Chapin 1380 Manual

Chapin Ikke kategoriseret 1380

Læs gratis den danske manual til Chapin 1380 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.9 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Chapin 1380, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

5. Pressurizing and Spraying

8. Care, Storage and Maintenance

1) Do: Rinse tank thoroughly with water only, empty, reﬁll with water. Follow Filling, Pressurizing

and Spraying Instructions, except pump unit only 8-10 strokes. Be sure that the wand and nozzle

are thoroughly rinsed with water after each use.

2) Do: Open shut-off and allow water to run through discharge assembly.

3) Release pressure (Follow Pressure Release Instructions), remove pump and empty sprayer. Do:

4) Store sprayer tank upside down, with pump removed, in a warm dry location. Do:

5) Periodically oil pump by dropping 10-12 drops of light oil down pump rod through Do:

opening in cover.

2-1051-59 (A) R0121

2. Nozzle

Attach nozzle to shut-off handle or extension wand.

6-4627

Repair Parts Kit Gaskets and Seals (not included),

Juego de piezas de reparación, empaquetaduras y juntas (no incluido)

Kit de pièces de réparation, joints et garniture d’étanchéité (non inclus)

Make sure hose is pushed all the way to the tank.

Make sure hose clamp is tight and below the hose barb.

Turn clockwise with a screwdriver to tighten.

Hose Barb

1. Hose to Tank

Pump until you

feel resistance.

Turn handle

clockwise to

tighten.Push handle

down, turn 1/4 turn

counterclockwise to

release.

Push handle,

down, turn 1/4 turn

clockwise to lock.

Begin spraying.

Re-pump sprayer as

required to maintain

spray force.

Adjust spray pattern

by turning nozzle

cap. Do not turn cap

more than 2 turns

or cap may come

off allowing spray

material to spray

back on you.

7. To Release Pressure

1) Do: With pump facing away, turn locked handle counterclockwise until air begins to escape.

Stop turning handle when you hear air escaping.

2) Do: Stay away from the sprayer until all air has escaped.

Sk-1154-1

WARNING: Improper use or failure to follow instructions can result in explosive failure causing serious

eye or other injury.

For safe use of this product you must read and follow all instructions. Do not leave

a pressurized sprayer in the hot sun. Heat can cause pressure build-up resulting in possible explosion.

Do not store or leave solution in tank after use. Always wear goggles, gloves, long sleeve shirt, long pants

and full foot protection when spraying. Never use any tool to remove pump if there is pressure in sprayer.

Never stand with face or body over top of tank when pumping or loosening pump to prevent ejecting pump

assembly and/or solution from striking and injuring you. Never pressurize sprayer by any means other than

the original pump. Do not attempt to modify this sprayer. Replace parts only with manufacturer’s original

parts. Never spray ﬂammable, caustic, acidic, chlorine, bleach or other corrosive solutions or heat,

pressure, or gas producing chemicals. Always read and follow chemical manufacturer’s instructions

before use with this sprayer as some chemicals may be hazardous when used with this sprayer.

6. Fatigue-Free Spraying

For constant spraying, push down on shut-off handle and

move locking mechanism away from you. To release,

squeeze handle and move the locking mechanism back

towards you.

5A 5B 5C 5D

2B2A

Parts, Piezas, Pièces

6-6136

Hose

Manguera

Tuyau

6-3337

Carrying Strap

Correa para cargar

Sangle de transport

6-6000

Nozzle

Tobera

Buse

6-1866

Shut-off Handle

Mango de cierre

Poignée du robinet

6-7711

Extension wand

Vara de extensión, Rallonge

WARNING

To ensure the long life of your sprayer, after every use thoroughly rinse the tank, funnel and pump when

cleaning your sprayer. Residual chemical can attack the seals, metal and TriPoxy coating.

Avoid chipping and/or denting of the inside and outside of the tank. Any exposed steel is prone to chemical

attack and can cause poor performance or even failure.

Never store sprayer with chemical left in the tank and thoroughly clean after each use. Seek out Chemical

manufacturer’s instructions for speciﬁc chemical compatibility information.

CAUTION

Note: Your particular sprayer may not include all parts pictured above.

Nota: Es posible que este pulverizador en particular no incluya todas las partes que se ilustran arriba.

Remarque : Votre pulvérisateur particulier pourrait ne pas inclure toutes les pièces illustrées plus haut.

Congratulations!

You have just purchased a quality Chapin product.

Call us @ 1-800-950-4458 or www.chapinmfg.com

P.O. Box 549 700 Ellicott St.

Batavia, NY 14021-0549 U.S.A.

1-800-950-4458 www.chapinmfg.com

3. Pre-Use Check

1) Do: Check tightness of hose nut to be sure hose is securely attached to the tank outlet.

2) Do: Inspect hose for deterioration, cracks, softness, or brittleness. If any of these conditions are

found, replace hose before using. Replace with original manufacturer’s parts only.

3) Do: Remove pump (see Filling, Pressurizing and Spraying Instructions), inspect interior and

exterior of tank for signs of deterioration of body and bottom. Any sign of deterioration indicates

possible tank weakening and could result in explosive bursting under pressure. If any of these

signs are found, discard tank immediately and replace. Do not attempt to patch leaks, etc., as this

could result in serious injury.

4) Do: Follow Filling, Pressurizing and Spraying Instructions, except use water only

(Pump plunger 10-20 strokes and inspect for leaks).

5) Do: Direct shut-off away from you and open to make sure discharge is not clogged.

6) Do: If unit passes this test, release pressure (see Pressure Releasing Instructions), empty tank,

and proceed with Filling, Pressurizing and Spraying Instructions.

7) Do: Inspect all metal parts including the wand, nozzle and ﬁttings for rust, corrosion and pitting.

If any of these conditions are found, replace affected part with original manufacturer’s part

before using.

4. Filling

1) Do: Turn pump handle counterclockwise and remove pump.

2) Do: Prepare spray solution following all directions and safety warnings on chemical label.

3) Do: Fill tank to no more than the proper gallon marker. over ﬁll to accommodate pump.Do NOT:

4) Do: Check pump to make sure that no grass or dirt is stuck to barrel. Replace pump in tank and

tighten securely.

Produkt Specifikationer

Mærke:	Chapin
Kategori:	Ikke kategoriseret
Model:	1380

Har du brug for hjælp?

Hvis du har brug for hjælp til Chapin 1380 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret Chapin Manualer

2 Januar 2026

17 September 2025

27 August 2025

27 August 2025

26 August 2025

26 August 2025

22 Juni 2025

20 Juni 2025

20 Juni 2025

20 Juni 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

NUX Mighty 20 BT Manual

2 Januar 2026

WAC Lighting H-LED160 Manual

2 Januar 2026

Mikrotik DynaDish 6 Manual

2 Januar 2026

SIME Murelle Equipe 70 ErP Manual

2 Januar 2026

Signature Hardware Sheba 462905 Manual

1 Januar 2026

Jones Stephens B0RPZLCP Manual

1 Januar 2026

NUX Stageman NMP-4 Manual

1 Januar 2026

WAC Lighting R4RNT-25 Manual

1 Januar 2026

Delta H777 Manual

1 Januar 2026

Kogan NBELENGRAVA Manual

1 Januar 2026