Chapin 4720 Manual

Chapin Ikke kategoriseret 4720

Læs gratis den danske manual til Chapin 4720 (8 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.8 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Chapin 4720, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/8

Model 4710

1 Gallon

Model 4720

2 Gallon

Chapin International, Inc

P.O. Box 549 700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.

1-800-950-4458 www.chapinmfg.com

Model: 4710, 4720

015693R0821

Carefully Read These Instructions Before Use

WARNING

Use and Care Manual

DO NOT RETURN TO STORE

Call: 1-800-950-4458

www.chapinmfg.com

FERTILIZER INJECTORS

See website for warranty details

INSTALLATION INSTRUCTIONS:

• Use of a backﬂow preventer per local codes.

• Install this device downstream of a backﬂow preventer. Backﬂow preventer sold separately.

Use Chapin part number 6-9089.

• WARNING: Line inlet water pressure should not exceed 60PSI. Pressure over 60PSI will result in damage to

the tank and head. If line pressure exceeds 60PSI, install a pressure regulator on the inlet side of the injector.

• For best results position the tank on a level surface.

• Ensure all hose washers are in place and hand tighten connections ﬁrmly.

• Connect the female swivel end to the water inlet.

Connect your system hose to the male garden hose connection on the discharge side of the device.

• Keep out of direct sunlight.

• Screw on the ball valve to the threaded ﬁtting on the bottom of the tank.

MAKING TUBING CONNECTIONS:

Tubing connections must be made between the injector manifold and the top of the clear tank lid. Prior to

making ﬁnal end connections it is important that both the inlet and outlet tube pass thru the center of the black

cap.

1. Two pieces of tubing are provided and can be cut to a shorter length if desired.

2. Connect the inlet tube from the injector manifold side port marked “1” to the IN port marked “1” on the clear

tank lid.

3. Connect the outlet tube from the OUT port “2” on the clear tank lid to the bottom port marked “2” on the

injector manifold.

4. Connections are made by sliding the tube over the barb ﬁttings and securing the tubing using the clamps

provided.

OPERATING INSTRUCTIONS:

• Turn off the inlet water pressure.

• Open the valve on the bottom of the clear tank to ensure it is empty. Close the valve.

Loosening of the top cap will allow the unit to drain quicker.

• For ﬁlling liquid fertilizer: Unscrew the cap and lid and slowly pour fertilizer product into the tank.

Re-install the cap and lid and tighten.

• For ﬁlling granulated concentrate: Unscrew the cap and lid. Move it to the side allowing the inlet tube to

remain in the tank. Fill half way with product. Re-install the cap and lid and tighten.

• The injector is designed to work best with a water ﬂow rate above 1 gallon per minute. At 1 GPM

or above. the device is designed to feed the liquid fertilizer at a rate of approximately 1 ounce of

fertilizer per gallon of water ﬂowed.

• For dilution rates less than 1 oz/gal, premix the product prior to ﬁlling the tank. Follow

recommended dilution rates for the fertilizer being used.

• Empty the tank and leave the bottom drain valve open when freezing conditions are present.

• When watering without fertilizer, it is not necessary to disconnect this device.

WHEN USING GRANULAR PRODUCTS:

For best results when using granular products, dissolve product in water before ﬁlling the HydroFeed™

tank. Example: Mix 1 cup of granular fertilizer with 24 oz of water, or 1.25 cups for 32 oz. Stir to dissolve.

Fill tank.

Note: This is not the dilution ratio for application. The fertilizer is still a concentrated solution. Your

HydroFeed™ fertilizer injector will automatically deliver 1 oz of concentrated fertilizer per 1 gallon of

water. Always refer to the chemical manufacturer’s instructions for recommended application and

coverage information.

IMPROPER USE OR FAILURE TO FOLLOW INSTRUCTIONS CAN RESULT IN PRODUCT FAILURE OR

INJURIES. FOR SAFE USE OF THIS PRODUCT YOU MUST READ AND FOLLOW ALL INSTRUCTIONS

BEFORE USING.

Chapin Operator’s Manual - English

WARNING

Produkt Specifikationer

Mærke:	Chapin
Kategori:	Ikke kategoriseret
Model:	4720

Har du brug for hjælp?

Hvis du har brug for hjælp til Chapin 4720 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Chapin Manualer

22 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

19 Juni 2025

19 Juni 2025

19 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Advantech WISE-2410 Manual

12 August 2025

Rowenta Semi Shielded BU5520 Manual

12 August 2025

Milwaukee M18 HAMMERVAC 2715-DE Manual

12 August 2025

Ingenico AXIUM DX8000 Manual

12 August 2025

Gazebo Penguin 41212MR-12 Manual

12 August 2025

Rowenta Compacteo RO173301 Manual

12 August 2025

Flex MWL 150 4 Manual

12 August 2025

Rowenta Gourmet OC7850 Manual

12 August 2025

Dito Sama 600450 Manual

12 August 2025

Advantech MIC-711D-OX3A1 Manual

12 August 2025