CRUX DKGM-49 Manual

CRUX Ikke kategoriseret DKGM-49

Læs gratis den danske manual til CRUX DKGM-49 (4 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 48 personer og har en gennemsnitlig bedømmelse på 4.3 stjerner ud af 24.5 anmeldelser. Har du et spørgsmål om CRUX DKGM-49, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/4

-Retains factory features in select GM LAN 29 Bit vehicles while functioning with an aftermarket radio.

-Pre-programmed to retain factory Steering Wheel Controls.

-iPhone Voice Recognition (VR) feature from SWC on Kenwood, Pioneer, Alpine and JVC radios.

-Supports Pick Up/End Call, Pick Up and Toggle between 1st and 2nd Incoming call, AVRCP Track, Seek.

-Supports Bose, non-Bose and Y-91 audio systems.

-Provides Factory Rear Seat Entertainment Activation. Requires Cable #CRUX2333A

(sold separately).

-Retains backup sensors / park assist system.

-Retains chime functions.

-EIA color coded wiring for easy installation.

1. *NOT compatible with 2012-Up SUVs/Trucks that are equipped with factory-installed Navigation radios.

2. **NOT compatible with Express and Savana vans that are powered by a diesel engine.

3. Supports Rear Entertainment System with special order harness #CJA2333A (sold separately).

4. DOES NOT support ONSTAR.

GM- Module 49

GM-49 Harness

SWC Cables

Antenna Adaptor

CRUX2543

Dash Kit

Rev.072322

1 / 4

SETTING THE AFTERMARKET RADIO BRAND

With the key in the off position, set the DIP switches to the corresponding radio listed below.

3.5MM SWC CABLE

Use the proper 3.5 to 4 pin SWC cable for the aftermarket radio being used:

OPTION A is used for ALPINE, CLARION, (JVC and KENWOOD units will use the Blue/Yellow wire).

OPTION B is used for ATOTO, BOSS, DUAL, FAHRENHEIT, JENSEN, POWER ACOUSTIK, PIONEER,

SONY, SOUND STREAM and most OFF-BRAND headunits.

NOTE: Cap or insulate the 3.5mm plug or Blue/Yellow wire if not being used.

If the vehicle is equipped with a Bose system, the DK - module has a built-in Bose adaptor that allows the GM 49

proper audio input gain from the aftermarket radio to the Bose amplifier. To use this feature, plug in the male 8-pin

connector on the harness to the GRAY female 8-pin connector on the - module. The module is also labeled DKGM 49

“Bose” and “Non Bose” to avoid confusion. (see picture below)

If the vehicle is NOT equipped with a Bose system, plug in the male 8-pin connector to the BLACK female 8-pin on

the GM-49 module.

BOSE

Connection

Non-BOSE

Connection

2 / 4

Rev.072322

Produkt Specifikationer

Mærke:	CRUX
Kategori:	Ikke kategoriseret
Model:	DKGM-49

Har du brug for hjælp?

Hvis du har brug for hjælp til CRUX DKGM-49 stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret CRUX Manualer

CRUX DKGM-16B Manual

3 Januar 2025

CRUX ACPBM-77Y Manual

1 Januar 2025

CRUX ACPMB-45W Manual

1 Januar 2025

CRUX ACPLX-12XW Manual

1 Januar 2025

CRUX ACPBM-77X Manual

1 Januar 2025

CRUX ACPAD-01 Manual

1 Januar 2025

CRUX ACPAD-81Y Manual

1 Januar 2025

CRUX ACPBM-77Z Manual

1 Januar 2025

CRUX ACPMB-50W Manual

1 Januar 2025

CRUX ACPLR-01 Manual

1 Januar 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Smeg CVI120GE Manual

17 Juni 2025

Panduit VS-CKP4-000 Manual

17 Juni 2025

Yamazen LTH-2BH Manual

17 Juni 2025

Philips ASH4511CH Manual

17 Juni 2025

Yamazen MNW-1890CJ Manual

17 Juni 2025

D-Link DMC-700SC Manual

17 Juni 2025

Makita DHP490 Manual

17 Juni 2025

Royal Catering RC-BFWH12030 Manual

17 Juni 2025

Makita TW011G Manual

17 Juni 2025

Philips 50BDL2050Q Manual

17 Juni 2025