Cotech 36-6077 Manual

Cotech Lys 36-6077

Læs gratis den danske manual til Cotech 36-6077 (5 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 7 personer og har en gennemsnitlig bedømmelse på 4.4 stjerner ud af 4 anmeldelser. Har du et spørgsmål om Cotech 36-6077, eller vil du spørge andre brugere om produktet?

Side 1/5
UNITED KINGDOM CUSTOMER SERVICE
tel 020 8247 9300 customerservice@clasohlson.co.uk www.clasohlson.co.uk 10 13 Market Place, Kingston upon Thames, Surrey, KT1 1JZe-mail internet postal
Ver. 20181204
Ceiling Light
Art.no 36-6077
Please read theentire instruction manual before using
theproduct and then save it for future reference. We reserve
theright for any errors in text or images and any necessary
changes made to technical data. In theevent of technical
problems or other queries, please contact our Customer
Services.
Safety
Installation should only be carried out by aqualified electrician.
Theproduct is only intended for indoor use.
Theproduct must be installed in accordance with current
safety regulations to prevent life-threatening accidents.
Theproduct is intended for fixed installation.
Theproduct is intended for ceiling installation.
The luminous flux (brightness) of the ceiling light can be
adjusted by setting the DIP switches as shown in the table.
Luminous
flux (lm)
Power (W) 1 2
1100 14.5 − −
800 10.5 ON −
500 6.6 ON ON
Care and maintenance
Switch off thepower to theceiling light before cleaning.
Clean thelight by wiping it with asoft, damp cloth. Use
amild detergent. Never use solvents or strong, abrasive
cleaning agents.
Responsible disposal
Only intended for indoor use (IP44).
If theplastic diffuser is damaged it must
be replaced.
Minimum distance from combustible
material: 0.1 m.
Warning: Make sure that thepower
is shut off before starting
theinstallation.
Installation
Fixings
If thesupplied fixings are not suitable for thematerial which
your ceiling is made of, use appropriate fixings which will
guarantee afirm anchorage.
Note: If you need to drill into theceiling, make sure to avoid
any concealed electrical wiring.
1. Open theceiling light by twisting thediffuser anticlockwise
and removing it.
2. Remove theplate holding theLED light by undoing
the3 retaining screws.
3. Knock out one of thepre-cut cable entries and fit
thecable gland.
4. Pull thepower supply cable through thecable gland.
5. Fasten theceiling light directly to theceiling using
the4 outermost mounting holes or fasten it to aceiling
rose using the2 innermost mounting holes.
6. Connect thepower supply cable to theterminal block as
shown below.
7. Re-assemble theceiling light in reverse order.
This ceiling light can be interconnected with multiple light
fittings of thesame article number (36-6077) or with motion
sensor ceiling lights (36-6078).
Thelight source in this product must
only be replaced by themanufacturer,
aqualified service facility or aqualified
technician.
This symbol indicates that this product should
not be disposed of with general household
waste. This applies throughout the entire EU.
In order to prevent any harm to the environment
or health hazards caused by incorrect waste
disposal, the product must be handed in for
recycling so that the material can be disposed
of in a responsible manner. When recycling
your product, take it to your local collection
facility or contact the place of purchase.
They will ensure that the product is disposed
of in an environmentally sound manner.
Specifications
Rated voltage 220–240V AC, 50/60Hz
Light source Built in LED
Power 14.5W
IP rating IP44
Colour temperature 3000K
Colour rendition Ra 80
Luminous flux 1100 / 800 / 500 lm
Operating temperature −30°C ~ +40°C
Diam 34cm
ON
1 2


Produkt Specifikationer

Mærke: Cotech
Kategori: Lys
Model: 36-6077

Har du brug for hjælp?

Hvis du har brug for hjælp til Cotech 36-6077 stil et spørgsmål nedenfor, og andre brugere vil svare dig