Main Enclosure Replacement
Repair parts 041-0190-000, 041-0191-000, and 041-0207-000
Instructions
You will need:
• 1/4" magnetic nut driver
• Long-nosed pliers
• 5/16" long-shafted magnetic nut driver and socket
• Flathead screwdriver
The images throughout this manual are for reference only and your
product may look different.
1. Unplug garage door opener and unplug battery (if necessary)
2. Remove the plastic doors from both sides and place in a safe spot
(Figure A)
3. Remove the end panel covers from both sides and place in a safe spot
(Figure B, Item B)
4. Take 4 or 6 screws out of sides depending on model
5. Remove Integrated LED Light Module (Figure B, Item E)
6. Unplug Integrated LED Light Module (and camera if necessary) and
place in a safe spot
7. Remove 4 screws from logic board side end panel (non-pointy screws)
(Figure B, Item C)
8. Partially remove end panel
9. Disconnect logic board wire connectors (Figure B, Item D)
10. Completely remove end panel and place in a safe spot
11. Remove 4 screws from the other end panel and place in a safe spot
12. Remove nal 2 screws from chassis to detach the main enclosure cover
you are replacing
To prevent damage to the receiver/logic board, DO NOT touch printed
circuit board of replacement receiver/logic board during installation.
ALWAYS wear protective gloves and eye protection when changing
the battery or working around the battery compartment.
To prevent possible SERIOUS INJURY or DEATH:
• Disconnect ALL electric and battery power BEFORE performing
ANY service or maintenance.
WARNING: This product can expose you to chemicals including
lead, which are known to the State of California to cause cancer
or birth defects or other reproductive harm. For more information
go to www.P65Warnings.ca.gov.
13. Replace main enclosure cover
14. Replace end panels to both sides using 4 screws on each side (non-
pointy screws)
15. Plug in Integrated LED Light Module (and camera if necessary)
16. Reattach module using 4 or 6 screws removed in step 4
17. Reattach end panel covers with 4 screws on each side (pointy screws)
18. Reattach plastic doors
19. Plug in garage door opener and battery (if necessary)
Control Door Panel
End Panel Cover
End Panel Logic Board Wire Connectors
LED Light Module
Figure B
Figure A
A
BC
D
E
© 2021, LiftMaster
All rights reserved
Tous droits réservés
Todos los derechos reservados
114-5583-000
