Crestron CLXI-2DIMFLV8 Manual

Crestron Ikke kategoriseret CLXI-2DIMFLV8

Læs gratis den danske manual til Crestron CLXI-2DIMFLV8 (2 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 22 personer og har en gennemsnitlig bedømmelse på 4.0 stjerner ud af 11.5 anmeldelser. Har du et spørgsmål om Crestron CLXI-2DIMFLV8, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/2

CLXI-2DIMFLV8

0-10 Volt 8 Channel Dimmer Module, 2 Feeds, 230V

crestron.com

800.237.2041

>8 channels of 0-10 Volt dimming control for fluorescent ballasts

and LED drivers

>Two independent 4-channel dimmers in a single module

>Dual or single 230 Volt feed

>Arcless switching

>Air-gap relays on every channel output

>Override preset capability

>Convection cooled

>Occupies 1 module space in a CAEN or CAENIB

automation enclosure

>Easy termination using CLTI Series terminal block

>CEC Title 24 2013 Compliant

As part of a complete Crestron

lighting system, the CLXI-2DIMFLV8

lighting control module provides 8 channels of 0-10 Volt dimming control

for fluorescent ballasts and LED drivers. The CLXI-2DIMFLV8 is actually

composed of two independent 4-channel dimmers in a single module.

Each channel is rated for 20 Amps, with a total module rating of 40 Amps

when fed from two separate 20 Amp feeds. Air-gap relays are provided on

every channel output, allowing individual circuits to be serviced without

disabling the entire module.

CLXI Series dimmers are rigorously built for ultimate reliability. Split-

bobbin transformers and ground referenced electronics deliver superior

performance. Lamp flicker is minimized through Crestron’s innovative

zero-crossing detection technique backed by proprietary firmware. Low-

maintenance convection cooling assures quiet and trouble-free operation.

An override feature allows each channel to be adjusted to a preset state

during setup. In the event that Cresnet

communications should be

disrupted for any reason, a simple contact closure can be used to activate

the override presets on a global or semi-global basis.

The CLXI-2DIMFLV8 occupies a single module space in any or CAEN

CAENIB automation enclosure. Termination of high-voltage wiring to the

module is facilitated by a CLTI-2DIMFLV8 terminal block, sold separately to

enable termination of the wiring any time prior to installing the module.

CLXI modules are controlled by the or other 3-SeriesCLX-DIN-AP3

control system via the Cresnet network. A 5-wire link provides bussing of

the Cresnet and override signals between modules within an enclosure

(interconnect jumpers included).

SPECIFICATIONS

Load Ratings

Dimmer Channels: 8

Per Channel: 20 Amps

Per Group: Channels 1-4: 20 Amps;

Channels 5-8: 20 Amps

Module Total: 40 Amps

Load Types: 0-10 Volt fluorescent ballast or LED driver (4-wire)

Power Requirements

220-240 Volts AC, 50/60 Hz, line power

Connectors on Module

Module Interconnect: (2) 5-pin 0.156 inch headers;

Cresnet/Override interconnect ports;

Each connects to a CAEN-BLOCK or the adjacent CLXI-Series module using

the interconnect cable provided

Connections via CLTI Terminal Block (sold separately)

LINE 1 - 2: (2) DIN rail terminal blocks, brown, line power inputs

DIM 1 - 8: (8) DIN rail terminal blocks, red, channel outputs

N IN 1 - 2: (2) DIN rail terminal blocks, blue, line input neutrals

N OUT 1 - 8: (8) DIN rail terminal blocks, blue, channel output neutrals

Buttons

SETUP: (1) Pushbutton, for manual channel activation and TSID

LED Indicators

PWR: (1) Green LED, indicates line power is applied to the LINE 1 terminal

NET: (1) Yellow LED, indicates communication with the control system

1 – 8: (8) Red LEDs, each indicates the state of the corresponding channel

SETUP: (1) Red LED, indicates unit is in setup/manual mode

Environmental

Temperature: 32° to 104° F (0° to 40° C)

Humidity: 10% to 90% RH (non-condensing)

Heat Dissipation: 45 BTU/hr

Shown with CLTI series terminal block (sold separately) positioned on left side.

Produkt Specifikationer

Mærke:	Crestron
Kategori:	Ikke kategoriseret
Model:	CLXI-2DIMFLV8
Type:	Lysdæmper
Bredde:	170 mm
Dybde:	84 mm
Højde:	176 mm
Relativ luftfugtighed ved drift (H-H):	10 - 90 %
Driftstemperatur (T-T):	0 - 40 °C