Cotech K-NCF-LN10W Manual

Cotech Lys K-NCF-LN10W

Læs gratis den danske manual til Cotech K-NCF-LN10W (5 sider) i kategorien Lys. Denne vejledning er vurderet som hjælpsom af 35 personer og har en gennemsnitlig bedømmelse på 4.6 stjerner ud af 18 anmeldelser. Har du et spørgsmål om Cotech K-NCF-LN10W, eller vil du spørge andre brugere om produktet?

Side 1/5
UNITED KINGDOM CUSTOMER SERVICE
tel 020 8247 9300 customerservice@clasohlson.co.uk www.clasohlson.co.uk 10 13 Market Place, Kingston Upon Thames, Surrey, KT1 1JZe-mail internet postal
Ver. 20181101
LED Ceiling Light
Art.no 36-7306-1 Model K-NCF-LN10W
36-7306-2 K-NCF-LN20W
Please read theentire instruction manual before use and
then save it for future reference. Wereserve theright for any
errors in text or images and any necessary changes made
queries, please contact our Customer Services.
Safety
The light source of this luminaire is not replaceable: when the
light source reaches its end of life the whole luminaire shall be
replaced.
2. Open theendpiece.
3. Remove theend
piece and take off
theplasticcover.
Responsible disposal
Thelight fitting is Class 1 rated and must therefore be
earthed.
The light source is not suitable for use with a dimmer.
Warning:
This light fitting is only suitable for permanent installation
and should be installed by aqualified electrician.
Thelighttting should be mounted out of thereach.
Ensure proper footing and balance at all times during
installation.
Whenever installing any electrical products, basic
safety precautions should always be observed to avoid
therisk of fire, electric shock and personal injury.
Installation
Warning:
1. Before beginning any electrical installation
always disconnect thepower to thecircuit
you are working on, either by turning off
themain circuit breaker or by removing
thefuse from theconsumerunit.
4. Using thelight fitting as atemplate mark out where you
may need to drill/screw.
Warning: Make sure that thewall has no concealed
electrical wiring, gas or water pipes before drilling/
screwing. Useanappropriate fastening method for
thesurface in question.
5. Make ahole in one of thesilicone plugs in theendpiece.
Pullthesupply cable through and connect it to
theterminalblock.
6. Turn thepoweron.
Use thesame installation procedures described above to
connect several light fittings in series (36-7306-1 Max 10, and
36-7306-2 Max 5).
This symbol indicates that this product
should not be disposed of with general
householdwaste. Thisapplies throughout
theentire EU. Inorder to prevent any harm to
theenvironment or health hazards caused by
incorrect waste disposal, theproduct must
be handed in for recycling so that thematerial
can be disposed of in aresponsible manner.
Whenrecycling theproduct, take it to your
local collection facility or contact theplace of
purchase. Theywill ensure that theproduct is
disposed of in anenvironmentally sound manner.
Specifications
36-7306-1
Rated voltage 220–240 V AC, 50/60Hz
Light source LED 13 W
Colour temperature 3000 K
Colour rendition (Ra) > 80
Luminous flux 1000lm
Beamangle 110°
IP rating IP21
Size 600×165×66mm
36-7306-2
Rated voltage 220–240 V AC, 50/60Hz
Light source LED 24 W
Colour temperature 3000 K
Colour rendition (Ra) > 80
Luminous flux 1800lm
Beamangle 110°
IP rating IP21
Size 1200×165×66mm


Produkt Specifikationer

Mærke: Cotech
Kategori: Lys
Model: K-NCF-LN10W

Har du brug for hjælp?

Hvis du har brug for hjælp til Cotech K-NCF-LN10W stil et spørgsmål nedenfor, og andre brugere vil svare dig