-000

Har du brug for hjælp?

Hvis du har brug for hjælp til Chamberlain 041-0185-000 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Chamberlain Manualer

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer