CRUX VIMCF-93E Manual

CRUX Ikke kategoriseret VIMCF-93E

Læs gratis den danske manual til CRUX VIMCF-93E (1 sider) i kategorien Ikke kategoriseret. Denne vejledning er vurderet som hjælpsom af 2 personer og har en gennemsnitlig bedømmelse på 4.1 stjerner ud af 1.5 anmeldelser. Har du et spørgsmål om CRUX VIMCF-93E, eller vil du spørge andre brugere om produktet?

Download PDF

Side 1/1

8-PIN

(male plug)

4 5 6

TO ENABLE VIDEO

IN-MOTION

1. On = Enable VIM

2. On = If Factory Back-Up Present

3. Not Used

4. Not Used

5. May Vary

6. May Vary

1 2 3

WHITE/ OPTIONAL

12V OUTPUT

GREEN/ 12V POWER SWITCH

(SAME FUNCTION AS DIP 1)

NON-PERMANENT

FUSE

(NOT INCLUDED)

12V

OPTIONAL/

TOGGLE SWITCH

NOT INCLUDED

4 5 6

1 2 3

TO FACTORY

HARNESS

TO FACTORY

RADIO

22-PIN

(male plug)

22-PIN

(female plug)

VOLUME

TUNE

8.4” RADIO

DISPLAY

WHITE

SAFETY WARNING:

THIS INTERFACE IS DESIGNED TO ACTIVATE

VIDEO IN-MOTION TO ALLOW THE PASSENER

ACCESS TO THE ADDRESS INPUT WHILE THE

VEHICLE IS IN-MOTION. THIS INTERFACE MAY

CAUSE AN ERROR WHEN SERVICED AT THE OEM

DEALER. BE AWARE THAT MOST DEALERS

WILL ATTEMPT TO VOID THE MANUFACTURERS

WARANTY WHEN INSTALLING ANY AFTERMARKET

EQUIPMENT. IMPROPER USE OF THIS INTERFACE

BY THE DRIVER MAY RESULT IN CITATION. DRIVER

MUST KEEP FULL ATTENTION ON THE ROAD AND

RESPOSIBILITY ON THE SAFETY OF HIS

PASSENGERS.

INTERFACING SOLUTIONS

VIDEO IN-MOTION ACTIVATION FOR CHRYSLER 300 2011-2014

CHRYSLER:

2011 - 2014 300

2011 - 2013 Charger

VIMCF-93E

We recommend reading this installation guide rst before starting any

work. Following these instructions from “Start” to” Finish” will ensure

a smooth and hassle free installation. We oer telephone support M-F

9:00 AM – 5:00PM PDT at 1 (855) 822-1348. We are here to help.

PARTS INCLUDED:

(1) CF-93E Interface

(1) CR-93E T-Harness (2598)

(1) Instruction

PRECAUTIONS:

- Remove the negative side of the battery to avoid any short circuits

durring the installation.

- Do not install the interface near any major components or near the

HVAC system. This may cause damage or overheating to the vehicle.

- Do not disconnect the airbag connection behind the radio panel.

PRELIMINARY:

Please read the entire mannual before installing this interface.

Vehicle must be equipped with factory DVD changer.

This interface does not activate DVD reader.

INSTALLATION OVERVIEW

TROUBLE SHOOTING

1. No video display while driving.

- Make sure the dip swithces are in the proper location.

Rev. 111413

INSTALLING THE INTERFACE:

1. Remove the factory radio to gain access to the factory connectors.

2. Remove the 22-Pin connector from behind the radio.

2. Make the T-Harness connections behind the factory radio.

(if the connectors do not match please contact tech support)

4. Set the sip switches to permanently activate the VIM feature.

5. Test the Navigation address input while the car is in-motion to verify

the VIM is active.

As an option we have provided a 12v output wire from our inter-

face, as the vehicle does not provide 12v Acc. Do not use if not

needed.

Dip 1: Activates the Video In-Motion feature. The dip switch

is the permanent solution for keeping the VIM unlocked.

Use the Green wire with a toggle switch for a non-permanent

solution. (Switch not included)

Dip 2: If factory back-up camera is present turn to ON, otherwise OFF.

Dip 5 & 6: Varies, these switches are defaulted both to OFF.

If the radio is having turn-on issues please try the following:

Attempt One: Set both 5 & 6 to the ON position.

Attempt Two: Set 5 to On and 6 to OFF.

Attempt Three: Set 5 to OFF and 6 to ON.

If none of the above solutions work out for your vehicle please

contact tech support.

SETTING THE DIP SWITCHES

CONNECTIONS ARE DONE

BEHIND THE RADIO.

NOT THE DISPLAY

COMPATIBLE RADIO:

8.4” U-CONNECT RADIO/ 2-PIECE RADIO

Produkt Specifikationer

Mærke:	CRUX
Kategori:	Ikke kategoriseret
Model:	VIMCF-93E

Har du brug for hjælp?

Hvis du har brug for hjælp til CRUX VIMCF-93E stil et spørgsmål nedenfor, og andre brugere vil svare dig

Dit navn*

Din email*

Skriv dit spørgsmål her

Ikke kategoriseret CRUX Manualer

CRUX VIMMB-85N Manual

10 Juli 2025

CRUX VIMPR-90P Manual

10 Juli 2025

CRUX VIMCF-93C Manual

10 Marts 2025

CRUX VIMFD-95F Manual

10 Marts 2025

10 Marts 2025

10 Marts 2025

10 Marts 2025

10 Marts 2025

10 Marts 2025

CRUX VIMMB-85P Manual

10 Marts 2025

Ikke kategoriseret Manualer

Nyeste Ikke kategoriseret Manualer

Panasonic PalmCam PV-SD5000 Manual

10 Juli 2025

Voigtländer Bessamatic Manual

10 Juli 2025

Leviton D6701 Manual

10 Juli 2025

Microchip USB7216C Manual

10 Juli 2025

Parkside PKHAP 20-Li C3 Manual

10 Juli 2025

Merging Anubis Pro SPS Manual

10 Juli 2025

Hazet 1987N-4 Manual

10 Juli 2025

Microchip MCP48FVB04 Manual

10 Juli 2025

Octavio STREAM Manual

10 Juli 2025

Voigtländer Vito C Manual

10 Juli 2025