Chapin 20075 Manual


Læs gratis den danske manual til Chapin 20075 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 12 personer og har en gennemsnitlig bedømmelse på 4.2 stjerner ud af 6.5 anmeldelser. Har du et spørgsmål om Chapin 20075, eller vil du spørge andre brugere om produktet?

Side 1/2
1. Assembly
Attach extension wand to shut-off handle.
Firmly insert the outlet tube portion into the tank adapter (Fig. 1B) leaving no gap between the
tank adapter and outlet tube adapter. Firmly tighten the retaining nut to the tank adapter (Fig. 1C).
To prevent hose from blowing off, hose must cover both barbs on the outlet tube
adapter and touch flange (Fig. 1B) before hose nut is securely tightened (Fig. 1C).
4. Pressurizing and Spraying
Do: Turn handle
tighten. Push
handle down, turn
1/4 turn counter-
release.
4A
Do: Push handle,
down, turn 1/4 turn
clockwise to lock.
Begin spraying.
Re-pump sprayer as
required to maintain
spray force.
4C
Do: Pump
until you feel
resistance.
4B
Do: Turn end of
nozzle to adjust
spray pattern.
4D
1A
1C
Retaining Nut -
Securely tightened.
Tool
Holder
Outlet
Tube
Discharge
Assembly
1B
No Gap
Tank
Adapter
Outlet
Tube
Adapter
Filter
7. Troubleshooting - Tank pressurizes but does not spray.
WARNING:
Release pressure in tank before troubleshooting.
Pull handle
straight up.
Insert notches
from underside of
handle into plunger
grooves and turn
counterclockwise.
Tighten plunger clockwise until flush to top of
shut-off body. Do not over-tighten or unit may
not spray. Slide forks under plunger, push handle
down until it snaps into place.
7A 7B
Handle
7D
Plunger flush
with body
A) Clean shut-off (Fig. 7A- 7D)
1D
1 piece style
B) Clean Nozzle Assembly (Fig. 7E)
-Remove nozzle cap by unscrewing
.
Clean and re-assemble.
7E
Nozzle Cap
Sk-1157-1
WARNING: Improper use or failure to follow instructions can result in explosive failure causing serious
eye or other injury. For safe use of this product you must read and follow all instructions. Do not leave a
pressurized sprayer in the hot sun. Heat can cause pressure build-up resulting in possible explosion. Do not
store or leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants and full
foot protection when spraying. Never use any tool to remove pump if there is pressure in sprayer. Never stand
with face or body over top of tank when pumping or loosening pump to prevent ejecting pump assembly
and/or solution from striking and injuring you. Never pressurize sprayer by any means other than original
pump. Do not attempt to modify this sprayer. Replace parts only with manufacturer’s original parts. This
sprayer is designed for use with bleach solutions only. Never use or mix bleach or solutions containing
bleach with other household chemicals such as toilet bowl cleaners, rust removers, acids or ammonia
containing products. Never spray flammable, acidic, caustic or other corrosive solutions or heat,
pressure, or gas producing chemicals. Always read and follow chemical manufacturer’s instructions
before use with this sprayer as some chemicals may be hazardous when used with this sprayer.
Parts, Piezas, Pièces
6-2001
Hose Kit: 2 nuts, 2 barbs and hose
Juego de manguera: 2 tuercas ,2 lengüetas y manguera.
Nécessaire de tuyau: Deux écrous, deux ardillons et tuyau
6-2000
Shut-off Handle
Mango de cierre
Poignée du robinet
6-6003
Nozzle
Boquilla
Buse
6-7749
Extension wand
Vara de extensión, Lance de rallonge
Remove plunger, diaphragm and spring.
Wash diaphragm with mild detergent.
Reassemble: Hold shut-off upright
as shown, place spring in hole, place
diaphragm on top of spring.
Reassemble plunger and tighten.
7C
Plunger
Spring
Diaphragm
WARNING
Congratulations!
You have just purchased a quality Chapin product.
Register Your Sprayer Online @ www.chapinmfg.com Questions? Do Not Return To Store.
Call us @ 1-800-950-4458 or www.chapinmfg.com
6-1925
Repair Parts Kit Gaskets and Seals (not included),
Juego de piezas de reparación, empaquetaduras y juntas (no incluido)
Kit de pièces de réparation, joints et garniture d’étanchéité (non inclus)
Note: Your particular sprayer may not include all parts pictured above.
Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.
Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.
2. Pre-Use Check
1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.
2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are
found, replace hose before using. Replace with original manufacturer’s parts only.
3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and
exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration indicates
possible tank weakening and could result in explosive bursting under pressure. If any of these
signs are found, discard tank immediately and replace. Do not attempt to patch leaks, etc., as this
could result in serious injury.
4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only
(Pump plunger 10-20 strokes and inspect for leaks).
5) Do: Direct shut-off away from you and open to make sure discharge is not clogged.
6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank,
and proceed with Filling, Pressurizing and Spraying Instructions.
7) Do: Inspect all metal parts including the wand, nozzle and fittings for rust, corrosion and pitting.
If any of these conditions are found, replace affected part with original manufacturer’s part
before using.
3. Filling
1) Do: Turn pump handle counterclockwise and remove pump
2) Do: Prepare spray solution following all directions and safety warnings on chemical label.
3) Do: Fill tank to no more than the proper gallon marker. Do NOT: over fill to accommodate pump.
4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and
tighten securely.
WARNING
5. To Release Pressure
Do: With pump facing away, turn locked handle counterclockwise until air begins to escape.
Stop turning handle when you hear air escaping. Do: Point pump away until all air escaped.
6. Care, Storage and Maintenance
1) Do: Follow chemical manufacture’s instructions for cleaning. Rinse thoroughly with
recommended solvent. Follow Filling, Pressurizing and Spraying Instructions, except pump unit
only 8-10 strokes. Be sure that the wand and nozzle are thoroughly rinsed after each use.
2) Do: Open shut-off and allow recommended solvent to run through discharge assembly.
3) Do: Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer.
4) Do: Store sprayer tank upside down, with pump removed, in a warm dry location.
5) Do: Periodically oil pump by dropping 10-12 drops of light oil down pump rod through opening
in cover.
P.O. Box 549 700 Ellicott St.
Batavia, NY 14021-0549 U.S.A.
1-800-950-4458 www.chapinmfg.com
017532R0923
20074, 20075, 20078, 22074


Produkt Specifikationer

Mærke: Chapin
Kategori: Ikke kategoriseret
Model: 20075
Vægt: 1140 g
Produktfarve: Hvid
Volumen: 4000 ml
Driftstryk: 4 bar

Har du brug for hjælp?

Hvis du har brug for hjælp til Chapin 20075 stil et spørgsmål nedenfor, og andre brugere vil svare dig




Ikke kategoriseret Chapin Manualer

Chapin

Chapin 20020 Manual

17 September 2025
Chapin

Chapin 60105 Manual

27 August 2025
Chapin

Chapin 82500B Manual

27 August 2025
Chapin

Chapin 25010 Manual

26 August 2025
Chapin

Chapin 1380 Manual

26 August 2025
Chapin

Chapin 97902 Manual

22 Juni 2025
Chapin

Chapin 4720 Manual

20 Juni 2025
Chapin

Chapin 60124 Manual

20 Juni 2025
Chapin

Chapin 4163 Manual

20 Juni 2025
Chapin

Chapin 84700A Manual

20 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer